pretty normal "older"v6 timing belt job. i love how on a v6 the cams usually sit in place by them selves just dont move them very far from aligned lol! . i like to lock them in place some how....a wrench and a few vice grips to hold said wrench, using a hole and pin/bolt.... and ya... keep the slack on the tensioner side.... learned that the hard way (rotated the engine by hand like 4 turns and ended up 1 tooth off on the 1 cam) . low comp motor, so didnt hurt anything (even on high comp, usually gotta be 3 or 4 teeth off)

Instead of adding music talk step by step fucking would help

What if you can’t get it to go in new?

Do you know if this is same on a Mazda2?

Nice job! It's a good idea to mark the steering wheel to the shaft position because it is extremely difficult to find the correct position if it is not marked. I noticed that you dd not tell when to remove the yellow lock.

Where was the module located? Was it underneath the vehicle or in the trunk?

What state and city?

was hoping to see how you changed out that #1 plug. My hands are just too darn big to get access. There has to be a trick.

Great video... 👍 Did you purge the gas first?

You stopped when you said the part gonna be tricky to get out that’s where I’m stumped at. That’s where everybody gets stumped at terrible video.

job done8

Camry very simple

What a pain

After watching your video, I had full confidence in replacing (and did) alone. Thank you for your video I used it as a step by step, it worked just as you did it. Thank you again.

One of the dumbest and most unnecessary videos I've seen 😂

What is the trick to disconnecting the sensor from the handle? In the video (i.e. 3:28 in the video) it was already disconnected. Great video! Thanks for making it.

Are you kidding me,,, you didn't show the bolt removal

Kip moore

Music on a tutorial is crazy

What

I punctured a whole in my gas tank.. hear to See i don't know if I can do it bye myself.. wonder what they gone charge to swap tank.

Once replaced do u have to relearn or calibrate it?

Thank you

Excellent video. I just had my water pump and thermostat and belt done. Cost a about $1200. I can see now why it cost so much. I used to do water pumps in the old days when they were a lot easier. No way I would even attempt this on my 08 Avalon.

so you do not have to drop the gas tank?

are these a common failure?

Nice video. I just made one a while ago about the same thing, although I don’t have access to a lift yet lol. These cars are great

worked perfectly. Thanks!

Thank you

Trying this on Wednesday. I’m just concerned about supporting the engine

Thanks 👍 my light disappear

I absolutely hated the music.... so much trade knowledge that could have been shared but NO!!!! We get to hear repetitive pounding crap music. I appreciate the video but leave the cool to Fonzi.

Good job bro I'm from 🇵🇰

My 2013 Kia forte Koup turn on when I inject the keys but it won’t crank or turn over it makes a low beep/click. Does that mean my starter bad or fule or o2 sensor? 🤔

hello... great job: easy to follow your step by step explanations and procedures..etc.

Thank you. I haven’t seen anybody show to disconnect the fuel pump fuse and wear glasses.. Quick into the point

What size nut and bolt for the top side? I just noticed I have one missing and I’m thinking that’s why my engine light is on

Your not video taping well!!

The photography was very bad

This was a really bad video. Bad camera work

Thank you very much for sharing bro

How many miles before change?

I recently came across your KZbin channel and was impressed by the quality of your content. Your videos need to be well search engine optimized (SEO) for organic traffic and engagement. However, after conducting a comprehensive analysis, I noticed there is room for improvement for your KZbin channel for getting more visitors and subscribers So I think you just need to customize your channel and videos, and you especially need SEO and video promotion services. So, what do you think about your channel issues? Or, what is your opinion? Or are you agree with me?

I recently came across your KZbin channel and was impressed by the quality of your content. Your videos need to be well search engine optimized (SEO) for organic traffic and engagement. However, after conducting a comprehensive analysis, I noticed there is room for improvement for your KZbin channel for getting more visitors and subscribers So I think you just need to customize your channel and videos, and you especially need SEO and video promotion services. So, what do you think about your channel issues? Or, what is your opinion? Or are you agree with me?

This is the worst how-to video I've ever seen no instruction no saying this is this and that is that and this is what we're doing here and that's what we're doing there it's just music and watching his head flop around it would have been better just to give an instructional video with no music and step by step on what your doing what you do and explain what you're doing, simple as that, waste of time for a how to video

Nice and straight to the point!

It just blows my mind how so many people clutter up youtube with these worthless videos. This one quickly turns into a bad uninformative music video. Please don't upload anymore, my time is valuable to me.

This is a very helpful video for all new mechanics, and your content is very unique, but your video views are very poor compared to your competitors. What do you think, or what is your opinion?

GOOD AND UNIQUE CONTENT

Hiii, I'm your new subscriber. I'm watch your all videos