I can't tell where yellow/red wire is hooked to and the black wire. If solenoid is 48 volt do you put 48 volts to small terminals to check continuity on big terminals? Thank you!
@EverettStewart-cx6rn6 ай бұрын
my ezgo golf cart just clicks
@2daybmine7 ай бұрын
ANOTHER BAD VIDEO didn't show what the altermeter was doing
@alilruthlessify7 ай бұрын
Anyone have any insight into the error code f040090?? Im trouble shooting these carts for the first time. Voltage on batteries is good charger is good. Idk where to go from here
@BjorgenEatinger Жыл бұрын
How exactly do you "energize" the solenoid. You missed explaining that.
@ericmontanez7276 Жыл бұрын
Sheesh!! About time a easy video to test a solenoid
@GulabKhan-tp3qy Жыл бұрын
Good evening sir
@lh98 Жыл бұрын
You don’t state what voltage you are energizing the solenoid with. I see 2 wires going to the small posts but no idea what you’re sourcing them to?
@juliabaldwin6782 жыл бұрын
Cushman gas golf cart won’t run
@gaylasweetser70112 жыл бұрын
If there's no clicking sound or any noise at all ..? Could it be solenoid?
@heidis87132 жыл бұрын
Why would you perform a test out of view, and not even explain what it was, in an instructional video?
@douglaskay99593 жыл бұрын
It is not a solenoid but a relay which is a switch energised by a coil so even if the coil is good the contacts could be bad. Sometimes relays stick closed.
@user-sv9sf1ns7g3 жыл бұрын
Guys if u plow more than 10 times a year at 12 plus hours each time change it annually w fluid in fall and save the old 1
@1cleandude3 жыл бұрын
To perform these test does the solenoid need to be unwired and separated from the starter? Thanks My solenoid clicks when keyed but high amperage only to one side and no start!! Anyone??
@edyacheraii4279 Жыл бұрын
You can try gently tapping on the starter I’ve tested starters off of the vehicle as well using a set of jumper cables first use your ground cable and clamp it onto one of the ears on starter using a small jumper wire clamp it to your solenoid (small connection to post on solenoid) then clamp the large post with the positive jumper cable end I also use the vehicle battery for the power supply for testing using the other end of your vehicle jumper cables clamp the ground side of the battery with the ground jumper cable at this point either have an assistant hold starter motor or put in a vice double check connections then tap positive side of the battery with positive end of jumper cable. If it (bendix) kicks out but the bendix doesn’t spin it’s the starter motor
@1cleandude Жыл бұрын
Thanks 🙏
@TECHNICUSChannel3 жыл бұрын
How solenoid function and look inside? I dismantling this stuff here: kzbin.info/www/bejne/rX65hWBjjbWmo7c
@DarrellDrinkwine3 жыл бұрын
your using the Diode setting on the meter.....
@ROVITTv3 жыл бұрын
Nice
@otisplunk25994 жыл бұрын
Unloaded test on the high current side does not mean it can carry a load. Just proves the control side works.
@gabrielmarquezsevilla40374 жыл бұрын
No se vale estamos en mexico por lo tanto estos documentales deben ser en español
@fritzj68034 жыл бұрын
You forgot to check for resistance. Having continuity doesn't necessarily mean it's a good solenoid.
@mrhoya144 жыл бұрын
So if using ohms to test the small ones it should read 0. What if it reads a number?
@MILO201214 жыл бұрын
Awsome video can u take a battery isolator apart
@philf41634 жыл бұрын
what would cause this to melt ? i was using my plow and this solenoid melted it is a tower type solenoid . do i have a short and if soo how to i find it and where do i start >
@wuvgl5 жыл бұрын
U didnt sho the power applied on the small terminals to activate bridge the big terminals
@breeze7875 жыл бұрын
For a training program you failed to mention how you're energizing the solenoid. What did you use?
@ghi13864 күн бұрын
Plug it into a wall outlet
@andrewsmith9415 жыл бұрын
I have 12 voltts until I try to start the motor and then I only have 9 volts at the starter
@stevenolsen63606 жыл бұрын
will a smear of graphite powder on the trust plate , help to stop pitting or frying-sticking etc, or is graphite a big no no
@doknosee70536 жыл бұрын
3minutes to tell everyone to just BUY a new one.
@eviljesus54114 жыл бұрын
a year old comment that's too dumb to ignore lol, if u have 4 solenoids in a winch, should u just replace them all instead of taking 2 minutes to check which one it is??
@jacquestocks58366 жыл бұрын
How do you test a solenoid with only 3 terminals
@sherrybarr86606 жыл бұрын
It was great to meet you today. We enjoyed hearing about your findings and look forward to seeing more videos.
@j-docksportfishing31266 жыл бұрын
Great job Mabel!! Keep the video's coming! Love Aunt Diane :)
@amccar277 жыл бұрын
Need to be checking with ohms (resistance) you're coil can show continuity and still be bad
@bradhill58227 жыл бұрын
Sorry Sean--have to give a thumbs down. You failed to explain or show how you "energized" solenoid
@tounchyhernandez48447 жыл бұрын
Not a solenoid its a starter relay
@priyanshsharma4807 жыл бұрын
what amperage current should be paased through the solenoid?
@aaronabend27747 жыл бұрын
Clear, concise - well done and thanks!
@roymiller4477 жыл бұрын
I have a 2007 EZ Go electric golf cart. I purchased new batteries last year with a service. This year, the cart starting jumping when put in F and R. Now, the cart won't move and the solenoid just clicks loudly in both F or R when I press the accelerator. Is the the solenoid? Something else? I don't want to have to load the cart and take to dealer. ???
@kw.98437 жыл бұрын
Roy Miller did you figure out what was wrong with your Cart mine is doing the exact same thing
@adalmadera256 жыл бұрын
Roy Miller maybe the accelerator switch. Normally electric golf carts have a throttle sensor that sends Signal to a module that then sends Signal to the motor. Ours normally does it after it gets wet, soaked, or high humidity under the cart.
@rubendominguez11737 жыл бұрын
I have an electric golf cart. when I push the gas it wants to go but it seems like it has resistance the rear engine shakes
@TonyGerace258 жыл бұрын
maybe you can help me. I replaced 6 batteries in my ez go 36 v cart. It will go sometimes if it is going and I let off on the acceleration it stops any idea what this can be?
@GDTractor8 жыл бұрын
Thanks for the video - the problem I am having is ... my 36 volt EZ-GO has forward and reverse - and the in both "directions" it goes FULL SPEED ! there is no progressive acceleration. any idea what that might be? thanks much !
@adalmadera256 жыл бұрын
GD Tractor your throttle input.
@darrickdykstra55795 жыл бұрын
Our yamaha golf cart is doing the same thing it goes full throttle when i just touch the pedal its all 36 volts. Did you get yours figured out? Please respond.
@ahmadkarout67808 жыл бұрын
very poor description for example why did you not explain the type of power you used to charge the solenoid and for terminals what if both working but one side not passing good charge ut still beeps and last back up the camera to see more connections ,eans zoom in and out
@bradhill58227 жыл бұрын
Well said
@letylopez36356 жыл бұрын
Ahmad Karout 12 v
@michaelfreeman26918 жыл бұрын
i own a 02 dodge caravan 3.3 V6.. it turn but won't start it makes a tinking sound like a dead battery.. my battery good alternator GOOD... I knw its not them... im lookn at my starter or solenoid... how can I tell if it's my starter or solenoid..?
@dewaynethompson88777 жыл бұрын
Michael Freeman I have a Honda gold wing 1200 86 I put a new, solenoid and it works good for about 3 days and now it just dim the lights when I hit the button but it won't crank can you please help
@zekbss8 жыл бұрын
thank you, good video and explanation
@duckprotectoralex44338 жыл бұрын
when I turn the key I get a tick from solenoid...and turn key and tick,,and turn key and tick,,and turn key and tick,,and turn key and tick and turn the key and car starts up....do you think it is the solenoid? or starter motor
@CuzinReem8 жыл бұрын
I ain't get continuity between s and the I terminal but somehow the truck started
@Odin31b4 жыл бұрын
Jesus!
@CuzinReem8 жыл бұрын
I ain't get continuity between s and the I terminal but somehow the truck started
@CuzinReem8 жыл бұрын
it's maybe to simple lol, I tested between both small terminals and got nothing no beep, but the truck started the next day would not start so I guess u right but if coil ain't show resistance of continuity but started the truck at least for moment
@CuzinReem8 жыл бұрын
it's maybe to simple lol, I tested between both small terminals and got nothing no beep, but the truck started the next day would not start so I guess u right but if coil ain't show resistance of continuity but started the truck at least for moment
@flagday848 жыл бұрын
Does it matter which way the current flows across a solenoid? I am installing one in an outboard motor and not sure which cables should hook up to which bolts (I know the small wires go on the small and big on big)
@marcialvasquez54618 жыл бұрын
no its not polarized
@PrendergastSean8 жыл бұрын
Scott, that is true; the best way to test it would be to energize it with a high amperage load and perform a voltage drop test across the terminals.