Life with Seven Sons

Пікірлер

@reginosantos7868 5 күн бұрын

Cuando se rompe de los costados el techo como se repara dies de fibra de vidrio

@noah97589 7 күн бұрын

Not only is the cam clapped it’s gonna more than likely need pistons the skirts love to crack on those but you neglected the oil changes and need to use diesel t6 oil or valvoline racing modern oil has no zink these are flat tappet cam motors they need a lot of zink those are only two oils the 4.0 cam safely run in 2025 even ams oil flat tappet cam oil doesn’t have enough zink for the 4.0 and no it doesn’t plug cats that’s a damn myth

@brevinbrevin9862 8 күн бұрын

Good job

@onelife2live_og454 16 күн бұрын

My heater only blows at high rpm , like when I go over 65mph , could this be this reason why?

@jaysrt21 13 күн бұрын

Same here, I even took the entire core out. Flushed it or tried too and it’s still cold. Gonna try this method tomorrow. I can’t take another night at 45 degrees.

@doctorcane. 12 күн бұрын

@@jaysrt21could be your water pump as well

@casualactivities1229 18 күн бұрын

When you did the head how was your oil pressure ? Did the bad head wipe your cam bearings cam and bearings?

@fabiocene 19 күн бұрын

So, the result of a badly installed windshield?

@landen_576 23 күн бұрын

i like this video ❤

@robch.2901 Ай бұрын

Thank you so much. My 99 xj have the same issue.

@ScottVanWagner Ай бұрын

Super informative thank you.....

@LachlanSimper Ай бұрын

Plz post the full performance again

@matterickson4168 Ай бұрын

5 seconds in I think, this guy sounds LDS. Then I see the channel is 7 sons, and I'm thinking, if this guy isn't LDS, he should be. Check the other videos: YM camp. Yup. Great XJ video, and keep up the good work!

@LifeWithSevenSons Ай бұрын

Haha too obvious. Born and raised. Thanks for watching!

@pavelh.7636 2 ай бұрын

Thank you for review 👍

@danielmeraz1628 2 ай бұрын

What are the symptoms with having a leak in the elbows?

@bradyb5487 2 ай бұрын

Only thing worse than a star bolt is an allen bolt!

@bradyb5487 2 ай бұрын

“Go!…slow slow” 😂 love it!

@LifeWithSevenSons 2 ай бұрын

Haha you know how it goes, Brady!

@johnofferman5814 2 ай бұрын

Rear control arm bushing a shot too

@LifeWithSevenSons 2 ай бұрын

How can you tell?

@dilmaster3 2 ай бұрын

Love that you cut out the curse words🤣

@cwilks5592 2 ай бұрын

Carquest premium. Good choice.

@LifeWithSevenSons 2 ай бұрын

Not sure if this is sarcastic or not, but we’re just keeping this car alive!

@cwilks5592 2 ай бұрын

@ No sarcasm at all. Carquest premium parts are great quality. They work hard to improve on OEM. They also partner with leading companies such as their heavy duty oil filters are made by Baldwin. I’m all for fixing what you have. I’ve got an 03 Tahoe with 200k miles. Simple maintenance will keep it on the road for many more years.

@LifeWithSevenSons 2 ай бұрын

@@cwilks5592awesome. Thank you for that info!

@davidcampbell8489 2 ай бұрын

Did u know to Check the hub bearings which the outboard of axel rides inside 🥸

@LifeWithSevenSons 2 ай бұрын

I did not! The CV axle was obviously shot so we just replaced it and she drives smooth now.

@ryanjamesdrake 2 ай бұрын

Alignment

@LifeWithSevenSons 2 ай бұрын

On the list!

@twillison8824 2 ай бұрын

Please don't let weight hang on your brake line and sensor wire. It could cause issues. Otherwise 👍

@jasonchristopher2977 2 ай бұрын

Yes but we all do it and done it for eons. It's not good. HF or Wally Mart sells small bungees. Like 6 inches, I mean nice sized😂 that work very well to hold them.

@LifeWithSevenSons 2 ай бұрын

Thanks for the tip!

@WeezyZzZ 2 ай бұрын

Definitely no good

@kzspeed1288 3 ай бұрын

Put a smaller rear spocket and large clutch driver in it. This will allow you have the same gear ratio, but more clearance on the rear sprocket.

@grantbarton8667 3 ай бұрын

Did this fix hold? My son had the same thing happen.

@LifeWithSevenSons 3 ай бұрын

Yep still holding for now!

@panchampatel1 3 ай бұрын

My heater is not blowing hot air. Is the t h e same location where heater tees are located?

@ibrajuhani6572 3 ай бұрын

Thanks alot.

@ibrajuhani6572 3 ай бұрын

Great job… Even me i did not make it well! But it’s good.

@mikegriego3671 3 ай бұрын

Thanks. That's exactly what my XJ needs. 👍

@iinglis89 3 ай бұрын

Bahahahahahahahahaha "and he's off.....whether he wants to be or not"

@chrisespinoza2554 3 ай бұрын

Na it don’t look fix bike. Took of as soon as u turn it on

@bikerworld4712 3 ай бұрын

What's the size for the clear hose used ID

@FuhRunna 4 ай бұрын

What size was your hose?

@danielescamillajr3598 Ай бұрын

Everything I keep searching 5/8

@queenlewis9610 4 ай бұрын

Thank you so much for this! Will be following, I inherited a lot of great tools from my father and I own a home that all these tools could help with projects and up keep…so I am researching how these tools are used.

@oo01le 4 ай бұрын

I have the exact vehicle year and colour. Just developed the same leak. Thank you for the detailed video. 👍 I’ll head to a good glass repair shop instead of pulling it all apart. Phew 😅 FYI my drip was coming from the dash where you pull the hood and gas release

@LifeWithSevenSons 4 ай бұрын

Glad to hear you found the source!

@mike1968442 5 ай бұрын

I need to know how to get that piece OUT of my jeep first.

@PatoLoco1833 5 ай бұрын

Thank you!

@Zraupp10 5 ай бұрын

Do you still have link to this product???

@brianarnold7357 5 ай бұрын

Nice work!!! Way over my skill level!!!

@collinpackham4224 5 ай бұрын

🔥🔥🔥🔥

@yallRweirdAF 5 ай бұрын

I had the perfect xj a few years ago. Totaled on the highway when someone lost a tire and pitted me. Hopefully it made a good parts car for someone

@LifeWithSevenSons 5 ай бұрын

Ah that's a bummer. Did you get a replacement?!!

@trojanyacht2518 5 ай бұрын

Great job! Respect for passing on skills to your son! The best time spent is the ones he'll remember after youre gone. A true hero father!

@LifeWithSevenSons 5 ай бұрын

Thank you! He and I are learning a ton together. I wish I would have got into this when I was a teenager!

@aflykidfrombrooklyn 5 ай бұрын

Appreciate the video thank you! What model XJ do you have? I only asked because my xj does not have 3 vacuumboards. I have a 2000 Jeep Cherokee XJ sport.

@LifeWithSevenSons 5 ай бұрын

@@aflykidfrombrooklyn mine is 2000 XJ sport 4wd with 4.0 engine

@aflykidfrombrooklyn 5 ай бұрын

Mine is as well and I’m not entirely sure why I only have one vacuum line going into my manifold. It’s so weird. Have you ever had a P1494 code?

@LifeWithSevenSons 5 ай бұрын

@@aflykidfrombrooklyn nope mostly just cylinder misfires which we’ve hopefully finally addressed (for now)