Parker Ionics

Пікірлер

@BumblebeCamaro 4 ай бұрын

Can you make a video of common recipes that are used??

@heidikeranova3251 8 ай бұрын

You are great Teacher

@jasonstatement3553 Жыл бұрын

Great work! I found you because Overnight dropped your name is one of his songs.

@maurohernandez9390 Жыл бұрын

Por mucho tiempo usamos esas makinas en mi trabajo gracias

@tp7672 Жыл бұрын

You guys should do a video on your GX7500S series! It would be very helpful.

@heidikeranova3251 2 жыл бұрын

I love your videos 🙏 thanks

@redlinewanted 2 жыл бұрын

Nice job 👌 🤗

@nickpatrick7021 2 жыл бұрын

Thank you for this run-down. I'm getting into manufacturing recruiting and I've got about six different manufacturing positions that I'm going to have to talk about about often and intelligently with clients and candidates - including powder coating.

@eckoscode 2 жыл бұрын

Stfu we powder coat parts that size using 1 gun each hand in a matter of seconds , I came here for the settings to make myself faster . Quality before quantity we make both .

@marinmarinov6922 2 жыл бұрын

Thanks for all the information provided I'm automotive paint sprayer, but interested in powder coating and that gave me a very good introduction.

@whitespeed100 2 жыл бұрын

nice info ! thanks ...

@charlesherrera3782 3 жыл бұрын

Can you guys please continue to upload these types of videos? The more knowledge we have the better your customers are. Also, it would be nice to know what each component does, just for future videos.

@Clifford270 3 жыл бұрын

Excellent instructions. Thank you

@simonac688. 3 жыл бұрын

Great tutorial Sir: question : can you use outside if no wind ? 👍

@woodswoods4921 3 жыл бұрын

I don't think so just for environmental protection purpose in anywhere! Just a simple spray booth~~~

@josellano82 3 жыл бұрын

John, Great video and of course great equipment. What would a good air flow in a booth? Thanks

@johnbracamontes4257 4 жыл бұрын

What were the settings on the unit?

@parkerionics2054 4 жыл бұрын

Hello John, The settings was on Super Pulse Power mode in (F) mode which tackles Faraday Cage Areas. Check out this video below for more information on the different settings. Hope this help! kzbin.info/www/bejne/rIm5aJqCjKyKe9E

@Herthan 4 жыл бұрын

2:45 The corners where the sheet metal is broke at a 90 both have Faraday spots. Would have liked to see that covered more than the long corners. Not being cynical, just honest. I usually have to "shove" the powder in a quick motion while releasing the trigger to try to basically throw it into the spots without a charge.

@parkerionics2054 4 жыл бұрын

Thank you for the suggestion, We will work on more content and hopefully powder coat more/ different Faraday cage areas.

@jordonconway7037 2 ай бұрын

I've noticed with the harder to reach places like tight corners and angles, if you spray slowly in a circular motion around the part from all angles, top bottom left right up down, the powder will stick from the back as you spray around the part