still waiting for it

Me too.

Ahh my bad, I hope the video was still useful and helped with your car

I reckon you can drive this car without the propshaft, Its a old enough vehicle what it's not constantly covered in sensors and electronics that would freak out when something in missing, and loads of land rover and Range rover drivers I know take it out from time to time to save fuel so I'd say yes you can

They've moved over to a different channel, they are on WelshNorris0703 😁

Haha maayyybbeee 😅🤣

@@CrossfireStudios ayee there's a capri in there

Of course, new videos of any builds like daleks will be on the new channel

@@CrossfireStudioswhat channel?

@@valentinomurray9967 The channel is WelshNorris0703

For a first time starting out RC car to go to I'd say FTX is your best bet

Absolutely 💯

If I remember correctly, I had to find a socket and extension that was thin enough to get in the gap, it's been a while now since so my memory is a bet meehhh. If not that then maybe from a different angle

Yes sorry for the delay, I've been caught up with setting up the second channel and work. I'll get a video out as soon as I can 😊

Ahh okay, for the 1.6 tdci they might of moved the location of the Thermostat because its a different engine set up, I.e different head (8 Valve or 16 Valve)

@@CrossfireStudios Hey, it was located the same as this video. Thanks! It was the car of my sister in law. Man what a sh.tty car. I never loved fords. But this one takes the cake. I started working on it at 8 in the morning. And around afternoon i was done. But then i had engine fault code. And the turbo wasn't working anymore and the car won't start at first. When i switched the key to the ignition position, i got a short circuit somewhere. So i dissambled almost everything again. Sanded the negative cable for a good GND. And then it was starting luckily. No fuses where burnt. I have no Delphi scantool on my laptop. So i called a garage owner what was open on sunday. He scanned the car for me. And after some searching he found that there was a cable on the turbo not plugged -_- I still feel my back hurt from all that stupid work. I said to my sister in law, just buy a volkswagen polo for that money. Not complicated to work on. And i have vagcom on my laptop, wich makes it a lot easier to work on. I always work on my own audi a6 and my wifes Golf mk7 tdi. Never had been this kind of weird issues working on it myself. freakin ford that cracks and makes all noises like a old women. For a car from 2010. It only has 125 000km. But feels like half a milion.