YJ Square lights

Пікірлер

@Black_Flag_e-Motorsports 5 күн бұрын

I am building up a stock 1988 and want to keep things as stock as possible. Do you know if there are Chromoly replacements for the stock split axles?

@josephwaddy5999 4 ай бұрын

You say old school stuff, but this is a great visual of the CAD interior and is very helpful for my 94' YJ too. Thank you for passing down some knowledge.

@Here2HelpYoutube 7 ай бұрын

Thanks for the video. What does the wire loom and plug do that are sticking out of the actuator? You pick it up at 2:50 into the video

@azimaslam6375 2 жыл бұрын

My yj 2.5 ltr has 33s This winter i put it in 4 wheel drive on a hill and the front tires were not spinning . Only rear was . Than i put it on 2 L still nothing .so embarrasing . Can anyone help me why the front wont move . Seems like 4x4 does engages and gets me out of parking lot and when lots of snow on ground but struggles on hills . Is it the big tires ? But in snow it should be easier to spin i guess. My jeep even has lockers There is a red dial up knob incab . I bought the jeep like this all modified

@ArrowItArchery Жыл бұрын

The red knob is not a dial up. It's a pull knob that's cable driven to the shift fork. When you engage your 4wd on the floor, you pull the red knob outwards. It's a manual cable that moves the shift fork to lock the two axles together. The vacuum lines are void. If you trace the black line from the red knob, you'll see that it runs to the shift fork housing cover. It runs into the housing and is connected to the shift fork internally. You will notice that, behind the red knob is possibly a black dial. When you pull the red knob outwards, you can dial the black knob clockwise to tighten up on the rod and lock it in place from working back inwards. It's much better than relying on vacuum to move the fork. Manual activation, over electrical, button, or vacuum is always my choice. If you pull on the knob and it won't move, check the black dial behind it and make sure it isn't tightened down on the shaft. Rotate it counter clockwise to free up the red button to pull. The black dial is basically to keep the red knob/shaft from working back in when it's pulled out. You may not need to use the black dial when the red button is outwards. You will figure that out after you use it. If your red button walks in when it's activated as you are four wheeling, then you'll know to just use the black dial to lock it in place. 😁

@azimaslam6375 Жыл бұрын

@@ArrowItArchery wow Man you are a pro.👏 I end up selling the jeep 😂

@colin5064 2 жыл бұрын

So did you have to change the axle shaft oil seals to fit the TJ drive shafts?

@davidadams6012 2 жыл бұрын

What year tj axle shafts will work on the yjs

@finemyu69 3 жыл бұрын

I’m trying to find a tool to replace that seal in there

@jcwoodman5285 3 жыл бұрын

We've owned our 92 Sahara YJ since 93🤗

@jimmack3620 3 жыл бұрын

Dear Sir. I need your help i removed the axle shafts on both sides of my 88 yj wrangler, bur i cant get out the intermediate shaft from the axle what can i try. jim at [email protected] please help

@zassaultt671pange5 4 жыл бұрын

If one of the vacuum lines is to turn on 4x4 light on dash then what is the harness plug for?

@e954rr2 4 жыл бұрын

Iv used this seal still leaks

@tstrenuous10 5 жыл бұрын

helpful. Thanks. I'm guessing one vacuum hose engages 4WD and the other vacuum hose pulls the motor out of 4WD and frees up the axle.

@yjsquarelights 4 жыл бұрын

It also turns the 4WD light on the dashboard.

@JustALad 5 жыл бұрын

Yes sir this was definitely a big help, no where in the haynes 84-01 xj manual was a diagram as good as this. Thank you

@yjsquarelights 4 жыл бұрын

Awesome! I'm glad this video was helpful.

@Bob_at_OZDiggzguitars 5 жыл бұрын

as a YJ owner (1993 Sahara) with a working vacuum setup, this helped me understand what I have and why my friends want me to swap in a post 1996 XJ axle.

@yjsquarelights 4 жыл бұрын

Yep, mine failed on the trail and you can't go far in 2WD.

@caitlinstudt1114 6 жыл бұрын

Thanks helped me out

@yjsquarelights 4 жыл бұрын

Glad to hear that.

@series9193 6 жыл бұрын

New JL now using something similar no vacuum, electronic

@yjsquarelights 4 жыл бұрын

I seen that. I'm guessing that will work better than the vacuum set up.

@jrodz808 7 жыл бұрын

What leaf springs and shocks do you have?

@yjsquarelights 4 жыл бұрын

4 inch Rubicon Express heavy duty kit. With a 1in body lift.

@dunlapmichaell 7 жыл бұрын

Nice, but still vote for the Jeeps every time.

@klb1956 7 жыл бұрын

I still use mine flawlessly. The shaft only engages if shifted into 4x4. So, I have found another remedy if the vacuum system failed. Taking the actuator apart you will see the "C" clips that hold the fork in place. Take the "C" clip off on the side that would slide the fork over to the side where the collar engages the shaft. Replace the "C" clip on the opposite side of the fork and this keeps the fork in the engaged position. Now you use your 4x4 shift as normal for off road.

@yjsquarelights 4 жыл бұрын

Nice! Thanks for the info.

@rausnielblanco5832 7 жыл бұрын

I would like to know if the posi locker blocks the front wheels and does the function of a locked differential or what is the purpose there?

@yjsquarelights 4 жыл бұрын

Good question. The posi lock does not lock the front differential. Only engages the passenger side axle shafts together.

@zxtuner4lyfe 7 жыл бұрын

Hey what you pay for tj shafts at pick a part? Thanks

@yjsquarelights 4 жыл бұрын

I think around $100

@bobczz3919 7 жыл бұрын

The only problem with a one piece is the differential and driveshaft will turn all the time. Not so bad if you have the 4.0L but if you have the 2.5l it robs a lot of power.

@yjsquarelights 4 жыл бұрын

Good point.

@theohatch8507 7 жыл бұрын

I still have the stock axle in my white Jeep jeep so yes this was helpful. Thank you!

@yjsquarelights 4 жыл бұрын

Your welcome, sorry it took 2 years to say so.

@kbennett87 7 жыл бұрын

Thanks for thanking the time to make this video. It was very helpful.

@fixitwithzim 7 жыл бұрын

Thanks for the info, good video

@sashanesterov 7 жыл бұрын

I'm sorry, just picking Your brain. Do I need it on both sides or just on passenger side and drivers side stays stock? Just being lazy and parasitic on Your knowledge. Thank You for a great video! Exactly what I was looking for: to get it generic part fast, instead of waiting for a mail order for a "special" kit.

@wesbrash74 6 жыл бұрын

sashanesterov Just the passenger side. Sorry I took so long to get back to you. Hope all worked out well.

@svborek 7 жыл бұрын

thank you

@hunttomuchwolfe 8 жыл бұрын

I never liked that set up in the XJ the vacuum fails just swap the Dana 30 to a solid it will be stronger

@tastethablade 8 жыл бұрын

How can I see your jeep? I only see the hood videos :(

@zyamahariderable 9 жыл бұрын

really cool watching this on 0.25 speed you can see it untwist

@Josephw615 9 жыл бұрын

you drive so slow.

@jennifergruetter4841 7 жыл бұрын

Cjw615 your supposed to be go slow while you are off-roading you will understand if you go off-road

@team_suv7778 5 жыл бұрын

Cjw615 yea man especially in a YJ with leaf spring suspension and a lift it gets pretty freakin bouncy going fast

@yjsquarelights 11 жыл бұрын

Yep, was definitely a learning experience.

@yjsquarelights 11 жыл бұрын

4" lift kit, 1" body lift, plus some body trimming.

@yjsquarelights 11 жыл бұрын

Badlands off road park

@Jfdumont1982 11 жыл бұрын

hey i would like to know ? what is your lift setup and tires size? ithats the kind of trail i do and it look pretty goods!

@TRAPBOULTERNAS 11 жыл бұрын

Where is this?

@yjsquarelights 11 жыл бұрын

My other channel "Wes Brash" has it at regular speed. Plus there more Jeep videos you might like.

@yjsquarelights 11 жыл бұрын

Just playing around with movie maker. It is up loaded at regular speed on my other channel.

@stevieG2015 11 жыл бұрын

I agree, would look a whole lot better at regular playback.

@gacountryboy86 12 жыл бұрын

Why in slow motion?

@JEEPINJUSTIN 12 жыл бұрын

floor mat on the cable next time

@tomswonderfulworld 12 жыл бұрын

WOW, Glad nobody was standing to close!

@yjsquarelights 13 жыл бұрын

@KinoFilm21 Not yet, on the list.

@yjsquarelights 13 жыл бұрын

@kaminskyjason yea, the noise can get old.

@yjsquarelights 13 жыл бұрын

@JEEPINJUSTIN1979 I've used it all over my jeep. Works good on my r/c videos too.

@yjsquarelights 13 жыл бұрын

@JEEPINJUSTIN1979 I've used it all over my jeep. Works good on my r/c videos too.

@yjsquarelights 13 жыл бұрын

@tomswonderfulworld So far so good, let you know if i break it.

@yjsquarelights 13 жыл бұрын

@JEEPINJUSTIN1979 Just picked up roll bar mount. Also have a crazy tri pod thing. Get the GoPro, good fun camera.

@JEEPINJUSTIN 13 жыл бұрын

Cool. Can't wait to get a go pro. Did you figure any other cool mount options?

@theoriginalmodz 13 жыл бұрын

tight spot at the end, i was like no way your going between the trees.

Ең жақсы KZbin

Пікірлер