@Hvacnc here in South florida , Dade ,Broward, Palm Beach , West Palm

You never know when you may run into

Man, sometimes you have to check. Can't believe it passed quality control

The float switch is there , look good 3:50 , also here in south florida the drain line goes under ground and comes up outside .

@@brian2coolful Sorry, I missed the float switch. My system in the attic has a float switch on PRIMARY condensate line directly out of the coil, then a cleanout, followed by a trap and then a second cleanout and then runs outside through attic and a exterior wall and drops about a foot above the ground. The coil's secondary line runs into a secondary pan (under the unit) which also has a float switch and the secondary condensate line from this pan runs outside to the exterior soffit. I think I'm well protected from water damage or at least I hope so. Just a regular homeowner here in Texas.

Stop lying your just the helper. Brian is really good at what he does. I know this because I hire him often.

@@victorortiz5761 Okay thats you! am jot sayind its bad ! it took alot time thats it.

Your spelling is bad lol 😂

@@victorortiz5761 yess Lol

Thanks again ,the closet was repainted and the floor also redone

I've nevee failed an inspection here doing it that way

@@brian2coolful but you're failing AHRI and the manufacturer every time! Just because you pass inspection doesn't mean it's right!

What would have you done differently?

@@brian2coolful to start with if code doesn't require a flange around the top of the unit then I probably wouldn't worry about it either..lol.. but when I join duct board together I would cut a female shiplap on the existing duct board and a male shiplap on the new piece... also your corners should not be Butt jointed but also have a shiplap... with the air handler being on the interior I know it's not really a big deal.. but I'm in Florida and a lot of air handlers are in the garages and I can't begin to tell you the ones that sweat and leak air! Anyway it's good to see guys like you in the field... I've been in HVAC for 45 years fixing to retire and it's hard to find good replacement people! Keep doing what you do.. I didn't really mean to put you down! You certainly seem like you got a brain and you care.. that goes a long way! Stay safe and may your best days to be ahead of you!

I have done both techniques. Wouldn't the mastic on the inside take care of the butt joint leaks?

good video though man looks nice

Not a common practice here in south florida , much different here

@@brian2coolful its very common in central florida its required here too but nice video man

In some cases, but specific in South florida

Non warranty OEM parts will cost for sure

Thanks

Thanks much

Appreciate it

Appreciate it