Works

Works for me. Thank you.

How did you go about tracing the state shape?

no riving knife behind the blade?? a no no annd a strip of timber glued underneath the panel to run in the groove would be a better idea also! machinist of 40 yrs!

Gloves on a table saw is a recipe for a loos of limb or life . Sorry I can’t watch folks who do stupid things Next

Love your videos Jenny 😊 one of the true good people on social media 👍best regards as always, Colin 💪😊🙏

You're THE BEST

Do you knw what mean Offline?

Thank you so much!!! Works wonders, great on card stock..💖💖💖💖💖💖Very Easy.

Thank you so much for sharing this!

too fast for me to follow. but nice end result ..

Seriously, undo with a star shaped drill bit?

This helped me greatly! Thank you! It took 3 hours, but I had to update EVERYTHING.

Brilliant

Looks very nice but as a former cabinetmaker I cringe at the lack of safety when using the table saw.

Man, no need for tape to get these clean lines. Awesome!

Yum! Looks great, Jenny! 👏🙌

Anotehr worthless video

Thank god for you sir

Excellent result! Just in case, I do not recommend that you work with a circular saw with gloves, these are safety rules prescribed in many instructions

Thank you

Thank You!!! I will try this on my next project.

Very good video, congratulations.... Is this chuck heads by Pegas good for Wen LL2156?

what type of blade are you using

Wow . Great work. where can i get a custom design of something similar.

Thank you helped alot! Was pulling my air out with various software and nothing worked correctly

Bravo, the boys down at Dewalt engineering please take note

This is a lot of work I wonder if at the time they had thumb knobs you could tighten with the adapters that wen brings with the machine , it seems like a lot of work

wats with gloves? lol

Great project. Now I have an idea for Christmas presents......

This is the first time i saw someone to put a vapor barrier outside the house. I previously thought it is for crawlspace only

I've made almsot the exact same bench design. What hardware did you use to mount to the ceiling?

This modification worked out very well. The drilled holes are closer to the edge of the piece of aluminum than the video shows. Perhaps I have mine at a higher position. I used a pan head screw for the front and I found that it allows the arm to lock in place without me touching it. Now working on a way to have the arm come down without moving the aluminum support

Thank you for sharing! I had to tear out some bushes along a foundation wall. End result left me needing to regrade and I had no clue how to do that. This video was so helpful. I wanted to come back and thank you. I did end up “painting” with DryLok patch to seal crevices and we’ve not had any issues since. Amazing how some TLC, just a day or two of effort, and a fraction of the cost in supplies saves us thousands of dollars in the end from damage (and hiring out contractors lol).

Honestly i fell asleep before i finished the video. Nice piano noise

Thanks perfect, went to DHCP mode hook to my core switch found IP right away, Telnet no user/pass easy as pie.

So yummy ❤ Did you make it with just normal dough? Or something specific?

thanks man

Thank you, thank you! Saved me $200!!!!

Hi that looks tasty 😊

First comment pls no mean comments

Why and when do we need to reset the switch

How many small pieces are needed ???

Awesome

This works perfectly well. I did the exact same setup two years ago and have not had a problem with it.

terrable to change blades way to complicated and hard to reach. i end up leaving off the side safety panel.

would have been nice to see a picture after screw was in

Absolutely brilliant, it saved me, and many others , a fortune. Thanks a lot.

❤

Simply relaxing for me, thanks for sharing