Beste Richard, ik ben erg te spreken over je videos van het maken van een archtop. Zeer concreet en voor mij zijn er alle vele vragen beantwoordt, ik was afgelopen week nog in Den Haag, wellicht ga ik binnekort nog weleens een keer surfen en kunnen we dan een keer ontmoeten. Maar alvast bedankt voor je geweldige content
@rombsix Жыл бұрын
Great work :)
@oldbuggerhunting1206 Жыл бұрын
Interesting video which intrigued me as I have a few old ones in the box. I love bone saddles and enjoy the LB6 and 12. After a bit of research LR Baggs states the piezo is cast into the brass body and the saddle is epoxy glued to the body. I heated one up and was able to easily remove the saddle and this shows a stainless steel fine micro mesh between the brass body and the saddle material. I assume this assists with the adhesion between the two parts and possible assist with providing an even pressure across the joint. This joint is what you could see during your video, which was not the piezo element. I was able to easily bond a bone saddle back onto the brass element and al is good! This may help you in the future, cheers
@raymonddegennaro30972 жыл бұрын
Absolutely Beautiful! How thick is the top?
@0ptimus2 жыл бұрын
Incredible
@rodionmmelnikov78002 жыл бұрын
Came to this channel to check how you make some fine guitar woodwork for my own amateur project and found my favorite guitarist playing your guitar.
@luigicannizzo26693 жыл бұрын
" Very Special Sounds on Arts Luthery Guitar .. Very Special Talent ". .. So' Nice ... ☺😊😀/💙💙💙/👍👌👏👋
In terms of epoxy, what did you use? I want the LB6 in my Taylor but I have found that Tusq sounds best. I am tempted to try this with a tusq saddle. I am surprised Baggs still uses Micarta as it seems to have the most impact on the unplugged tone.
@LuizRock4 жыл бұрын
Is the lb6 good enough without preamp?
@jakelondon4 ай бұрын
No. I have one. IMHO, much better with the pre-amp.
@mennoverdoorn8444 жыл бұрын
She's a real beauty indeed!
@husky27754 жыл бұрын
Wereldklasse
@JzZcAt4 жыл бұрын
Wow !
@JzZcAt4 жыл бұрын
Wow !
@fruitmatedynasty68345 жыл бұрын
I looked your vid already Mayiask that where and how did you install the lbsix with the endpin?
@RichardHeeres5 жыл бұрын
Tanks for your comment. The endpin is in the tailblock.