This looks absolutely gorgeous my friend, fantastic panorama!

ok

San Diego jam knot

How well does this work with 80 lb mono or flouro?

Terrible background to film against for this and the music has to go.

Terrible back ground, use lines that video camera can pick up and ... but good knot 🪢 thanks.

Fisherman and a techy. I see that rasperi pi in the back. My dude!

thank you for good advice!

You said sis

dumbass

*They come nice>>> **allabout.wiki/1004** and sharp out the packaging, strong, and the different sizes are perfect to match whatever you go fish for. Give it a shot you don't be disappointed.*

How did you access to the GPIO via Golang ?? Pls let us know

the ultimate back lash guide

Great video

This helped thanks😊😊👌👌

I use a broken old reel to load the spool line onto first, then transfer the line onto the final target reel but set the drag of the old reel. The new reel then pulls the line hard off the reel and you get a far more compact line lay. Also you can also use water on the braid to help get a compact line lay.

Good tutorial

This is NOT how you want to wind braid. Please don't follow this guy's instructions. You don't need tape if its done right. The key is to leave a tag end about an inch long of braid and to SLOWLY wind over that tag end at HIGH PRESSURE when you start. He is way too loose and it would cause nothing but problems later when the spool slips. Salt water will get under the tape and corrode the spool. I even put in a light coat of corrosion protectant on the spool to protect it.

I am Asian

nice video... appreciate it... but whats an elechit tape

This is the style knot I'm going to tying this summer because I'm a big fan of the improved Albright

so that blue body part is plastic?

Hello, im working on a project for my staircase at my house using some ws2812 PIXEL leds controlled by a lights equencer software for the raspberry pi, its called falcon pi player. it consists on 2 pir motion sensors HC-SR501. 1 sensor should be upstairs and the other downstairs. I need your help with a script to disable a gpio and another script to enable it again. Bottom line heres what i want to do when motion "A" is triggered it will start a playlist just like this 1- Script to disable motion "B" gpio (pin 11 GPIO 17) 2- Start sequence (After sequence ends then proceed to step 3) 3- script to enable motion "B" gpio (pin 11 GPIO 17) when motion "B" is triggered it will start a playlist just like this 1- Script to disable motion "A" gpio (pin 12 GPIO 18) 2- Start sequence (After sequence ends then proceed to step 3) 3- script to enable motion "A" gpio (pin 12 GPIO 18) Any help will be appreciated. Thanks!

I wonder how easy it is to open up. I might have a spare brass thread I can use.

good tutorial

What's the knot called

I live in an old sandstone house. My laptop is in the basement at the back of the house and my router is upstairs. I could only get a very weak WiFi signal in the basement and powerline has been the answer. I am not technically minded but I had my adapters out of the box and working in a matter of minutes. No software or complicated configuration is required - it is literally plug and play and the adapters “find” one another quickly. If you want to create a fully secure network you can press the encryption buttons. I have personally not bothered as no one else has access to my house electricity. I now have a reliable broadband connection for my laptop thanks to powerline.

Asian fool

my camera also stripped the mount, did this replacement affect the waterproofing or the WiFi plug inside the camera?