Пікірлер
@TheNagaguy Ай бұрын
Is this the same procedure for a 2005 Korando
@TheNagaguy Ай бұрын
Its a pretty good video and quite explanatory. I found it a bit annoying that he camera at times was not showing what you were actually doing, nor did I see you actually putting back the new brake shoes. but thanks anyway, I enjoyed the video it was very helpful. I hope that my supposition is correct and that this is virtually the same on the 2005 Korando
@GarageAddict91 Ай бұрын
Thanks for the tips I'll improve in the future. To be honest I don't know if they are the same.
@objectiveartefacts 3 ай бұрын
When this is exactly what you need to know about your Musso park break assembly.. you just became my favourite KZbin channel :) thanks. And just a question.. if I wanted to increase the distance of the spread of the existing break shoe.. can I adjust the expander mechanism at the bottom by taking off the shoe and turning the left side with a grip on it?
@GarageAddict91 2 ай бұрын
Thank you . If you just want to adjust it no need to take the shoe off
@NewG3nGaminG69 6 ай бұрын
I have 2013 Ford Galaxy 2.0 TDCI,My enginge started to shaking after i push the clutch pedal seems its gone.Do you think its a flywheel or else?
@GarageAddict91 3 ай бұрын
Is there any noise coming from gearbox area ? If not I would do diagnostic scan and check engine mounts for play.
@knut5397 6 ай бұрын
I will soon start doing the exact same job. I think my flywheel is bad. It started making noise when the clutch pedal was released. When I pressed the clutch pedal down, the noise disappeared. After a week, I started experiencing a lot of vibrations when driving - so much that I don't feel safe driving the car. Do you remember how long it took to finish the job? Is there anything special I need to be aware of?
@GarageAddict91 6 ай бұрын
Hello it took me around 5-6 h to complete the job once the subframe is off makes the job easier.
@95ops 7 ай бұрын
This is 5 or 6 speed gearbox?
@GarageAddict91 6 ай бұрын
Sorry I don't remember
@lostgroovemusic8494 10 ай бұрын
Did you change the flywheel
@GarageAddict91 9 ай бұрын
Yes I did it was very noisy
@stevehodgson3436 Жыл бұрын
Load of crap why even put it up you’ve explained anything
@Darm.photography 2 жыл бұрын
Can you just change the slave cylinder on its own thats whats gone on mine pissing out will do the rest eventually but for cost wise I can do slave myself
@GarageAddict91 9 ай бұрын
Yes you can if it bad if not it's waste of money
@dragzgaming 3 жыл бұрын
i have the 1.9 tdi and replaced master cylinder. clutch still keeps going limp (pedal spring pulls pedal to the floor/ no pressure) and have to bleed again 3times now. last time it happened i had a grinding rubbing type sound from under the bonnet ... you recon its the slave cylinder? or could it be something more sinister... edit. no oil leaks and fluid level doesn't budge unless bleeding.
@seanconnelly2832 3 жыл бұрын
Do you need to remove the subframe for getting gear box out
@GarageAddict91 3 жыл бұрын
Yes you have to take it out