2012 kia

I just got a peterbilt 379, old vut im gonna post fixing it up

What’s the part number

Were u able to just move the back fowed and cut off the back

very good explanation! Thanks😀

Probably a little late now but night want to make a weight you can grab and carry with the bucket if you're going to be doing a lot of blade work. It'll give you more down pressure on the blade.

😎👏👏👏👏

What happened in the morning after pump installation?

Hey question so I fixed the purge value and also the fuel pressure sensor but I still get hit with the same code. Any information or suggestions or what it might be thank you

can you send me the link to buy it please ?

Wondering if this is causing my P0456 on my 2016 Kia soul. Was it for a ‘very small evap leak?’

Allo there ! Thank you for this video just did you fix it defenitely repair it up time ? Thank you

p0455

💪💪💪👍👍👍

💪💪💪👍👍👍

💪💪💪👍👍👍

💪💪💪👍👍👍

💪💪💪👍👍👍

💪💪💪👍👍👍

💪💪💪👍👍👍

The battery in the key could be dead.

Cuánto cuesta tu camión

Its one of the fuses under the hood. Row closest to the right if your facing the cab from outside and fuse closest to the cab

What is the name for this sensor

Very helpful.... Mine used to start on the fifth crank... now long crank to start then fine.... Might only be the check valve out of the ECM cooling plate, but I'm thinking of replacing the whole fuel pump, check valve and new fuel lines to get a thorough fix

Do you think an aftermarket fuelpump can throw that code on a kia soul? since the fuel tank pressure sensor is aftermarket as well and maybe the computer doesn't like the aftermarket part?

I have the same issues with my Ford tourneo connect… started few month ago but lately was getting worse nd tomorrow early in the morning i have appointpent to the car service for another issue nd now guess what… the malfunction anti theft car system does nt allow me to start the engine… i hope tomorrow in the morning it will start.

disconnect starter wire plug by the battery and go direct to battery positive and see if it cranks if it does could be shifter mechanism by the transmission , this happened to me almost got stranded on the road so after a while of fucking with it i went to that wire and started the van then at home i put a push buttom no more problems gut it will start in drive so be careful

Lovely

I went to the local Kia dealer and they told me that they did not make 2013 Kia Soul anymore so I couldn't get any parts for my car. I spent $500 on a scanner at AutoZone and the only light on the dash was for low washer fluid so my ex-girlfriend had her friends slash three of my tires. The guy at the tire store said that the tires were on sale and I could buy 3 and get the fourth one free but when I told him I only needed three he yelled at me and so now I have to walk to work until I can buy a new car.

All freightshakers leak there

You're a life saver I was about to buy hole fuel pump

How do you removed the seat?

Was your floor getting water under it aswell?

I have a 2014 Kia soul manual and I have the same code, would you happen to know if the same valve would be in the exact same place?

Cochino!!!

Would love a video of greasing the house bearing. Just got one and it's all new for me. And if you ever put the password to start it is love to see that. Manuals suck! Thanks for the video!

What kind of gloves are you using to work on the pump?

Great looking freightliner the fld was the best freightliner ever built congratulations

Goo gone

Any new update on your freightliner

So what did you do with the pats system? Im trying to swap my pcm but it wont start because of anti theft issue

WHERES PART 5!!!!!

Yaaaaa sabeeees DOMÍNGUEZ TE LO DICE ❤️🤣

Good job buddy 👍👍👍

Where did you get the pump from and how much $$?

You can use the fiberglass filler on that hood and it'll help with all the deep scratches and stuff and for the whole you need to sand the area around and then feather it out and get some fiberglass mat make sure you wear rubber gloves and the mask and use fiberglass and resin to fill the hole make it into layers like do you layer of fiberglass and resin and then do a layer of resin and then fiberglass and then after you get that done then put a top coat of fiberglass filler

2009 E350 superduty van v10 weird start problems also Ford can not figure it out. On 2nd pcm problems still, vehicle is useless got stranded for 3 hours recently only 34k on van.

Good

Nice one sir..