Excellent

thanks a bunch for this video

Thank you very much for uploading this video

@13:56 - you just created a route-rule to allows traffic from FIN to Mkt. 1. So, can that same rule allows traffic from Mkt to FIN ???? 2. Or do you have to create a new route-rule to allows Mkt to FIN ????

Please make videos on Link aggrigate and BGP setup.

Create video for all' security profile please

Great sir but if subnet not directly connected in that case need to add router?

Nice explanation

Rakshit bhai how can I go for your more videos

can I get your slide

Pls make more videos

Does your perform this tutorial on your real device or simulator?

Thank you very much for a fantastic presentation - nothing short of awesome.

IPsec tunnel down debug showing dpd down but when when ping continue from peer site and manualy up tunnel some tunnel up I need solution for this

how to check logs for interesting traffic ? while packet capture we can only see gateway IP logs

The firewall policy that wasn't working at 44:10 before you changed the firewall mode didn't have an action configured. The rule you created after changing the firewall mode did have an action of permit.

Why port3 has an IP? do you use that as a management?

Truly amazing and informative lecture Sir. Many things I have learnt from this session which will improve my skills for future endeavours. A Great thanks to you for the support.🙏🙏🙏

Rakshit please post videos regularly

Hey man, that was a really awesome video. Well explained, I can tell you have a lot of knowledge and you helped me understand how to create a policy in Fortigate. Thank you!

Thanks, btw where I can download fortinet trial version to run in my Eve ng console? please advise

Thanks for the amazing video

Thanks for your sharing, this video is really helpful for me.

which tool / materials you are using in order to draw on the screen ? thansk you

Amazing!

NICE

Good job sir!

I dont recognize that simulator whay you are using? What it is?

Good Stuff Thanks for sharing

Excellent video. Thank you very much for your time and perfect explanations. This helped me out huge.

as you say at one point cisco asa is stateless firewall is that correct??

Great . Thank you.

Hi sir, In this lecture you have configured simple policy in fw and in policy config you have mentioned services as ALL(which allows all tcp udp..etc) . but if BGP routing is configured and what if I want to allow only https service in policy . should I enable both tcp port 179(Bgp) , 443(https)?

Awesome teaching skill man. Thank you.

You've stated that Target Client is for traffic from outside to lan. When http request is coming from outside(client) to our server, shouldn't the Target be Server??

Your all tutorials are Informative 👍

@rakshit can please share your eve-ng file.

What we miss sir I don't found yet

Saving this for later. Thank you@

What is rhe procdedure in active passive setup with zero downtime.

The main goal of anti-replay is to avoid hackers injecting or making changes in packets that travel from a source to a destination. Anti-replay protocol uses a unidirectional security association in order to establish a secure connection between two nodes in the network. Once a secure connection is established, the anti-replay protocol uses packet sequence numbers to defeat replay attacks as follows: When the source sends a message, it adds a sequence number to its packet; the sequence number starts at 0 and is incremented by 1 for each subsequent packet. The destination maintains a 'sliding window' record of the sequence numbers of validated received packets; it rejects all packets which have a sequence number which is lower than the lowest in the sliding window (i.e. too old) or already appears in the sliding window (i.e. duplicates/replays). Accepted packets, once validated, update the sliding window (displacing the lowest sequence number out of the window if it was already full)

ek overlapping subnets pe bhi karde bhai

great job done

How can I join your course?