Wrong tool buddy

Hey Dude, how's it going, might be a Lil late but anyway. El mio a veces se apaga la llave y arranca y otras veces queda encendida, puede ser los fusibles?

U didn't show ur diagram

Y si no sale aire en los dos lugares al frente y atrás que es?

What area are you if I needed to bring car for your help with repair?

WHAT IS THE IGNITION FUSE?

U should chack the new feul pump befor you fix it...on out said battry...also too much ignition well burne the feuse

Did the vehicle have 32 pin or OBDII connector?

Salute!!!!!!!!!

5:40 that's the first time I've ever seen that not break.

Pretty smooth goin until the wheel bearing. I decided to change everything and it was a SOB! I had 3 hours in getting the joint nuts off, an hour getting the inner and outer separated, and around another 4 getting the bearing out. I was going to do the other side but I think I'm going to hit a bridge instead. Worst repair job I ever undertook. Best wishes and thanks for the video you guys!

El Cheeso

Massachusetts , ❤

How does it work, though?

2011 Nitro replace the engine it starts but it won't fire up

Pretty stupid video, poorly made and nit even telling what tools are needed it.

⭐️⭐️⭐️⭐️⭐️

I purchased another key from a lock smith because i lost my key. And, now i found my key and lost the purchased key now my green flashing light is on. I know it's not the spark plugs. I need to add this key back to the car. Can you please!!!!

Thanks so much for your video. My HHR had been idling rough and eventually the check engine light came on and I got the P0014 code. I took the car in for an engine flush and oil change. Then I went home and pulled the VVT control solenoids as you showed. The exhaust solenoid had a huge flake of something stuck to its side as well as some other small particles. The intake solenoid had just smaller particles on it. I cleaned them both and reinstalled. Started the car up and cleared the code with my OBDII reader. There's no more rough idle and engine power is back to normal. After about 35 miles of driving there is no new code. There's currently about 88,000 miles on the engine. Thanks again!

Didn't bend tab up on axle nut.these g guys shouldn't be working on cars

Hi is coding needed after installing the new gear shifter?

Thanks for your video. That was just about the easiest car repair I've ever done.

Perfecto gracias si era el relay ya funciono la parte trasera

Chequé los dos relay no enfría avienta puro aire caliente

Should have vacuumed up all that garbage around that seal....

Por q la segunda llave y la 3 no prenden la guagua y la primera sirve bien

This fuel in the tank sucks! Hold system 👎!)

Thanks for the walk through everything working back to normal

Some DENSO are Made In China.

Quiere decir q si no es la batería de la llave puede ser un fusible

My 2006 pilot is having the same problem. However, the fuse keeps popping when i turn the key after every replacement. Does anyone know what could cause this fuse to keep blowing?

2010 Honda Is it normal for the green flashing key to flash 5 times on shutting off car?

My daughter car it just happened when she got off work.. key 🔑 shows on dashboard. It’s a 2012 Honda civic LX PLEASE HELP WITH STEPS because we don’t have the tester and she only has 1 simple key.. with no 🔒 or 🔓 button. Was giving to her like that. She has to insert the key in the door to unlock automatic.

Great video will help me do mine. Someone in the past made my hole bigger to replace pump. What I learnt from else where was 1) to take out fuel pump fuse and try starting a few times to release pressure from fuel line and 2) use little vacuum cleaner and rag to clean area before undoing the fuel pump/ sensor bracket. So bits can’t fall into tank.

Must have been the first time working on a VW LOL 😂 great job though 👍🏼

Where can I buy or find that fuse ACG s 15 fuse?

Yo tengo un Problema con un 2011 Honda civic y no se cual fusible es

I got a ton of confidence from this video! 🤗

Don’t strive a match please

😊cool you’re the best at playing at all the games in the world

This is very helpful, thank you! Approximately how long does it take (straight time, not mechanic's billed time) to replace an alternator? I see that this video is 38 minutes long, but you edited it and perhaps trimmed the time. My car mechanic says it takes two hours to replace the alternator on my 2004 V6 Highlander.

I did that didn't work

Awesomeness

Hola bendiciones yo tengo una honda crv 2008 en qué parte viene el fusible que tengo q cambiar para quitar la llave verde?

Mikey would you F'N help him already so he can stop saying your damn name.

You dissasabled waaaay too many pieces.

A video that left many a question. So there is 3 sensors? Since now we don't know which one is which.

Was the fuel pump module bench tested? The Spec is 180ohms empty to 10 ohms Full. If the sending unit passed bench test, what is the next diagnosis with the dash cluster, assuming pins 12 and 25 on the dash cluster read the same as the terminals on the pump?

I would of done a all DTC check Maybe find something in the mobilizer.

This was the only video with 2 people. Pretty much all was covered but the install of the square box that was a complete nightmare! I tried to remove to clean but didnt take out alternator out so no room! And it had so much rust that i couldnt back the bolt out any way.😡 I saw you had a mirror my guess towards end of video you used it to get that lower 12m square wedge and bolt. I walked away for it for today tomorrow ill try again. Im pretty handy and have tools glad to see the even a skilled mechanic had trouble with minimal room to work! Toyota could have made this easier by more room and a better design- A 3 bolt 😢nightmare! You guys did great mike too!👍🏽