By All Means

Пікірлер

@oscarcamachojr4025 2 күн бұрын

Hi sir is it possible to remove center air vents without removing the radio? Thnks

@mattsd23 7 күн бұрын

Great vid. Died you figure out what cused the first one to break?

@tmscam5115 8 күн бұрын

What boost controller??

@byallmeans8270 7 күн бұрын

@@tmscam5115 Don’t have one rn waiting to setup a dyno session

@yevgeniyprotsenko9500 14 күн бұрын

Just got 2 mk4 gti 1.8l and will be watching your work. Thanks bro

@byallmeans8270 12 күн бұрын

@@yevgeniyprotsenko9500 thank you bro I appreciate that bro deff stay locked in I’ll be uploading a few more videos soon. And I just ordered a wavetrac lsdin the process of looking for another trans

@sexyboomboom 15 күн бұрын

where did you get your headers from

@strip4sleaze Ай бұрын

tuff💪🏾🫂

@samueljoseparedes3606 Ай бұрын

Thank you for the video

@byallmeans8270 Ай бұрын

No problem 💪🏿

@sonicgamerxd3412 Ай бұрын

Your video 😵🤮🤮

@curlyy_boyy_zayy915 Ай бұрын

u feel like a tourist bc you own a Taurus

@Lifesourban Ай бұрын

yeah i have to start paying more attention to the Celtics, I haven't watched a game since Rondo left

@byallmeans8270 Ай бұрын

We need one more win they lost last night

@Lifesourban Ай бұрын

Good to hear about your VW training, try to get some Zzz

@danutlavric98 Ай бұрын

What do you think about this car? Want to buy a 2024 atlas cross sport. I really like it, and i think the build quality is great compared with similar products

@byallmeans8270 Ай бұрын

I prefer the full size Atlas overall both good SVUs. I like working on them can’t go wrong with either one

@tonomejia7249 Ай бұрын

El vegano de los Jettas el mejor chulada de carro te felicito amigo

@JorgeRodriguez-ny4lm 2 ай бұрын

Nice project! What injectors are you using?

@byallmeans8270 2 ай бұрын

630cc I will upgrade to 870cc whenever I setup time for dyno session

@TonyLobo-uw6ck 2 ай бұрын

Belleza

@blancaleon752 2 ай бұрын

Como se llama o donde se consigue la herramienta que usas para desmontar el estereo ?

@quzfinest1988 2 ай бұрын

How did you disconnect the othee end of the discharge hose. I cant get to it at all.

@byallmeans8270 2 ай бұрын

I don’t really remember but you should be able to reach down in the engine bay to disconnect it. If you having trouble get a pocket flat head tap it in to break the seal. Spray silicone/wd40 when you start to see a gap on the oring

@cruzever09 2 ай бұрын

Dang so wheel bearing making that noise I'll make a note of that we haven't seen any yet with noise complaints

@byallmeans8270 2 ай бұрын

That Atlas was a weird breed from factory

@PatrickErasmus-nc1or 3 ай бұрын

sent that old light to me

@baranycuriel 3 ай бұрын

What turbo is? T3t4?? Hi im from tijuana. Mexico. Near to san Diego California.

@byallmeans8270 2 ай бұрын

Precision turbo 6266 gen 2 ball bearing

@annh.torres1242 3 ай бұрын

Where do you buy those? I have a Honda accord 2015 sport

@ethanevangonzalez5206 3 ай бұрын

Did you have to drain the engine oil before you started removing the head gasket?

@cruzever09 3 ай бұрын

Dang a harness havent seen one of those go bad so farr

@ishaaqmalik7103 3 ай бұрын

I got a water stain inside the actual screen, is it possible to take only the screen off and clean the water mark?

@byallmeans8270 2 ай бұрын

I would replace that

@vdubsterw2516 3 ай бұрын

all those badass parts and you still have the crappy oil to coolant heat exchanger on the oil filter housing. wtf! ditch that junk.

@jaredd8473 2 ай бұрын

Replace it with what? I ask because I'm a about 2 weeks from fully finishing my engine rebuild. All performance parts, 2.0 stroker etc

@vdubsterw2516 2 ай бұрын

@@jaredd8473 dont replace it with anything. All it is, is a heat exchanger for cold weather. Its designed to get the oil temp up to temperature faster by using the coolant that is circulating from the block through the bypass hoses before the thermostat opens up. It is not needed unless u live in a cold climate and you are starting the car early in the morning and driving it right away before the car gets up to 210 degrees. If you are concerned about the truth that has been presented to you just now, then go buy a real oil cooler and a filter sandwhich plate with 10 an fittings and install an oil cooler instead a cold weather heat exchanger. And by the way i work on vw cars almost every day. I can tell you this. Those oil and water exchangers leak all the time. So if you dont mind coolant in your oil later on while you run that awsome motor you built then by all means leave it on there.

@RyanRocket 3 ай бұрын

Hey man are you located in the south? I was wondering if you were close to me.

@piotrochel2518 4 ай бұрын

How to remove front counter panel?

@Lifesourban 4 ай бұрын

nice video!

@byallmeans8270 4 ай бұрын

Thank you idk what happen during rendering the video was synced better than this

@NathanFromme 4 ай бұрын

Im a dealer vw tech. I’ve ran into that stupid plastic pipe breaking in the head before. I’ve been able to remove it both times. Both times it was already broken in the head leaking coolant.

@XESCOBARCARTEL 4 ай бұрын

Hello, the USA spec boras are lovely , the rub strip / front bumper trim with the light ? Do you know where I can order USA spec trims etc without spending a fortune?

@XESCOBARCARTEL 4 ай бұрын

Or please can I have the part number from the front bumper rub strip

@PDX-JAY 4 ай бұрын

your tires 225/45/17?

@89foxguy 5 ай бұрын

Yo what lights are you using? HID kit? looking for my mk4 gli stock lights are terrible.

@Lifesourban 5 ай бұрын

GOOD JOB

@byallmeans8270 5 ай бұрын

Thank you 💪🏿

@jwhitehead4959 5 ай бұрын

Promo_SM 💖

@wizking3400 5 ай бұрын

What's your ig bro?

@byallmeans8270 5 ай бұрын

Twizzy.mcfly

@Lifesourban 5 ай бұрын

looks good, that garage comes in handy!

@warlord431 6 ай бұрын

So did that fix the problem with the Touareg?

@byallmeans8270 6 ай бұрын

Yes it did after the module was programmed

@frann949 6 ай бұрын

Here in Arg this car is called "bora" you can search in YT for "bora 1.8t" You can also watch the video called "bora big turbo hernan" which is a jetta just like yours with more than 700 horses

@Lifesourban 6 ай бұрын

Good job tearing it down & putting it back together

@hellboundTX333 6 ай бұрын

Keep learning and become a master tech.. no more tire work!

@byallmeans8270 6 ай бұрын

💯 I peeped that early master tech never do tires after becoming one

@YoAminor 6 ай бұрын

too fire

@Lifesourban 6 ай бұрын

Nice wheels on it

@byallmeans8270 6 ай бұрын

💯 Vossen wheels. I have another video dropping on this car real soon

@fabioc9605 6 ай бұрын

I too would love to see pics or a video of the setup

@byallmeans8270 6 ай бұрын

Check out my older videos I have a few clips and pictures of the setup. Some time this year I will make a video on the full setup

@jimlee7317 6 ай бұрын

Yes, let's see the equipment that's why I'm here ❤

@byallmeans8270 6 ай бұрын

@@jimlee7317 I got you once the LSD delivers I’ll have to make full video one of these days on the build. For now check out my older videos on the setup. I have about 2 videos that shows alittle of the process and all the parts I got for it

@hellaflushhonda 5 ай бұрын

I’m in the process of going big turbo on my 20th, it’s got a built bottom end, a DKM clutch and a 02m transmission with welded shifter forks, I just don’t know where to start on the set up, I wanna go gt30 but I’m confused on turbo lines and what tuning to do and people have so many different set ups haha, especially with the MAFs on these