Cool just what I needed to find. I had been hearing some water sloshing around occasionally inside the dashboard area. My backup camera stopped working and the started working again. (No sure if that was related ) but I began to think about it a little bit more after seeing water on thethe floor mat. I just tackled this job and it looks like it was time! Your video was super helpful. Thank you.
@WiLL0272420 күн бұрын
@@JasonPurdyNH for the backup camera, if you open the tailgate there is a little plastic square cut out. If you pop that cover off you’ll have access to the backup camera wiring. I usually just wiggled it and it would work again. It probably needs an electric contact cleaner spray and dielectric grease for the connector but the quick 10 second wire jiggle works for me when I needed it to work quickly.
@JasonPurdyNH19 күн бұрын
Thanks@@WiLL02724. I'll keep that in mind when goes out again. Or clean it up when I'm feeling more ambitious.
@johnnielsen4759Ай бұрын
Worked Perfectly!! Thank you.
@CathyKunceАй бұрын
Thank u for making this video! I’m a 70-something year-old grandmother, and even I could do this! Although, I did break/loose 3 of the 6 black clips 🙄
@austinhealey4488Ай бұрын
Great video! Thanks!!! I just completed this following your steps. A successfully job with no injuries, damage, or trips to the store! My only variation was a minor one-- instead of an 8mm socket on the driver’s side, I used an 8mm box wrench to reach the clip.
@natecole813 ай бұрын
I wish I saw this video before removing the wipers. FYI : the arm puller I bought was about 1/8” off center and kept slipping. Got it done, now to wait for the next rain and see if it works. The 2012 flex has a mess cover over the drain. And a metal covering over that… fun
@LambentPoint6 ай бұрын
Easy peasy! Great video! Just did mine.
@byronpendleton82726 ай бұрын
This has got to be the BEST video showing step by step how to fix this issue. Removing the wiper blades was way too much work. Thank you. 5 Star Video 🌟🌟🌟🌟🌟
@tennaj13677 ай бұрын
Appreciate the video it was helpful. My issue was when I went to the automatic car wash all that water and soap would build up because my drain was not clear which allowed the water to drip down in my heater box so when I turned my heater on it would fog through my vents! At first I thought I had a bad heater core or something until I noticed it only happened when I went to the automatic car wash.. And my coolant reservoir was at the normal level. And also it smelled just like the car washew soap and not sweet like antifreeze. 😊
@WiLL027247 ай бұрын
Be careful running the heater or AC on full blast through the car wash. It can suck water into the blower fan and short it out. That happened to me! So now I always shut it off fully to prevent it happening again.
@tennaj13677 ай бұрын
@@WiLL02724 Good advice. 👍
@worldbiggestfan19 ай бұрын
wait is that james ryan, thanks miller for the easter egg saving private ryan
@martinfinster989910 ай бұрын
While watching another vid on this, I thought, "I can use a small socket to remove that white clip.". Great minds think alike!
@gavinj0111 ай бұрын
Thanks! What is it with the Flex and doing things the hard way! I recently replaced my HIDs and everyone says you have to remove the grill and number! I found someone like you who showed how to go in behind the wheel wells and it was relatively easy.
@thomasanderson652111 ай бұрын
Great video and the idea to use the 8mm socket. My only mistake on my 2009 flex was after I cleaned out the cowl was not trying to run water through the drain hole and I found out later it was plugged up further down. I had to do it all over again this time I took a wire and bent it down the drain hole and then flushed it with water. Second time's a charm and easier.
@ValentyneMusicOfficial Жыл бұрын
This video was super helpful to me today! Thanks!
@jinhiryu1786 Жыл бұрын
Super helpful. Just did this today, one of my drains was fine the other was completely gross though.
@user-yj1qm4vu2f Жыл бұрын
Worked great thanks
@WiseLights Жыл бұрын
Do you still make videos?
@WiLL02724 Жыл бұрын
I do.
@carlreeves9329 Жыл бұрын
awesome,,like the socket idea !
@cobyglenn8719 Жыл бұрын
It’s all still there I went there recently it’s in laketown Massachusetts. It’s right next to the CVS
@sammypsycho8273 Жыл бұрын
I have to do this yearly. What happens if you just pop them pos out and leave them out?
@ministryofwrongthink69627 ай бұрын
Your muffler will fall into the radiator
@sammypsycho82737 ай бұрын
@@ministryofwrongthink6962 You win by default. 🤣
@mark97213 Жыл бұрын
What is the piece(s) under the cowl vent that you fasten to with retainers? Mine is missing. There's just the top plastic piece that you see behind the hood. The cabin is flooding with water when it rains.
@zackdonato8728 Жыл бұрын
Wow rip
@uscgspawn2298 Жыл бұрын
Only open for 28 years. What a waste. So many great memories got bulldozed along with the building
@HappyCamper1992 Жыл бұрын
First thank you for the video. Second I guess I got lucky I was able to get my hand to the one on the passenger side and pull it out from the bottom. Yup it was clogged. And was able to replace it without too much issue and without any dismantling. The drivers side I had to use a wooden dowel and a flashlight and with some Dawn dish soap and low amount of water was able to work the clog out from the outside. But thank you for showing me the locations
@joeg29422 жыл бұрын
I just cleaned out the drains following your instructions. Best and easiest way to do the job. Thanks for posting the video.
@trapperjohn34002 жыл бұрын
Nice saves quite a bit of time, thank you
@tcatnat702 жыл бұрын
Thanks for this. I've been having water in the cabin passenger floor on and off for two years and could not figure it out. Both my drains were clogged to the top. It took me less than 30 minutes but I did lose one of the black clips when it popped out of my hand and fell into the engine compartment. 8mm socket is genius. Super easy when not having to remove the wipers.
@swirvdabuilder53782 жыл бұрын
ABSOLUTE GAME CHANGER FOR ME BRO!!!! THANKS FOR THE SIMPLE SHORT AND SWEET OF IT ALL!!!!! THIS WAS AWESOME.
@Snowbird_892 жыл бұрын
I just read they are going to knock down all the buildings and build a warehouse on the property.
@fodormotor2 жыл бұрын
Thanks for this video including what tools to grab. I was able to bang out this cleaning during my lunch break and have time to type this and eat a sandwich. A+ would watch again.
@billslusher19352 жыл бұрын
Thanks WiLL. Genius with the 8mm socket.
@DAK1dd20102 жыл бұрын
RIP
@the38steps2 жыл бұрын
Thank you for this. Looks much easier than some of the other methods. Great tip using the socket for the white squeeze tabs.
@jimsdigitalself2 жыл бұрын
My Mavic 2 Pro was perfect for 2 years, then it developed this exact problem. It happens infrequently. Can even go a few flights without having the problem. Very strange. I was thinking it was probably the ribbon cable to the camera. But now seeing that a lot of new ones are doing this, I'm not so sure.
@alekseiiudin28742 жыл бұрын
I have the same thing - I am actively working on my Mavic 2. After 2 years I started having the same problem. I thought it was due to the strong wind and possibly tired motors of gimbal. I don't know how to fix this. Have you found a solution?
@jbrey84272 жыл бұрын
@@alekseiiudin2874 Nope. It wasn’t the ribbon cable. I replaced that, no help. I sent it in to DJI for an estimate and their estimate was insane. They quoted me $1287 to repair the Camera/gimbal and an additional $600 to fix the drone body. I thought they were out of their minds! Said just send it back as is. But your problem could be different.
@alekseiiudin28742 жыл бұрын
@@jbrey8427 It's easier to buy a new separate gibald with a camera for $600 and replace it yourself))) Let me know if you find an answer in the future.
@jbrey84272 жыл бұрын
@@alekseiiudin2874 absolutely!
@yusiffranklin17542 жыл бұрын
Results 👀?
@WiLL027242 жыл бұрын
Finished pics in the Instagram link in the description
@dpjohnjones4322 жыл бұрын
yep had the same issue with one that was brand new out of the box. Now I'm experiencing it again on another MP2 that belongs to a company I'm. This one has it worse than mine does. Cant bank right at all or it goes nuts!
@WiLL027242 жыл бұрын
My second unit has been perfect. It’s almost a year old now.
@thehighhighpriestess2 жыл бұрын
🤤🥵
@WiLL027242 жыл бұрын
Hey you’re here 😆😆😆
@thehighhighpriestess2 жыл бұрын
@@WiLL02724 just here looking for car tips 😅🙈😬
@linchen91502 жыл бұрын
Cute hope you have fun!
@carlklitzke94552 жыл бұрын
Thank you for putting this up! It's more of a pain just removing the windshield wipers than this whole process. Awesome time and windshield saver.
@ryanmiller91373 жыл бұрын
Short, sweet, and to the point. I would probably have broken those white tabs off. Never thought to use a socket on them lol. Thanks!
@WiLL027243 жыл бұрын
Originally I used needle nose pliers to pinch the front and back of them, but I found the socket to be so much easier ☺️
@Myles07313 жыл бұрын
What is the address
@davidbamlett953 жыл бұрын
same here brand new from box. sent for repair. uk and came back no different
@jimsdigitalself2 жыл бұрын
Wow! That sucks.
@jacksonbush43213 жыл бұрын
I have the same problem with one of my MP2’s.
@ILoveJamAndPeanuts3 жыл бұрын
Me and my dad would go down the rock hill and down there was a door that led under the now pile of rubble. He had a lot of computer stuff in their, he rented it out back in the day. But the some fire happened and he lost everything in their. I'll never forget the day I saw the remains of my favorite place. We called it the batcave, man time has flew by...
@weevilwoovil99793 жыл бұрын
What a great place to shop over the years, times change everything. Ballad of The Bizkit music video was shot here. Haha!
@zoranprpos2923 жыл бұрын
Do you have to be connected to wifi to go back to stock?
@kg_17203 жыл бұрын
How did you get those gauges on your screen monitor?
@WiLL027243 жыл бұрын
That’s the Tunerview app running. The head unit was rooted to allow me to install Android apps. If you have a 2016-2017 you can do this yourself for free. If you have a 2018+ you can do the paid version from autohack.org
@kg_17203 жыл бұрын
@@WiLL02724 Thanks Will! 🙏
@rlkassan834 жыл бұрын
Which skin is that for tunerview? I cant seem to figure out how you got the steering wheel in the gauge cluster
@eleizerjudeantes25034 жыл бұрын
Hi! How did u removed the errors on ur dashboard?
@WiLL027244 жыл бұрын
Eleizer jude Antes drive for 10-15 mins.
@eleizerjudeantes25034 жыл бұрын
WiLL02724 mine was still there even I flashed it to factory
@eleizerjudeantes25034 жыл бұрын
Last time while I’m driving, all the errors pops up just like it’s erasing during on flash. Is that means it’s already initializing. I was got scared that time that’s why I turned the engine off, and open it again. And the errors were still there
@eleizerjudeantes25034 жыл бұрын
Hi! May I know if what year and what model is ur car? Coz I just bought v1.2 ktuner and prl cold air intake (race) maf. And my car was 2017 civic touring coupe.
@WiLL027244 жыл бұрын
2016 Civic Touring (sedan) Street Maf.
@eleizerjudeantes25034 жыл бұрын
WiLL02724 how did u change your tuner view?
@WiLL027244 жыл бұрын
@jac46771985 I couldn’t comment on your video but wow that water shooting out the back got a little close it looked like !!! 😬