Turning all 2ohms speakers into 1 ohms would not sound great. The higher the ohms the better the sounds so it would be better if you install a 4 channel amp and connect all the speakers individually the get the best of all speakers

awesome , gonna test this out soon

Thanks man im gonna declog it this weekend

Love ❤

High quality Tutorial. Thanks!

High Quality Tutorial. Thanks!

Does it have to be empty to change out???

Thank you!

Yep they never tell u details as long they sell it..

Can you tune the touring mode as a gas saver and sports mode as a race mode as in 2 different tunes?

Love it

Thank you !!!

What do you use to clean the gasket itself before re installing the throttle body?

Me and my grandson followed your instructions like 3 time and every time and the door isn't locking

Are the torsion keys adjusted now. I have 22 duramaxx with 7 inch with 37s and it’s definitely not this tall.

Hello I did the noid lights on all injectors. All noid tests seem to be very weak. Is that normal, I got a 2012 suburban 5.3 that has a stumble when giving the throttle lightly. Any ideas would helpthanks marc

what screws do i need for this

Thank you so much!! My dad has a long history of kicking locks with enough force to knock them clean off, but it still helps to finally have a doorknob that locks for my room ♡♡

2.5 inch all around when your family got in truck did it make any difference or when you went over anything

Want to drop my Chevy suburban do u think it will work the same way

A 36mm wrench works as well as te 1-7/16. Also recharging was not discussed. Turn key or press button without putting your foot on the brake. You will here pump when it stops you are good to go.

Name the type of exhaust love your set up rims?

Okay. I have a question. I have a diamond audio technology D3 600.1 mono block amp with two positive and two negative. I put a speaker to each. I have two 10" Massive Audio GTX104 1400 w max dual coil subwoofers. What would be the best way to run the wires for these subs, series or parallel?

Very helpful. I will try to do this. Thank you.

Well done. Very thorough and well explained.

is having hyper flash bad ?

Thanks bro, trying to fix my mirror. I have to replace the wires too. 😮

Do you do this before you clear the codes or is this supposed to work consistently

I did it. And it rides like crap don’t do it

J

Would this be the same or almost the same location of an Ford F150 1989?? Anyone?

Need better wiring brother. Besides that nice build.

Great video. Way to go man, probably helping thousands of people

Looks easy, hopefully it will be for me, I will try later this week to replace a door lock first time by myself 😅

What headlights are you running looks nice and bright and super white with very light tint of blue can u see at night normal or did u lose a little bit?

I’m hearing the same noise on my 2023 Chevrolet Silverado 1500 4x4 smh taking this Friday morning to get check up i took the front wheel off and checked the brake pads still new with a lot of life in them looking forward to to what they said

Liking and Commenting as an appreciation for the help.

True hero of the people I can come find this video ten years later in 2024 and work on my 2011 thank you

Those are not Catts, theyre resonators.

And to op, the word is not bafore its before

No domestic car has secondary catts, none, unless you remove only one, the left or right.

Can you help me Out I have two e15 duel 2ohm I want 1ohm At the min there half ohm I don’t like

Hey man thanks for the break down i e been trying to figure this out I was the same set up

Great information 👍🏼 thanks again 😀I finally got some understanding about the ohm,s

Use a torx bit to drain the diesel fuel before lossining the whole yhing

What’s the wheel and tires size on the Denali

I just got a 93 Geo tracker project for me and my sons that I’m possibly doing a LS1 engine swap. So I can’t wait to see this project completed.

cleannnnn

I have this install the exact same way. But I don't like the sound. I can't figure out gain is all set. No clipping on any indicator. But the speakers sound like they raddle when being pushed. Everything is tight. Super frustrating on my 2024 trail boss

Used a 6MM box wrench on the small push together tabs, worked really well up in the corner of the cap.