100 +- with cable 3_ 400 in bedrock with our rotary drill in some areas as needed, thanks

I have not owned a ford 555, or worked on one... sorry cant help there

Eric, glad it was helpful

EBAY

Thank you for the information, that sounds worse. I have a old case 680.. i has breaks that ride on the pinion shafts, easy to replace, just pull a cover off slide steels an discs off shaft, to renew, reverse procedure with new break parts. but one problem, disks are way o small a diameter, so on a good day here is very little breaking power.

Algunos me dicen q lleva un retén donde esta la flecha

Ellos corren en aceite They run in oil, I hope i got translation correct, thanks for watching I hope everyone got some help from this.

North central washington

Sorry, don't understand, but thanks

no, we did both sides, they are identical

@@upsidewithstephenkreider589 I'd like to think Case would make it easier to replace brakes. I've been thinking about replacing my current backhoe with a case, not new of course. Good video.

thank you for watching

Thank you for watching

these discs are no fiber or normal break martial, there is a grainy metallic material imbedded on the disk? did not think soaking would do any good, thank you for the commend.

Sure hope it helps, I could not find much information when we did this.

I did a transaxle rebuild, the easiest way is disconnected everything associated eg drive shafts etc plus wheels whilst sitting on the rear legs, then start engine lower transaxle onto the ground on a piece of wood, remove the bolts that hold the trans in place once on the ground then start it up and raise the backhoe, once your done that pull the whole tranny out and ok on it that way, easy as 🇦🇺

I'm gonna find out pretty soon. 82 580d

Cuanto aceite lleva esa trasmicion

Don know it is bad, just difficult to replace brakes for sure.

Thank you for your comment, glad you liked the video

Thanks for sharing, i have a bar and chain tightener, but after using it several times, joint kept coming loose, I just could not get it right, so went to using the chain fall

@@upsidewithstephenkreider589 Stephen,we never had any trouble with the bar and chain tightener . When you changed bits do you take a wet stone to the shoulders of the bit and box? We always did that every time we changed bits,put on jars etc. but if the chain fall works that is good. When tools come loose on a cabletool rig it can be a pretty bad ending . I love those little rigs. I still want to buy another one but I am now over 70 and the wife said "NO"!!!!! With another word ahead of it. I would love to have either a 20W,22W or possible a 60L that I could use to drill a couple shallow gas wells on my property. I think by 1100' here I can have a couple or three shallow gas zones.

I love these little rigs. The Speedstar is a great rig. That is a 55 isn't it Stephen?

Had a 22w made in 58. A 55 ss 3-51 keystones

Drilled 50 mile radius of Westminster Md. 30 years. 65 years old now. Retired early to help care of mother in law, alzhiemers.

I don't think I would call it complex, , but difficult to work on

@@upsidewithstephenkreider589 yeah i can agree with that

im in okanogan county Washington

Thank you or your comment. It was actually a fun machine to run

@@upsidewithstephenkreider589 Looks like a model 55?

this one is a star, of unknown designation

It looks like a 55 Speedstar to me. The bean is a lot heavier on the 71. After watching the video again. Love the videos keep making them. I miss hanging on the line ! Thank you and have a most safe and Blessed day !@@upsidewithstephenkreider589