Hi There! thanks for the video. I'm not very clued-up when it comes to driving light installations. you cant perhaps send me some photos of the routing inside the cabin? I tried installing this afternoon but that grommet is so tight and I don't want to break something...
@tomduff2491 Жыл бұрын
Did you cut the dick off to feed cables through?
@doggothedog7744 Жыл бұрын
I needed this video. Thank you so much!🖤
@deni.b4577 Жыл бұрын
Thank you so much , this is the first KZbin video that solved my problem without any fuss .
@sawyer41032 жыл бұрын
U can buy the Adapter for N80
@sawyer41032 жыл бұрын
Try this
@screwdriver35772 жыл бұрын
Is the stedi wiring kit plug and play for the facelifted n80 hilux? I read all these online forums about it being negatively switched and slight modification is required to the wiring kit. I’ve got no clue what it’s all about.
@motoelectric74972 жыл бұрын
I'm not entirely sure about Stedi, but if they don't there's now a range of patch harnesses that I source from Cooldrive that will do the job with any kit. And yes, you need to pick up both a switched positive and switched negative on most Toyotas.
@GlobalTriathlonNetwork2 жыл бұрын
So none of the wiring looms come with an 8 pin adapter to tap into the headlight plugs??
@motoelectric74972 жыл бұрын
Not many. I think just Stedi and Lightforce offer an option but it's not offered in their generic wiring harness kit.
@BGS21002 жыл бұрын
Hi, how can make lights activated from high beam
@motoelectric74972 жыл бұрын
Hi, the circuit that I tap into is high beam. When you connect the switch circuit from your driving light harness, you'll be good to go!
@dilomurphy2 жыл бұрын
Very helpful. Thanks for this!
@ivantheron41542 жыл бұрын
He mate, thanks for that, those 8.5 inch spotties, did it interfere with the radar ? Thanks man…
@motoelectric74972 жыл бұрын
Hi Ivan, no interference reported from the owner whatsover. 👍🏼
@Fekillix3 жыл бұрын
Do you happen to remember any of the other pins other than earth and high beam? I'm upgrading from halogen to OEM LED headlights and I'm trying to make up a wire diagram that won't fry my new expensive headlights. It's so new I haven't found anyone else doing it.
@motoelectric74973 жыл бұрын
Hi, no I'm sorry I haven't. I simply haven't had the need to. But if you are just chasing the low beam circuit as well, it won't be difficult. Using the same earth will make it a safe bet to find the correct pin. Good luck!
@Fekillix3 жыл бұрын
@@motoelectric7497 Hm, I guess I will have to overcome my fears eventually ;). There are some people in Thailand that make adapter harnessess but they're pretty bulky. I bought the OEM connector to re pin the original harness. Originally there are four connectors one for each incandescent bulb. I know there is one relay required for one of the pins. At least now I have two pins to start with.
@marcelogarcia50943 жыл бұрын
Thanks for that mate Saved me some time doing the job 👍