Great explanation of how to replace the crank shaft censor. Well done.👍

Bro you sound like you are in a wind storm

Every place i went they didn't have the harness so i did it like you thank you for your help

I..Think..Guy here..is.. wrong.. my truck was doing the same thing and all I had to do was change the call Pandora

Thanks

Thank you, this video applies to 2010 as well

Worked like a champ!! Been battling this for a few years… fixed in 10 min no $$ thanks. !!

Thank you It worked for me

Thank you . That heat for a while 15 minutes was the worst . Thank you Just saved me .

Cut ur nails bro nasty 🤮

After you install the crankshaft position sensor you have to relearn the sensor they usually charge between 30 to 50 dollars to do it in a shops with a scanner

You're a life saver I live in Arizona and that happened to me today it was 112 degrees and I was stuck in traffic so I tried as soon as I got to work and it worked. Thanks for Making this video it work me

Ty sir. Very helpful instructions, 10/10 You're doin the Lord's work

Excellent!

Muchas grasias Mario por tomar tu tiempo en aser este video pude areglar mi chevy tahoe 2004 con tus intruciones. Thank you for taking the time on doing this video because it takes time and u did it to help everyone here I was able to fix my chevy tahoe 2004 thanks bro

I started by just turning the heat all the way up and then slowly bringing it down, and that worked for me…. Much Appreciated!!!

Nunca regreso el problema ?

Brooo thank you so much I parked at a gas station turned my truck off with ac on then came back and it was blowing nothing but hot air i send positive energy bro 🍺💪💪🥶🥶

Bro your a straight hero!! My wife and I have been miserable past two summers buying motors on motors or fuses or switches just to find the EXACTSame issue I looked in wiring of driver door and sure enough severed wires galore lol Gracias way

Thanks, same issue to my car...ill try krank shaft sensor

Saludos hey what is that little computer box called please?

My 2005silveraddddoooo heat n air controlls look nothing like this(l. S). I guess gm had better ideas. Lets just F f F F. Up these trucks more!!! 3 actuators. Dummmmm! Hell to get too. Hey. Lets just tear the damm dash all the way out. Dum dum G. M.

Thank you Mario you did a great job on explaining how to do this repair.

Thank you for your post, were having exact issues and you just saved us a whole lot of trial and error.

Thank you

hey easy way from instructions to calibrate the Hvac .... so 1st turn ignition to acc dont start just acc then to have both temps at same time just press Auto wait till the display shows arrows at bottom with word auto between then 2nd turn truck off open hood open fuse box remove 10 amp fuse that says Hvac wait 2mins then put fuse back in 3rd ya turn truck ignition all the way starting the truck the temp display should show 74 farinhiet with air condition snow flake on DO NOT TOUCH GIVE IT NO LESS THEN 15SEC NO MORE THEN 30SEC 4th turn ignition all the way off turn back on and select ur desired temp and output and thats it done.

thank you so much !!!! this video helped my friend turn her car right on

Thank you so much! I've replaced parts before and was going to replace them again until I saw this video. Your video fixed my issue. Good bless you man!

Yes thank-you it worked on my 05 silverado thought it was the actuator almost bought a replacement then I saw your video worked perfectly saved some money and a headache

Starts cold then turns hot on drivers side . Turn off the car and start it back , runs cold for a little while

Gracias Mario!!! Trabajo para mi 09 Silverado, mil gracias por este video Dios te Bendiga

Gracias

Too much work , put the climate controls just above cold on both sides turn fan speed to 3 disconnect ac fuse located under hood by drivers side turn on truck for 45 seconds turn off for 15 seconds reinstall fuse turn back on should work. You may have to try a couple times. These instructions are for 03-07 Silverado climate controls with sliders knobs but may also work for digital climate controls.

Yes this did work on my 05 silverado. Only thing is i had to disconnect the box and run the a/c. While the truck was is accessory mode. I change the temp from hot to cold then turn the ac off. Reconnected the box, crunk up my truck and turned the ac back on. And it worked😊

promo sm 😡

If doesn't work first time try again... If you only have one control do the same proses...

so I take my dash apart , but do that?

nice , thanks bra

Gracias

Had this problem on 05 sierra, 1st. turn off ignition, as soon as possible once you realize it isn't cooling. 2nd. Restart vehicle, if it begins cooling. Take to ac shop Ask for the shim to be removed on the ac clutch. I replaced, belt, both high and low sensor, had it recharged with proper ounces. Humbly drove into account shop, cost 150. Be running great for 3 years.

Would have been nice to know all that before I unplugged them all after I got done and I turned my AC on now it will not stay on it blinks and shuts off

Thank you so much this helped me!!!!

so bascially hes saying the battery needs to adjust or be reprogrammed to the system if the battery is replaced which i did replace my battery so ill check this out tomrrow ill let you know if it works.

Thank you Mario, I was looking for the fuse, but I was looking under “radio”, I ll check the fuse for dome asap. Gracias 👍🏼

wind too much on the truk too mucho

Flapping vent! 😂 Regardless I’m gonna try this. I hope it works. Thanks !

Tried this on my 04 Silverado and 05 Suburban worked in the Driveway time will tell🤞

I let my truck battery die since these gas prices are outrages and been using the Honda. This method worked! Thanks brotha 💪🏼😎 06’ Chevy 2500 HD 6.0

Doesn’t work..

So glad this video popped up ….. I have an 03 Tahoe that after changed battery same thing happened, mechanic was stumped as everything was in working order. Thanks a ton, never would have thought changing battery would cause this