4 ай бұрын
2 жыл бұрын
3 жыл бұрын
3 жыл бұрын
3 жыл бұрын
3 жыл бұрын
3 жыл бұрын
3 жыл бұрын
4 жыл бұрын
4 жыл бұрын
7 жыл бұрын
Пікірлер
@Its_paulo 14 күн бұрын
This is what my sr sounded like after I did my rockers, was off a tooth with my Tomei cams. Then it went back to normal idle after I fixed it
@kalvinhengler8827 Ай бұрын
SO freaking cool man
@arca9e295 Ай бұрын
I know this vid is for the cam but I can’t help but admire your catch can setup
@alitutar8533 Ай бұрын
Boost psi ?
@GarageAbstract Ай бұрын
14 PSI. All specs are in description
@codynichols12 2 ай бұрын
is that the full motor build in the description ?
@GarageAbstract 2 ай бұрын
Yes, it’s a very simple setup
@jonathanrice-exec11 2 ай бұрын
Nice! Sounds great! Is the yellow car TD06 now as well? It'll be nice to swing by the shop again once I'm living in town after next month
@GarageAbstract 2 ай бұрын
Yes! Yellow car has TD06-20G. And yeah, swing by and hang out for a bit once you’re back!
@teamd-frog1260 2 ай бұрын
perfect sounds
@reubenmorris487 3 ай бұрын
My first DSM with HKS 264/272 sounded like this with slightly less chop and pop.
@kornboyjr6419 4 ай бұрын
What rear gear ratio is it running?
@GarageAbstract 2 ай бұрын
4.08
@esoteric__ 4 ай бұрын
Which bov was this thing equipped with? Sounds like old HKS. Seen that some guys who ran no BOV with the RX suffered catastrophic failure by snapping the shaft due to the RPM's that the billet wheel achieves and the sudden deceleration was enough to cause the shaft to snap off at the base of the inducer wheel. 3 pulls on a dyno and the thing calls it quits.
@Zilvia33 4 ай бұрын
Delicious music 🤌🏾
@ej208 6 ай бұрын
17 lbs in bars?
@scareyaf 6 ай бұрын
About 1.2 bar or so. Google exists my dude, use it.
@user-lp5wb5wg6v 7 ай бұрын
What BOV? The car sounds great!
@zoic613 6 ай бұрын
That’s no bov.
@JohnHonza 7 ай бұрын
🥵🥵
@ItsMarkBernardo 8 ай бұрын
hell yeah brotherr
@um-cara-no-impreza 8 ай бұрын
rx7 ?
@GetBusyDrift 10 ай бұрын
that shit sounds so wet
@pistnbroke736 10 ай бұрын
I have finally copied your set-up. Sounds similar, not as lumpy now it's tuned. I also funny enough, have the same wheels you have on the front 😂 just about to throw on a GTX3076 turbo with a ramhorn high mount manifold.
@EvThaFunkyHomosapien 11 ай бұрын
Any reason going for the hks cams vs tomei poncams?
@GarageAbstract 11 ай бұрын
Tomei Poncams are a great drop-in replacement without needing to further upgrade the springs/retainers. However the 258 duration and 11.5mm lift of the poncam doesn’t offer as much as the 264 duration, 12.0mm lift of these HKS step 2 cams.
@EvThaFunkyHomosapien 11 ай бұрын
Thanks for the reply! I failed to see they were a higher duration. Do you have a preference for 256 duration cams between hks and tomei?
@dennisrobinson8008 8 ай бұрын
Hi, So the 258 poncams are a direct drop in and don't require a tune, but the 264 cams will?@@GarageAbstract
@GarageAbstract 7 ай бұрын
@@dennisrobinson8008 I recommend a tune with any cam upgrade. The poncams are “drop in” meaning they don’t require further valve spring or retainer upgrades, whereas the HKS 264 cams do
@jaredsannicandro4658 Жыл бұрын
exhaust mani?
@GarageAbstract Жыл бұрын
Trust mid mount
@14dose Жыл бұрын
What size and material is the dose pipe man?
@GarageAbstract 7 ай бұрын
It’s a Trust air intake kit. Aluminum, opening up to 80mm at the MAF
@Understeerking Жыл бұрын
🎶🎶
@jeremynazario3971 Жыл бұрын
What oil do you use?
@GarageAbstract Жыл бұрын
Motul 300V 15w-50
@jeremynazario3971 Жыл бұрын
@@GarageAbstract Stock block never open, stock oil pump and stock oil filter? right?
@GarageAbstract Жыл бұрын
@@jeremynazario3971 Stock bottom end, stock oil pump. Greddy thermostatic oil filter relocation, Greddy oil filter, Greddy oil cooler
@jeremynazario3971 Жыл бұрын
@@GarageAbstract okay perfect I just wanna ask bc I have the same spec as you but the only difference is that I got 272 cams and I use 10w40 but when I use try to use 15w50 I feel lost of power
@GarageAbstract Жыл бұрын
@@jeremynazario3971 we’ve used 10w40 during the winter time in our street cars, and haven’t noticed any power difference. Both weights are perfectly fine depending on application. No problem!
@colemannon Жыл бұрын
Older video so not sure if you'll see this buuuuuuut....does this have the bigger center resonator like the newer N1s do? If so, how was ground clearance? Planning on getting one of the newer N1s and I'm around the same ride height.
@GarageAbstract Жыл бұрын
This was the older version with the smaller mid section resonator, haven’t had any experience with the newer one, sorry!
@colemannon Жыл бұрын
@Garage Abstract sick!! Thank you for the insight! Might just end up running the rear section then.
@warbvrton Жыл бұрын
Love it. Cool to see another s13 with hurricanes
@roshailsmedia2067 Жыл бұрын
Who needs a rotary?
@Jeremy_Hill_2020 Жыл бұрын
0:05 stustustu
@Jeremy_Hill_2020 Жыл бұрын
that one person: "you did a 13B swap?"
@garybuder4645 Жыл бұрын
Guesstimate on the diameter of the horn? I'm looking at a set but they don't list the size.
@jerxue2194 Жыл бұрын
What fuel pump you are running?
@GarageAbstract Жыл бұрын
Walbro 450
@GabesGarage 2 жыл бұрын
A lot of improvement from the video on the rain at Lanier 👌 nice that track look very technical.
@owenmccannell5831 2 жыл бұрын
Man, shoutout to you for answering literally every question in this comment section. Need more people like you in the car scene rn. Much love bro!
@milkteaman510 Жыл бұрын
I wish more people did this, I try to answer as many questions as possible in my video comments. I like to help people figure out their issues and help with their planning.
@trippieredd2899 2 жыл бұрын
Super nice ride. Who makes the exhaust tips you uave on there I like the angle.
@jw5031 2 жыл бұрын
What injectors?
@GarageAbstract 2 жыл бұрын
Nismo 740cc
@dfr9789 2 жыл бұрын
can i know what size are your head gasket?
@dfr9789 2 жыл бұрын
dude can i know ur cams size?, is it a 264/272?
@GarageAbstract 2 жыл бұрын
yes, specs are in description x
@dfr9789 2 жыл бұрын
stock rods and pistons?
@GarageAbstract 2 жыл бұрын
Yes
@thomasjoyce8374 2 жыл бұрын
Is this a speed density setup?
@GarageAbstract 2 жыл бұрын
No, N62 MAF equipped
@langgengpratama8106 2 жыл бұрын
that lumpy sound is an eargasm :3
@cmbrlnd94 2 жыл бұрын
What fuel is this on? Curious as I have a very similar setup atm and going for a tune in a couple weeks, thinking of maybe going e85. I also have a GT2871R with .64 housing, and HKS cams too but 254/264's instead and I am also running 740cc injectors. Very nice build, love it!
@GarageAbstract 2 жыл бұрын
Sorry for the late reply, this was on 93 octane pump gas
@THESLlCK 2 жыл бұрын
it literally sounds like half a muscle car, that's so cool
@_yungfrankz Ай бұрын
Half of 8 is 4 😎
@THESLlCK Ай бұрын
@@_yungfrankz source??
@leakerror 2 жыл бұрын
this is a stupid question but does the gt2871r bolt up to the stock mani? also do you know if gt2835s do or not aswell
@GarageAbstract 2 жыл бұрын
Not a stupid question! The stock manifold uses a “T2” turbo flange. So any turbo with a T2 flange on the exhaust housing will work! Some turbos are direct bolt on replacements for the factory T25/T28, while others may require custom intercooler piping and exhaust work. This particular turbo used in the video was just a direct bolt on unit
@leakerror 2 жыл бұрын
@@GarageAbstract is this the correct one or is the .86 superior? 0.64 A/R T25 Inlet, 5-Bolt Outlet (Internal WG) w/ Actuator
@GarageAbstract 2 жыл бұрын
@@leakerror That’s it! The .64 is what we have installed on this car and it spools much quicker than the .86 version
@leakerror 2 жыл бұрын
@@GarageAbstract perfect, thanks man
@cgaige 2 жыл бұрын
Hi! Hard question, What do you recommend is the overall best exhaust/set up for the sr20/s13 platform?
@GarageAbstract 2 жыл бұрын
Exhaust setup as in from the manifold to the rear of the car? It really depends on your driving style, what sounds you like, etc.
@THESLlCK 2 жыл бұрын
@@GarageAbstract that was a wacky question lol. It's never an end-all answer really
@user-hv5ld2ve8p 2 жыл бұрын
Ff33333332234
@AdamNZ 2 жыл бұрын
Needs the mid mount manifold to get the unique sound.
@GarageAbstract 2 жыл бұрын
It has the mid mount manifold haha. The original one from Trust
@slider2828 2 жыл бұрын
Thats just overlap.... can spread out the lobes to get more mids
@that_blobeye_sti 2 жыл бұрын
I love everything about this car, the wing, the wheels, the fitment, sunroof, rhd, like bro I would sell my car so fast for this
@nyleen 8 ай бұрын
do it
@cgaige 2 жыл бұрын
18 or 19 Minerva’s in the rear?:)
@GarageAbstract 2 жыл бұрын
18’s !!
@cgaige 2 жыл бұрын
@@GarageAbstract they look perfect!! I’ve been considering going staggered for my stock body Silvia!
@GarageAbstract 2 жыл бұрын
@@cgaige Can’t beat a good staggered setup
@pawelbacik1289 2 жыл бұрын
Bro made an rotary out of SR
@wojciechgromek250 2 жыл бұрын
sounds like mu 1.9 tdi