i think you need a tank of coffee !

How get the degrees to show up as you draw?

Thank you! It's such a simple question but its so hard to find the answer online.

Na hora de fazer a boca de logo tem que respeitar a espessura da chapa do tubo por que si não a maquina a laser não consegue cortar isso.

thanks bro

big thumbs up! thank you

thanks

How do you show the angle and length while drawing?

This is all I needed. Thanks.

Amazing.

❤

Sir kindly atuo cad main karay drawing maray system pay cad/cam ni hy

your video explains a lot and I can tell you know a lot I’m trying to put together a jack shaft on a go kart I’m building my torque converter sprocket is rated for a 420 chain which is easy to find but my rear sprocket is rated for a 530 chain and I need to find a 530 sprocket which I can’t find one I’m trying to have the jack shaft with a 420 sprocket and a 530 sprocket but I also need to find the shaft along with the diameter of the shaft bore size of the sprocket a shaft with a key hole the sprockets with the same size key hole that fits the shaft and all of this mess put together makes it hard so if you can help it will be so appreciated for me

Big preesh

THANK YOU! finding this "obviuos" information online is wierdly not easy...

Thanks.

Thamk you

It's pretty lame that Inventor doesn't have a centering mate. There's so much basic functionality that it's missing that I would never recommend anyone use Inventor.

I would highly suggest that you figure a way to adjust volume. I have mine up to 100 and i can hardly hear what you are saying. I had to keep going back and listening very closely. beside that, it was pretty helpful.

Great video!

Thank you friend. May I kindly know how you created internal thread in 3d module of sw? You have done it in right way so technical drawing identifies it. When i create with thread module in 3d, drawing is not identifing.

Thank you!😀

short but bloody marvellous. Thanks

Excellent video.

RRRRRRrrrrrrrrrrrrr ZZZZZZzzzzzzzzzzzz

Thanks

Thank you very much!

Thanks I leaned some ideas!

Thanks!

Great video! Thanks for sharing!

Hey thanks for the video, really helpful. Can you tell me how to fill that spaces between the walls about the edges? Do we weld them in real life or is there any other way? I am asking because I want to make a casing for a gearbox. Also how thick you suggest the sheet must be?

Very well sir

What did you do when you paused at 1:43? I am having the same trouble to snap to a sketch from another plane

THANK YOU

really great video.

Thanks this helped me with a school assignment

If you use the hole callout command, all that information goes in automatically.

how do you turn on the view cube? (usually at the bottom left of screen)

Thank you!!!

Thanks helped a lot

good one..tnx

please did you design the box

@youtube: please, let uploaders normalize volume levels after upload.

Pretty straightforward. What's *not* as straightforward though, is having your 2" tubing notched to accept a piece of 1.5" tubing there at one end. This is very common in aircraft, where tubing of different sizes is often joined together in a fuselage structure.

merci

would it be possible to show center marks for circles/arcs in the isometric view?

awesome

Is there a chance you can make a run through of how you made each piece?

Could you make a video that shows step by step how to design each part of the jack shaft assembly? It would help me a lot with my project

Thank you,really helped!