Pretty slick

What size hardware do you use to mount the motor to the stand??

I guess it does say: outback, bleeding, air bubbles and such so it sorta is like my ass after chilli omelettes

I do something similar with those funnels each time I get the runs. I don't hardly spill a drop. My wife says thanks for not making a video about using funnels for severe diarrhea but if'n you do spray out all soiled areas with garden hose including ass. This don't even make sense to put on here.

Very strange but thank you very much sir. Watching from Jamaica 🇯🇲

Super helpful vid thx

When you back them out aren't you supposed to losen them in reverse order? Or does it matter

I work with a dude and he came from a subbie dealership and said they always just tighten like the arp bolts . 30-60-90 ft lbs ... We're gonna find out lol he would also do like 4-5 engines a week

People aren't saying what year their engine is. Where mine is a 2010 torque specs are different than these shown.

29ftlbs, 71ftlbs, back of 180deg, back off another 180deg, 7.4ftlbs, 22ftlbs, 52ftlbs, 80deg, 40deg then 40deg two middle bolts only. 10 rediculous steps.lol

Had to come back here, knew something want right. You didn't loosen 180 degrees TWICE. Also didn't tighten 90 degrees TWICE at end. Sorry.

I’m putting head studs in my EJ right now, just doing a final clean up and putting everything together. Let’s hope it’s the same process.

Is finding the timing just lining up the marks on the cams and crank gear?

Whats the torque to tide injectors on this dt466 And the torque for valve cover.

Omg I can’t ❤️ this enough!!!! You rock...I am going to let you name her...

No, no, no bad boy!

You better check the size!

The Delano car wash