Søren Balje

Пікірлер

@PompS-x7j 19 күн бұрын

Do you know the diameter of membrane?

@tobiasnoruprejnhardt9168 3 ай бұрын

Hejsa. Hvordan pokker får du tændrørene af? Jeg kan slet ikke få dem af. En 18mm tændrørsnøgle er for tyk til at komme ned i hullet som tændrøret sidder i. 16 og 17mm er for lille til tændrøret….

@MLWAM 3 ай бұрын

Jeg kan ikke huske det, men er sikker på jeg brugte en tændrørs-top, hvilket er smallere i det end de normale lange toppe

@ciupaalex9935 4 ай бұрын

how manny turns you have on air mixture screw?

@MLWAM 3 ай бұрын

1 turn and 1/4 of a turn

@paulcanindo9014 4 ай бұрын

Great job! Very helpful !

@olec7125 5 ай бұрын

I'm just watching this waiting for mine to be registered ;-; TWO WEEKS WAITING TIME

@pavlouk5186 5 ай бұрын

today I rode my new used er500 for the first time for about 15 minutes.I found that it got very hot between my legs under the saddle.is this normal?on the short maiden ride I changed first second gear and very little third.parked it until to get a diploma

@AlexanderMLarsen 7 ай бұрын

Har lige købt en fra 1999, sætter pris på dine videoer! God guide til de forskellige ting

@MLWAM 6 ай бұрын

Tillykke med købet, den skal du nok blive glad for og tak for din kommentar!

@edwardloshak 7 ай бұрын

Hello, great tutorial. Can you explain the difference between the "FV+BH, 12 V/6 W" and the "ST., 12 V/6 W"?

@MLWAM 6 ай бұрын

Sorry for the late respons. I'm not quite sure, but my guess will be the cap at the end of the light. Because the volt and wattage are the same on both of them.

@Zodiac730908 8 ай бұрын

I found if i attach carbs to the airbox first, and then slide them both in it fits much easier and quicker. Just my findings. I also attach cables before i do all that. I found that works well for me..

@MLWAM 6 ай бұрын

I'll remember that next time I have to disassemble it, thanks.

@Paul-be7yg 11 ай бұрын

That a huge part of great job!

@alexestefanesturbo Жыл бұрын

Muito bom eu comprei uma aqui no Brasil más está muito surada estou fazendo do zero a moto 😅 #ALEXSANDROR1000 🤠👍 venho agradecer a você que está na, família R1000. para quem não faz. parte da família venha que tem,Muita novidades Nunca desista dos seus sonhos Nunca abandone seus amigos Quando você más precisou eles ficaram com você

@TheKillboxer Жыл бұрын

Had this issue with my yamaha xv535 it was arcing from one of the coils

@jakobhenningsen Жыл бұрын

Hej Tak for nogle virkelig gode videoer, de rammer lige præcis det jeg har haft brug for. Du har malet cyklen kan jeg se, det ser superfedt ud. Hvilken maling har du brugt til hhv. motor og forgaffel ? /Jakob

@MLWAM Жыл бұрын

Hej Jakob Tak for din kommentar, det sætter jeg stor pris på. Jeg vil klart anbefale at bruge en 2k spraymaling til alt hvad der skal males af stel eller metal dele, som ikke bliver varme. Jeg har brug den her maling til forgaffel: picment.dk/supreme-2k-mat-sort-spray-1?gclid=Cj0KCQjwx5qoBhDyARIsAPbMagCawHiZt07lu_hfvAP4yCualOct9jkm_xme0xc15_ihI4EPzwTT3P4aAm92EALw_wcB Jeg har ikke malet min motor, men hvis du tænker maling af udstødning har jeg brugt den her: www.hcfarver.dk/autolak/autolak/spray/motip-varmefast-maling-400-ml Jeg synes dog nu her nogle år efter (motorcyklen har stået udenfor i al slags vejr, under cover) at det klart er malingen på forgaflen har holdt bedst.

@typecek281 Жыл бұрын

Great job bud! Amazing video, thanks to you I can do the job now. Much appreciated

@dejannovakovic7857 Жыл бұрын

Super planirao sam da kupim er 5 Kawasaki.

@2ride_along Жыл бұрын

Thank you !

@hugo0338 Жыл бұрын

Hello, my indicators are led, when i try to use it they make the lights to fast, how can i make the resistance low to make it well?

@MLWAM Жыл бұрын

I changed my relay, you can see it here on my instagram. instagram.com/p/CJWPU28jdt9/

@graymatter6401 Жыл бұрын

Hi can you please tell me where to get the diaphragms on there own from I can only seem to source them complete.

@MLWAM Жыл бұрын

Hello Gray Matter I think i bought them here: www.ebay.com/itm/285172968194?hash=item4265a22b02:g:rQQAAOSwVexkBmas&amdata=enc%3AAQAHAAAA4F1bOQlL5HLCOU4o7QpdC9oZvgD%2FDTTOsGtzvBO%2FjEvJcsgFC4Mct4o519zVUKTVJtnhtxAtHL17geNhxVzrlbPSi%2Ff2F5Sw4Sf%2Bl4P9ykFuk%2BlSOeO4cb5tyU8HrFv4pzgedYrJjsOguIeRab4%2BmBe3Y0IZ9k5XbI%2BaywydjjM3LN2hrHAxuvf0J2nbn1h4jy0iOOPCZcRBmlWTZi%2BCz9OnVPDxepro22Bo1%2BYhFO2JfJVXu0HM4tkLG93F2Cmh9w%2Fw%2FC1yFKrHNgnp2mB1h%2B9k%2BofAAZZ66iMfLVh2CtbG%7Ctkp%3ABFBM0ozIn-xh

@nicolaasdamigella7557 Жыл бұрын

Thank you very nice and helpful video

@TomBartram-b1c Жыл бұрын

I've two er5s and both were a nightmare with leaking carbs and fuel taps. Both sold on at a ££ loss as "projects". Grr gutted. Otherwise really good economical bikes.

@automajstorijediy Жыл бұрын

i solved fuel tap problems and fuel in engine oil for 4 euro. simple manual fuel valve instead of factory one.yes you can buy repair kit for factory fuel tap,but this is cheap and forever. open it,drive,close it and no fuel leaking in engine oil. or,if you need sophisticated system, just use electrovalve from car lpg system. its open when you turn the key,and closed when you stop the engine.

@osxar84 Жыл бұрын

I have an ER-5 from 04 and I have removed that carb probably 7 times in the last three months. Drives me insane.

@stevehufngel7221 Жыл бұрын

Hi! Where did you buy your diaphram? The ones that came with my carb rebuild kit are too small and the seller is not willing to refund me lmao Any tip would be helpful

@MLWAM Жыл бұрын

That seems weird, that they are too small? - I think i bought from here: www.ebay.com/itm/285172968194?hash=item4265a22b02:g:rQQAAOSwVexkBmas&amdata=enc%3AAQAHAAAA4F1bOQlL5HLCOU4o7QpdC9oZvgD%2FDTTOsGtzvBO%2FjEvJcsgFC4Mct4o519zVUKTVJtnhtxAtHL17geNhxVzrlbPSi%2Ff2F5Sw4Sf%2Bl4P9ykFuk%2BlSOeO4cb5tyU8HrFv4pzgedYrJjsOguIeRab4%2BmBe3Y0IZ9k5XbI%2BaywydjjM3LN2hrHAxuvf0J2nbn1h4jy0iOOPCZcRBmlWTZi%2BCz9OnVPDxepro22Bo1%2BYhFO2JfJVXu0HM4tkLG93F2Cmh9w%2Fw%2FC1yFKrHNgnp2mB1h%2B9k%2BofAAZZ66iMfLVh2CtbG%7Ctkp%3ABFBM0ozIn-xh

@brayli86 Жыл бұрын

I found 2 issues: 1. Left carburetor filling valve was overfloating, which caused mix a way to rich. Cleaning it helped nothing, and I had to bent valve support rod a little bit to close earlier. 2. My version has Secondary Air System. Here a valve membrane was ruptured, causing right carburetor sucking false air. Must have! : fuel filter, otherwise some day petcock plus carburetor together will perform a fuel dump at the midnight 😑

@migueldacruz6640 Жыл бұрын

Thanks a lot for you videos. I bought recently an old Kawasaki ER5 that needs some love and, after watching your videos, I'm planning to do it myself instead of spenting a small fortune in professional workshops. Funny thing is, the first thing I though when I bought it was to paint these parts (radiator cover and foot pegs support) in matt black, same as you

@RoobieRoo2 Жыл бұрын

amazing, thanks so much

@erman0006 Жыл бұрын

hello dear Master, i washed my kle500 with jet and then my bike's engine doest'n work. i think water went to somewhere. if i pushed the bike from top of the road, bike works very hard. where should i check? handstarter is working but engine doesn't runing. if the engine run somehow does not stop. what can ı do?

@MLWAM Жыл бұрын

I think you got water inside your airfilter and housing also your carbs. You probably needs to empty the carbs and try turning it over with fresh fuel. If your engine runs and you dont know how to stop it again you can try killing the engine by remove the sparkplugwires if they are accessible. If not try sufficate the engine by fill the exhaust with an old towel, so there won't come any exhaustgases out.

@erman0006 Жыл бұрын

@@MLWAM The last situation is as follows. My engine sometimes doesn't start, when I check from sparkplugs, there is no ignition. Is there a connection to the ignition in the ignition switch? The starter works but the ignition sometimes does not work.

@MLWAM Жыл бұрын

@@erman0006 There could potentially be something wrong with the ignitionswitch yes. I have not had mine off, so I don't know how hard is it to get to. But maybe try holding the key in the On position while cranking and wiggle the key a bit.

@erman0006 Жыл бұрын

It fixes itself when I turn the key and turn it on and off. Have you ever looked at the electrical diagram? Is the ignition connection through the ignition switch (key)?

@MLWAM Жыл бұрын

@@erman0006 No i haven't had a look at the diagram for the ignition switch og connection. Do you have the diagram? for the electrics?

@andrewphair7820 Жыл бұрын

Very helpful video I am having a problem with the same bike I've got. So bought the kit and doing the carbs just wandering the about the slow idle valves is it just the value and no o ring thanks 👍

@MLWAM Жыл бұрын

Yes, if there weren't any from the kit, or the old ones you removed, then there shouldn't be any.

@TheMartinjava Жыл бұрын

kender følelsen

@danlee807 2 жыл бұрын

Very clear very helpful got to do mine this week.

@MaximilianMaxim 2 жыл бұрын

Cool 🤙💪 kzbin.info/www/bejne/lYWYn2NpitKlmZY

@manuelhartinger4866 2 жыл бұрын

please tell me which spark plug wrench you use here exactly - i would like that too because it's just too difficult and stupid with the normal one