3 жыл бұрын
3 жыл бұрын
Пікірлер
@DrHinge 3 жыл бұрын
By doing this on my Jab3+, the amplifier turns off all sound and can not be paired on bluetooth.
@DrHinge 3 жыл бұрын
I have nothing called “VIN” on my Jab3+. On that connector, the one you program with, there is “RST” and “+5V”. If I short those, the sound is off all the time. When I release the short, it keeps turning off at low levels.
@knorz76 3 жыл бұрын
Hello Adrian, on JAB3+ use connector J5, there is pin1 "RST" and pin2 "+5V" (VIN)
@DrHinge 3 жыл бұрын
@@knorz76 That’s what I tried, that just mutes the amplifier completely and I hear a low clicking sound.
@knorz76 3 жыл бұрын
@@DrHinge Ok, i will check this on my JAB3+. But just to be sure, we are not talking about the powersaving feature after 5 minutes but about the level sensor after a few seconds?
@DrHinge 3 жыл бұрын
@@knorz76 Thank you. Correct. I can’t seem to get a reply from Wondom.
@knorz76 3 жыл бұрын
@@DrHinge kzbin.info/www/bejne/emGXaHSFqKyaftE Hello Adrian, i have bridged both pins, no problem with muting or clicking noise. I use in the video the blueetoth connection from the ipad. i had the same problem on the jab3+ in the video, for me its gone after i use my own sigmastudio project. do you have a programmer?