14 күн бұрын
14 күн бұрын
4 ай бұрын
5 ай бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
2 жыл бұрын
Пікірлер
@dlouque 9 күн бұрын
Why you didn’t make a complete pass on the tailgate instead of half? Would be better if you did that and do 50% overlap instead of spraying the way you did.
@sunburntlawnmowermechanic16 9 күн бұрын
I need to do another coat I will do complete passes the next time I was just trying to get it in primer normally I do a 50% over lap but the gun was not working right I couldn’t get the fan set were I wanted it
@WindRider1 9 күн бұрын
Let your first coat flash, then put your wet coat on. Set your fluid wide open. You do that with the air disconnected.
@sunburntlawnmowermechanic16 9 күн бұрын
Normally I do the first coat a little lighter but is was really cold In the shop and it takes about a hour to flash off
@cooki3cutt3r13 10 күн бұрын
what is the coldest temp you apply filler?, for me is applying filler at 41F panel temp cause im concerned about it curring probably but I've heard you can just mix it hotter.(adding more hardener.)
@sunburntlawnmowermechanic16 9 күн бұрын
I agree with you about the temp for me it seems to stick better win the panel is warm but the reason people add more hardener is because they say it makes it dry faster in colder temps I don’t add more than recommended I just wait a little longer for it to dry
@sunburntlawnmowermechanic16 9 күн бұрын
Normally I would use a heater and warm up the panels before hand
@cooki3cutt3r13 9 күн бұрын
@@sunburntlawnmowermechanic16 yea, that definitely makes sense. ive been using a heat gun if need be but a heater would definitely be better
@jraposo911 11 күн бұрын
put a mask on buddy
@sunburntlawnmowermechanic16 9 күн бұрын
Normally I do were a mask and have fans running but the one I have it is hard to hear me talk in
@BlazingTurbine 22 күн бұрын
Yeehaw
@benkuehnle4071 4 ай бұрын
Thanks for sharing this!
@sunburntlawnmowermechanic16 9 күн бұрын
Your welcome there should be more videos coming on the mower I just ain’t got time to work on it lately
@BluezzytYT 4 ай бұрын
What's up