I didn't understand what an unscrewable barrel was Can you tell me in more detail?

@@kevindb2911 Like threaded to add custom flash hiders or tracer units.

cults3d.com/en/3d-model/game/tokyo-marui-mws-based-ar-10-sr-25-dmr My favorite

The question is too broad to answer. I'm not sure if it means that what you created can't be printed or that it can't be implemented. I don't know if this is a tip, but you should simplify the driving part as much as possible and always remember that it is plastic. You will never succeed by taking the design or structure of a real gun. The structure must be redesigned specifically for 3D printing.

cults3d.com/en/users/kevindb/3d-models When most of my work is finished, I post it here.

@@kevindb2911 Thanks, looking forward to it

No I will never make a gas magazine by printing. I have no intention of using higher pressure gas than green gas. Production is not over There are still some parts I don't like.

This uses the original TM MWS GBBR short magazine in the green gas version.

In order to make a magazine catch to fix the magazine, I had to make a new magazine, but since there is a very high risk of explosion due to gas pressure when printing the entire magazine, I made it this way to use the existing GBBR magazine as a gas tank.

@@kevindb2911 Ah I understand, smart

cults3d.com/en/users/kevindb/3d-models When most of my work is finished, I post it here.

I'll think about it It's not that I don't want to reveal it, but I'm not sure how to film it.

well...

The reference model is DVL-10M1 SABOTEUR. The exterior was created using the specifications of the real thing, and the driving part is a creation.

The modeled gun is the DVL-10M1 Saboteur, and it features an integrated silencer barrel. The outer barrel is complete as is.

I think that's the case since I used the MWS magazine and hop-up unit.

Structurally, an airsoft magazine and hop-up unit must be added to make it an operable gun, so it seems to sufficiently fulfill the function of the model without including these parts.

It uses a short magazine for TM MWS rather than a CO2 magazine, and the power source is green gas. If you are curious about the structure, I recommend searching for KJW M700. It was produced by appropriately mixing the structure of KJW M700 and general GBBR.

I'm not sure I just refined it until it looked the way I wanted, and it ended up like this.

@@kevindb2911how many hours do you think you have in cad?

@ I think it's been about 4 years

This modeling was created to test the gimmick of using a pistol magazine on an AR platform, so sadly I did not plan to make the file public. Since you are interested, I will edit the file.

I don't have a way to measure it right now, so I guess I'll have to wait a little longer.

@kevindb2911 oh ok, but how many layers of paper

It is difficult to say exactly how much filament was used because it varies depending on the printing settings. Excluding the failed output, I think there were about 3 rolls.

I'm not sure I think I'll just have to make the structure where the stock folds, but this will take a while.

I haven't tested it externally, so I'm not sure about bullet speed or range yet. I'm planning to finish the file by mid-February at the earliest.

@@kevindb2911 you need a manual for the rifle?

The structure itself refers to the Remington M700 and M200 Intervention.

Thank you for your interest kzbin.info/www/bejne/fIfRapmfqJKpd7s The shooting test has been completed and the internal dimensions are being adjusted.