I can, it depends on the requirements

What is PMC?

You might be talking about the PZV, pressure relief valve- selection of PZV ACTUALLY selecting the spring range of the valve, the more higher rated PZV shall have more stronger spring- so for lower rating if you use higher capacity PZV, it might not pop or release pressure at low range. Hydrotest pressure should fall under 30 to 80% of the pressure gauge range. For example, with a 1000 psi gauge you can deal a hydrotest range of 300 to 800 psi.

You might be talking about the PZV, pressure relief valve- selection of PZV ACTUALLY selecting the spring range of the valve, the more higher rated PZV shall have more stronger spring- so for lower rating if you use higher capacity PZV, it might not pop or release pressure at low range. Hydrotest pressure should fall under 30 to 80% of the pressure gauge range. For example, with a 1000 psi gauge you can deal a hydrotest range of 300 to 800 psi.i will try to make one video about the punch lists

I will try to make one small video to explain this feature of the valve

Thanks a lot

Thanks! I will try to create a video about QC documents preparation.

Aure, Please allow me some time

Thank you dear for your kind comments, can you please elaborate what type of report you are asking. For quality all the required formats are either part of the quality plan or it is being supplied by your client

@soumendey1331 Sir When we perform qualified welder test after that all qualified welder will do job of fabrication at site ! So such type of report or documentation we have to prepare at that time ! Using isometric drawing We prepare document like 1) Weld visual report 2) Fit up report 3) NDT report 4) Hydrotest Report (if hydrotest) 5) Structural Painting & Coating Report This all reports submitted to client for sign on daily work report!

These all are quality report! There are lot of reports how to identify the joint and how many joint and how to give joint number like this !

What is PIM?

Ok, you mean Pre inspection meeting. This meeting is basically a communication meeting where contractor, client and vendor meet together to finalize the inspection and test plan. They negotiate to decide the witness, surveillance and hold points

Thank you sir ​@@soumendey1331

very good. You are key person for a pipeline construction

PIpeline can be 2 inch to 60inch or more based on the requirements. Service can be utility, gas, crude oil, Raw or refined products, Drinking water, Sea water, Fire fighting or potable water. Where we need a continuous transportation of any liquid or gases over the country and under the sea, pipeline is a kind of permanent solution- can run long years.

most of the standards can be available open sources, start with the standards that is relevant field you are working- for an easy understanding.

Thank you! Please follow my channel for updates.

Thank you, I will

thanks for the inspiration

Thank you for watching!

I do not use any fixed PPT, most of them I speak from my experience.

Thanks for your kind words. Glad you found the video helpful!

If pipes are internally coated, No checmicals need to be used. You know, all pipelines carrying Sea water are internally coated, So we can use Sea water as a test medium which are full of salts and other chemicals, Because Pipeline internal will be protected by the coating. For pipelines without any coating inside has to be protected from corrosion, and to stop building any Sulphate reducing bacteria- which are promoting more corrosion to the steel.

@@OilandGas-inspection-soumen Wow you just taght me so much in like 3 min... please make youtube channel about this. You are amazing. wow over time you would think it breaks down. that's so cool. i didn't even know about sulfate bacteria.