Which mode do you use for the hover test? FBWA or QLOITER or QSTABILIZE?

Good day, could you say, QRTL mode, before landing, will switch on automatically? and from what distance from home point?

Nice info

Hi Sir. You've done a good job. Congratulations. I've been working on these VTOL things. Could you share the flight plan of this flight if it is possible? Thank you. I wish you good work.

Tertarik model yg ini, harganya kisaran berapa...?

What happens if you charge lipo battery on semisolid?

20 pk ada pak... ??

Hi on mine the percentage will stay at 99% for a long time ! Do you have the same ?

Berapa hp dan rpm nya pa

Berapah.harga nya os

Sy minat yg 10 hp dmn bs dbeli & hrg brapa??

Dmn mesin yanmar ini bs dbeli om??

Thank you for the video Mr. Keeyen. I noticed it's Ctrl + F for the Special Menu to appear. 😃👍

Kalow mau beli pesan di mana bang

Bos belinya dimana? Ya minta tolong yaa kirim nomor WA nya yang jual makasih

Nice job, you have very good results under 12 sat and 0.9 hdop, no gps drift ! really amazing.

Could you write down more information ?, please

Agrostar pb 300...tramisinya tak sakut kalau di masukkan.apa masalah

Agrostar pb 300...tramisinya tak sakut kalau di masukkan.apa masalah

Harga berapa bos

Hi good job, did you need to use a wheel encoder to make the auto mode working?

Kalau l90 kapasitas oli berapa ltr yah..

Belinya dimana om? Boleh minta no.wa nya om?

24 pk brapa harga nya boss

Hrg mesinx brapa bos

Untuk yg 10Hp berapa harganya

$$$

How much?

Why dont you use 4 servos to tilt the motors and use them for forward motion

Bao nhiêu hp vậy bạn.

mantap om.. berapa harganya 🙏🙏

Pak untuk mesin ini ada manual book ?

Bisa kasih contoh kelistrikan untuk dinamo starter nya pak,soalnya saya punya sdh trbongkar tidak tau dari aslinya bagai mana🙏

Fantastic demo. Well done.

The arc of the turn is beautiful, but why is there no current displayed?

Very impressive!

Maybe you can try our VTOL.

good job.

Boss . Kenapa beltin yaa slalu putus.? Cara menjaga beltin cam mana?

I have the same problem. It was always fine but after I haven't flown like 2 years or so I noticed the same behavior but I didn't pay attention and today I had a bad luck in the air so now my plane is crashed. Do you have any progress on solving this problem?

Hi All - I just can't get my motor to start in auto mode. I can fly in manual but in Auto mode throttle shuts off. I can't do a pretend throw to get the motor to start. I've adjusted all the parameters for hand launch but still no go. Can some one please help. Thank you :) Rob

Hi friend, I'm Brazilian and I'm building a skywalker x8, I liked the result you got (diydrones.com/profiles/blogs/100km-challenge?id=705844%3ABlogPost%3A1656588&page=2#comments). I already got the skywalker x8, two lipo 6s 5500mA (60c) and a Red Brick ESC (100a). I also have the dragonlink v2, radio th9x. I'm looking for a good engine and a good propeller. I'm setting him up for mapping studies in my doctorate, intending to board a nikon and a lidar-lite (rangefinder). Could you help me set a good engine and propeller? They must support a total weight of approximately 4kg and have an autonomy of approximately 50min... Hugs, Leandro

Thanks for sharing friend!

tq

What are your parameters ?=

Can you tell me how much deflection you have on your flaps?

Is that a phantom 4?

Thanks for the video! Very helpful! May I ask what receiver you're using with your T8J to connect to the Pixhawk? I'm assuming you're using an S.BUS connection? Do you have a tutorial video on how to set up your T8J with the Pixhawk flight controller? I realize that's a lot of questions but I have a very similar set up and facing problems getting it to work. Before this I've been using the T8J+R2008SB with a Naza-M lite FC. Thanks for any info you can share!

Having those flaps makes landing such a breeze!!