That’s too quick and easy. Do you realize if you made a detailed process video, how many views you gonna get? This can be actually so helpful
@MyAirbags17 сағат бұрын
Thanks for the feedback. We made a detailed video here: kzbin.info/www/bejne/eIaUc5luhZdld6M
@kidproduction672016 сағат бұрын
@@MyAirbags thanks
@adolg40493 күн бұрын
I swap mk6 steering wheel into mk4 golf but new mk6 doesnt fit into connect at Clock spring mk4 do u have info so i can depin andd reuse old connector ?
@SakibAhsanTamim3 күн бұрын
Hello, " MyAirbags" How are you?? Hope you are well, recently I have looked to your channel. And saw that in your channel have many many problems, for this reason channel videos not getting much engagements. Not growing, If you can solve these problems, channel will grow, You want to know these main main problems??? I can tell if you want to know. here or in email!! Where?????
@StefHD-z7d5 күн бұрын
Existe en jaune ? Merci
@EricArmagost5 күн бұрын
i just want to pet your pair
@EdgarJaimes-l2z6 күн бұрын
Do you know if the airbag module is the same for civic 2014 and 2015?
@Deathfromamile6 күн бұрын
How about showing the install.....
@SamSonnyPan6 күн бұрын
Thank you !
@SamSonnyPan6 күн бұрын
Never seen anything like this! So dope
@SamSonnyPan6 күн бұрын
Thanks. Needed this
@charliediaz90546 күн бұрын
I changed my steering wheel airbag Do I need to program it to my car?
@chrisdedavid186012 күн бұрын
damn, how did you remove the cover at the top.... what car is this?
@MyAirbags7 күн бұрын
This was on a Lexus
@Ilikewater4313 күн бұрын
Thanks for the help!!!
@MyAirbags7 күн бұрын
Happy to help!
@Ilikewater4313 күн бұрын
Do you know where I can get red seatbelts with a checkered pattern?
@MyAirbags7 күн бұрын
We will soon start printing any custom design you want.
@trybc313 күн бұрын
I have a 2014 Chevy Malibu and my rear seatbelt on the drivers side is stuck. It will release a little bit but it took 15+ minutes of pulling it in and out for us to be able to buckle someone up.
@MyAirbags7 күн бұрын
It may need to be replaced or repaired. Check out myairbags.com for repair and replacements.
@cosmichappening171215 күн бұрын
Thanks champ...
@MyAirbags7 күн бұрын
You bet!
@roboslide18 күн бұрын
I just used two tiny flat screwdrivers to remove the connectors, it took like a minute. Once I had the nuts and scew out.
@MyAirbags7 күн бұрын
Great job 👏
@amongusmarkII20 күн бұрын
Having issues with a 2019 mazda 3 seatbelt, it wont retract and ive taken it all apart and cant figure out whats wrong
@MyAirbags7 күн бұрын
It could be faulty internal components. Check out info.myairbags.com/kb
@Arod-d1p20 күн бұрын
Hi there, this video was very helpful, however im skeptical because Im not sure how I would install the module without messing something up. Do you guys have a video for that as well?
@MyAirbags7 күн бұрын
Yes check out myairbags.com or info.myairbags.com/kb
@MohamedMohamed-ej2rz21 күн бұрын
2015 Nissan Altima 2 airbags come out then I changed 2 airbags but airbag light on dashboard pls reply me
@Arod-d1p20 күн бұрын
you replaced the airbags which is good. But did you also replace the module?
@MyAirbags7 күн бұрын
Yes, the airbag control module needs to be reset, and most likely seat belts need to be repaired. Check out info.myairbags.com/kb
@MohamedMohamed-ej2rz22 күн бұрын
My Nissan Altima 2015 airbags came out Then I changed 2 New airbags but airbag light didn't go
@MyAirbags22 күн бұрын
The airbag control module needs to be reset after the vehicle was in an accident. Also check the seat belts as they could be bad as well. MyAirbags does reset airbag control module and rebuilds seat belts. Checkout myairbags.com
@Shdwcst4823 күн бұрын
Short and to the point… great video!
@MyAirbags23 күн бұрын
Thanks for your feedback 😀
@NOJOOMFM24 күн бұрын
Hi, i have a question, my airbag light will come on after driving the car for almost 30 minutes and it goes away only when i restart the car then it will come again, Elantra 2021.
@MyAirbags7 күн бұрын
Was your vehicle in an accident?
@user-xt6uq5bu8f26 күн бұрын
THANKS 🎉
@MyAirbags25 күн бұрын
No problem!!
@tanikawilson870827 күн бұрын
I need your service. I have a 2014 Honda Civic Coupe that needs front driver and passenger fixed. New Airbag in still seeing the symbol
@MyAirbags26 күн бұрын
Yes, we can take care of that for you and save you a lot of money. Please check out myairbags.com and let us know if you have any questions. Thank you!
@frankflex4465Ай бұрын
should i disconnect the battery cables while taking out the sensor
@MyAirbagsАй бұрын
No, it is not necessary
@Sam-sd6qyАй бұрын
Thanks heaps for your video
@MyAirbagsАй бұрын
Happy to help
@brunopereira5087Ай бұрын
Hey, how do you get the headrest back in the original position?
@MyAirbagsАй бұрын
We will need to make a new video regarding that.
@jeffflowers729Ай бұрын
I have a 2005 town car. My air bag light sometimes flashes 33 for driver sometimes 34 for passenger. I only tested driver side to start. I am able to fully remove the shorting clip. My ohm meter shows a 1 in standby and. It still shows a 1 when testing which means a bad tensioner. But I used a 2ohm resister to bypass as a test and my air bag light continues to flash. So do I have more than one issue?
@MyAirbagsАй бұрын
The resistance needs to be between 2 to 3 OHMs for a good seat belt. Your seat belt is bad and needs to be replaced or repaired. Are you using 2 ohm or 2k ohms. Needs to be 2 ohms.
@jeffflowers729Ай бұрын
I have a 2005 town car. Using my ohm meter, it stays at 1. I fully removed the the shorting bar to be sure. But then I used a 2 ohm resister as a bypass test and the air bag light was still on. Sometimes flashes 33 sometimes 34.
@MyAirbagsАй бұрын
The resistance needs to be between 2 to 3 OHMs for a good seat belt. Your seat belt is bad and needs to be replaced or repaired. Are you using 2 ohm or 2k ohms. Needs to be 2 ohms.
@jeffflowers729Ай бұрын
@@MyAirbags the lowest setting on my meter is 200. I just tried the passenger side and neither one has resistance. My codes are 33 and 34 which is both sides. They both went out at the same time? Or is it the air bag control module?
@MyAirbagsАй бұрын
@@jeffflowers729 it sounds like the seat belts. You can also use your scanner to see what the resistance is on the seat belts.
@jeffflowers72929 күн бұрын
@@MyAirbags both of them? where would I test that? I found the code is 2292
@MyAirbags29 күн бұрын
@@jeffflowers729 yeah that is hard to imagine that both went out at the same time. But if the ohm reading is not between 2 - 3 ohms then it is a bad seat belt.
@frankflex4465Ай бұрын
can the vehicle be driven with the sensor out while waiting to get the refurbished sensor back
@MyAirbagsАй бұрын
yes the vehicle will still run & drive without that sensor
@sandrabrewster5241Ай бұрын
I have a 2014 lexus Rx350 My air bag light came on after my daughter was pouncing around in the passenger seat. Got a diagnosis code B1650. she did have on a seat belt. unable to clear code. what should I do next
@MyAirbagsАй бұрын
It is bad passenger occupant weight sensor. May need to have your passenger seat calibrated or have the seat replaced.
@frankflex4465Ай бұрын
can i remove the sensor in truck without taking out the whole clumn
@MyAirbagsАй бұрын
Yes, there are usually a few screws that hold that sensor in place. Just remove those screws and get the sensor out.
@oponoponomeditationАй бұрын
Can you, please, make a video on how to release a mazda3 2018 seat belt pretensionner?
@MyAirbagsАй бұрын
Was your mazda 3 in an accident/collision or you hit something on the road?
@oponoponomeditationАй бұрын
@@MyAirbags accident
@vitaly15Ай бұрын
@oponoponomeditation there are different style of seat belts. In most there are gears that lock up and need to be replaced. Also, there is a pyro sensor that needs to be replaced. That pyro sensor will keep the airbag light if not changed.
@kurticusmaximusАй бұрын
Saving me money. Thanks.
@MyAirbagsАй бұрын
Happy to help!
@kennylamintao4948Ай бұрын
Is it necessary to unplug the battery before doing this just to avoid the airbag blowout?
@MyAirbagsАй бұрын
It is not necessary, but it is what manufacturers recommend. Also make sure the control module is bolted down with all bolts and the harness plugs are connected before turning ignition on. If not, it will blow side/roof airbags and seat belts.
@Shan-ki7hzАй бұрын
Same for 2011 versa? Thank you
@MyAirbagsАй бұрын
Yes very similar
@michaeldepaola910Ай бұрын
Thanks for this video! I need to replace a seat belt in 2009 Honda Civic for physical damage to the belt (it's frayed). If I disconnect the battery before disassembly, will I have any issues with the new (OEM) belt?
@MyAirbagsАй бұрын
Yes, you can send your frayed seat belt, and we can change the seat belt webbing. No, you will not have any issues with the new OEM belt.
@ashleyortiz3567Ай бұрын
What kind of tools are needed for this removal? Also If the error code says open or increase resistance in the drivers seat belt tensioner /open or increase resistance in the front passengers seat belt tensioner ….what do I have to send for repair?
@MyAirbagsАй бұрын
Yes, both seat belts are bad. Yes, we can rebuild them. You will need a ratchet set and a flat head screwdriver. Visit myairbags.com for more info.
@kosetАй бұрын
Dude, you are a life saver. It’s exactly the instructions I needed. Cheers.
@MyAirbagsАй бұрын
Your welcome!
@superjavi9820Ай бұрын
It throws the wrench light if you try and remove for weigh reduction
@MyAirbagsАй бұрын
Are you getting any codes?
@superjavi9820Ай бұрын
@@MyAirbags yeah unknown dtc and wrench light might be cause I unplugged with battery connected but I put it back
@patdennison4508Ай бұрын
Thanks, saved me hundreds just to do that. £230 for belt and £60 for fitting. I paid £27 for belt, fitted it myself after watching this. Fantastic!
@MyAirbagsАй бұрын
Glad it helped
@rahulvenkateshkannan2603Ай бұрын
There are two ports in the seat belt unit. Which one to test?
@MyAirbagsАй бұрын
The one that connects to the pyro sensor side. Usually looks like a tube.
@user-qw2ui4sh5lАй бұрын
Beautiful woman
@MyAirbagsАй бұрын
Thank you kindly
@JaySprayReloadedАй бұрын
That’s cool but how do You properly repair it what is causing it to do That
@MyAirbagsАй бұрын
That is a good question. Not sure what the answer regarding on what causes the shifter to fail.
@straightfifty4202Ай бұрын
Tip to all, Remove module screws, then disconnect the module from passenger side. You will likely break one of the clips for centre console but it'll still line up decent and not rattle
@MyAirbagsАй бұрын
Thank you for tip! Much appreciated!
@janets7288Ай бұрын
where do we order :)
@MyAirbagsАй бұрын
Visit myairbags.com
@terrymckinley3037Ай бұрын
You sold me😀
@zwigeorgali7470Ай бұрын
I don't understand exactly what are you doing i have a toyota yaris and the belts doing the same thing how can i fix it?
@MyAirbagsАй бұрын
This just shows that the seat belt will work, retract, pull out in a certain position (how it is installed in the vehicle)