21 күн бұрын
2 ай бұрын
2 ай бұрын
2 ай бұрын
3 ай бұрын
3 ай бұрын
4 ай бұрын
5 ай бұрын
5 ай бұрын
5 ай бұрын
6 ай бұрын
7 ай бұрын
7 ай бұрын
7 ай бұрын
7 ай бұрын
8 ай бұрын
Жыл бұрын
Жыл бұрын
Пікірлер
@elisargent452 5 сағат бұрын
That “vent stack” says the gas needs to stay off
@WST77 7 сағат бұрын
T&P Valve plumbed incorrectly
@StevenDieter-fc8gh Күн бұрын
Yeah you made it simple thanks
@falgosh5956 Күн бұрын
Not to your camera person, please. Quit moving the camera around so quickly; it makes it hard to see and follow.
@goose92537 2 күн бұрын
Everything about this would fail inspection in NY. Sloppy hack work at its finest. 👎 Do better.
@bobsoft 3 күн бұрын
38:17 The gas line kit I bought at Home Depot says no pipe dope on the flared fittings side as well as a few other kits say "DO NOT apply grease, oil, sealant, or tape to flare ends of fitting or shut-off valve. Sealant and tape will prevent this connection from sealing properly"
@aidenton6490 3 күн бұрын
Thank you mark Roger for this info
@oforirichard2268 4 күн бұрын
Good work master 🤝
@loganprion5535 5 күн бұрын
Hack plumbing
@John-NeverStopLearning 5 күн бұрын
Who picked this guy for this video??? He says “Hot Water Heater “!!! He’s a n Id… Who wants to heat HOT WATER?? It’s a Water Heater!!! He’s NO plumber. Look how clean his hands are. No wonder the terminology is wrong.
@hardnoxgrad5763 5 күн бұрын
First I always put a big towel on the cabinet floor before I get started…..so I do not put any scratches on the customers cabinets and not let any water get into cabinet joints. The customer will appreciate it when a worker is considerate and respects the homeowners property.
@dalehart7238 5 күн бұрын
It surprises me that these are still being installed in the US. This design is very similar to an old Andrews water heater in the UK but they are incredibly inefficient compared to modern appliances. What's the efficiency on these things in the US?
@skinlab4239 4 күн бұрын
What do you use?
@dalehart7238 4 күн бұрын
@@skinlab4239 in a domestic setting, the closest thing to this system would be an unvented (pressurised cylinder), heated by a condensing boiler. In the UK, any newly installed system has to reach a minimum of 92% efficiency. I get that the heater in this video is an all in one unit and saves some space but the heat loss must be quite high if it operates like I think it does. Is there some additional form of heat recovery placed on the flue?
@josejuan1264 5 күн бұрын
I have them at home and I don't recommend the they spin easily and make your plumbing work move around after installation
@EM-fi2qg 6 күн бұрын
0:42 It's just a water heater.
@therockbabyben 6 күн бұрын
So this is what my dad whatches?
@davidwolf8861 6 күн бұрын
NOT A HOT WATER HEATER!!! ITS A WATER HEATER OR HOT WATER MAKER.
@rjb6327 6 күн бұрын
If only it was that quick and easy. Try it in a utility closet.
@bigfamilyginusa9454 6 күн бұрын
Bro, why is everybody Doing comments😂😂😂 this is just a ad
@gema7777 7 күн бұрын
KZbin is doing some funky stuff in the past 2 days. I didn’t click on this it took me here mid video. 😡
@BillyFrench2 7 күн бұрын
Most people would say every single one of them should be fired and you know what that's common sense and real life
@davidrosen4951 8 күн бұрын
The music makes it harder to follow your video. Music is good at the start but not when you're talking.
@justchillin_moai 8 күн бұрын
I’m watching tin foil balls, not this
@MrKYT-gb8gs 8 күн бұрын
Turn down the music. Can't hear shit.
@jdigity72 9 күн бұрын
Yes, but who’s your dentist?
@RARufus 9 күн бұрын
Was watching Garand Thumb and accidentally clicked! 😂
@nolahorserider 10 күн бұрын
Great video. I’m saving it to watch it again. Thank you. ❤
@basedlogic 10 күн бұрын
Don't forget to remove the Teflon tape that's on the stub out.
@Rbee-nz1ij 10 күн бұрын
Just take out the water-saving device.
@redstonetek4718 11 күн бұрын
Could just put painters paint around it before using whatever tool you have available, too! There are no scratches, and you dont have to be picky on your tools if limited
@bobstew1862 11 күн бұрын
Man this is a plumbing working with a Ron White voice over 🤣
@free2beme773 11 күн бұрын
With that nice house, an escutcheon for the drain pipe hole would make it look nicer. Strange they did it for the water pipes but not the drain pipe.
@free2beme773 11 күн бұрын
I use a paper towel to check for leaks. Best to use a brown napkin because water really shows up on it.
@free2beme773 11 күн бұрын
I was shocked that you let the water flow out into the cabinet. 😢 Maybe the cabinet is made of waterproof material? I would be horrified by that. And, it could have been nasty if the trap was filled.
@Kodikat2 12 күн бұрын
Why were the shutoff valves replaced? Do they have a timeline for replacement.
@free2beme773 11 күн бұрын
Not sure why those needed replaced unless they were causing a problem or they simply wanted a different type. But, typically, they last about 10-15 years. If there is nard water, they might not last but a couple years. They can get corroded or stuck open. Best to replace them before that happens. Also, good idea to turn them on and off once in awhile to keep them loose.
@free2beme773 11 күн бұрын
This is a SharkBite company. He replaced the stop valves to highlight a SharkBite product, the SharkBite Max. It’s at the end of the video and he provides a link. Strange he didn’t explain how they are better or really talk about them.
@zzo6chrome 12 күн бұрын
I didn’t even misclick I just somehow got here
@megahornballssniffershitpost 12 күн бұрын
210th like and 20th comment
@ajk374 12 күн бұрын
Guaranteed even those pliers marred that shower head.
@ryan-bq9ds 14 күн бұрын
Why is this an ad
@Uptown212HVAC 14 күн бұрын
I use a reciprocating saw to remove them and replace them with copper as should have been done from the beginning
@MattHolstein 14 күн бұрын
Man, Mark Rober's gone down hill fast since the loss on Mr. Beast's video.
@stevem1081 15 күн бұрын
I don't believe the washer goes on the threaded part on the pan drain. The de-burr tool was also used to mark the insertion depth, but I guess the newer fittings need to be deeper?
@stevem1081 15 күн бұрын
I installed a pressure regulator on a house with 125psi incoming. I installed a spigot just before the regulator just for filling the pool.
@everythingacoustic6736 15 күн бұрын
Solid
@WT-Sherman 15 күн бұрын
Wish I had such easy access to my plumbing. Only crawl spaces in SW Washington. Nasty.
@Psylinguist 16 күн бұрын
1. music is annoying and agreessive, 2. how to replace the installed sharkbiyte if it is close to the wall?
@connorporeider9631 16 күн бұрын
Shark bites suck
@NoName-lu1tt 17 күн бұрын
Great video why do some some plumber hate on sharkbite inside walls? Is there any downside to using shark bites over regular pex connectors?
@joelalmon3088 19 күн бұрын
big deal
@ricklee827 19 күн бұрын
If you were a plumber or if you want to be a plumber there was important information
@alt7244 20 күн бұрын
Run a smear of never sieze on the threads for the lock collar. Ive replaced many, many whole shower bodies because maintenance twists the body trying to get the collars off to change cartridge or the collars just dont come off.
@johnbrzenksforearm8295 19 күн бұрын
Plumber's grease will do the same thing.
@officialtopgorilla 20 күн бұрын
i misclicked 😭😭😭