Well done Django. I thought you were going to loose your sunglasses Miss Loo x
@RussTNails-fw9ds Жыл бұрын
Thanks very interesting, will keep this in mind for future on mine.😊
@RussTNails-fw9ds Жыл бұрын
Thanks for your show very good ,what brand of knoby tyres have you put on your bike?
@RussTNails-fw9ds Жыл бұрын
What brand of knobby tyres did you put on it?
@Bir_Singh Жыл бұрын
How is the bike and how many km's u have got on it
@sennahandaya4920 Жыл бұрын
Thank you Stephen! Really helped me with my F1000!
@81naji Жыл бұрын
thanks for the video, can you please write the model name of the original pads, you mentioned at 2:52. Also which winter tires model should i buy for the bike thanks again
@jahangir2515 Жыл бұрын
✌️✌️✌️🇧🇩🇧🇩🇧🇩🇧🇩😍😍🙋♂️🙋♂️🙋♂️
@kallumaster4536 Жыл бұрын
Aap ka mobail namber do
@gabrielepeli9781 Жыл бұрын
Ok ,perfetto
@NamasTim Жыл бұрын
Do you also ride in rain? Did you modify the two cable holes at the control unit below the crank?
@040501ab Жыл бұрын
Hi Stephen, when you replace the street tire with Kenda 20 x 4 knobbies tires do you need to do any modification, or does the tire just fit in right away?
@stephenstokes3271 Жыл бұрын
Gday, The knobby tyres fit no mods, but you must not exceed 30psi pressure of the tread will rub on the screws that mount the mudguards. Thks
@zentman012 жыл бұрын
No problems?
@stephenstokes32712 жыл бұрын
No problems, I love the lower gearing for going through mud and slippery grass. I couldn’t go where I do without the knobby tyres. I have recently added mudguard extensions front & rear, to stop the bike and my legs from getting splashed with mud & dirty water.
@zentman012 жыл бұрын
@@stephenstokes3271 Thanks for the reply. I read the derailleur was sub par so I was concerned. I just took it for a 20 minute ride and though the volt reading on the C7 display changed as I rode the battery icon remained at full. I'm in the US btw.
@stephenstokes32712 жыл бұрын
@@zentman01 All I can say is that my bike has done lots of work over the last year in really dirty conditions. I clean the chain and lubricate with RP7 spray ( not grease ) , the gear changes are smooth and have not caused any missed gear changes. I only use P1 assist, as I can pedal with the 38 chainring rather than rely on just power from the ebike.
@suzsto68852 жыл бұрын
Good job x
@stephenstokes32712 жыл бұрын
thks
@Boppa19642 жыл бұрын
Hi Stephen what is the brand of the basket you have on your bike. I’m looking for one for out et f1000. Cheers
@ahmedeid74452 жыл бұрын
I have das kit C7 with my ebike f720 if i buy das kit c6 it work with my ebike
@stephenstokes32712 жыл бұрын
Not sure
@maudedianemarie6092 жыл бұрын
7h276 vum.fyi
@a04j05barros3 жыл бұрын
What tire you have on your F1000? Also do you have access on ECO mode?
@stephenstokes32713 жыл бұрын
Gday, I fitted Kenda 20x4 Knobby tyres in lieu of the standard 'street' tread fitted as original equipment. There are many tracks with wet , muddy , slippery grass and gravel in my area , so I feel much safer on the knobby tyres. You do need to alter some of the screw lengths in the mudguard mounts, as the new tyres are a tight fit. Also do not exceed the 30psi pressures or the tyres will rub inside the guards. I have not used Eco mode, so cannot give you any reply on that. regards Steve
@040501ab3 жыл бұрын
@@stephenstokes3271 Hi Steve, what changes have you made to accommodate the Kenda knobby tires?
@stephenstokes32712 жыл бұрын
@@040501ab gday The guard clearance is really tight , so you may need to release the back guard brace from the original position and modify how it is mounted. Tyre pressure becomes critical. Over inflation will cause the tyre to rub.
@stephenstokes32712 жыл бұрын
@@040501ab gday I just did a gear change. I replaced the 52t chainring with a 38t, wow what a difference it makes to the bike. Chk the latest video.