Mine won’t go to the next option after Bluetooth device to pair.

This video saved my bacon this morning. Thanks for going to the trouble of posting it.

Nice mine was stuck in high position. Was able to lower it and now full range of motion back

Just get question I have 2002 Yamaha jet boat .when I turned on out of the water you can feel the double engine are string . But when it's in the water and I push on the gas you feel the boat sinking from the back with no power .the the engine turned off . You think the engine no good or the impeller? Thanks for your support

Excellant video and walk through. I was able to remove the tow rope that got wrap within my impeller housing with no other way out. Thank you!

Thank you 🎉🎉

The seats are trash. So are the rod boxes with bent tubes. The cooler was designed to NOT keep drinks cold. Or drain. I hate mine. Do you want to buy it back. You brag about this boat. You run it. With all the leaks. Swamp boxes. And seats that will never dry out. BASS TRASH is a better name.

possibly the most helpful video I have ever seen, not just because it applies to me but well done and explained without a bunch of extra nonsense. ppl should watch this before trying to make instructional videos on any topic.

Great Help. Blew fuse in motor. Needed to lower to open storage and get spare. Lifesaver

Very good help thank you

Any tips on a replacement for the IDIOT (that's me) that unscrewed it to far and dropped it in the lake. I have no idea wat it even looks like.

Nothing funner than being tethered to my kill switch on my 20ft ski boat. Eff that.

They better have a valid reason for detaining you in the first place. The U.S. Constitution doesn't stop at the shoreline.

Thank you so much.

So do you leave it in the live well and the lines all winter?

Thanks to the video went much faster than expected. Except for seating the gromet that the wires pass through under the cowling. Is there a trick? Took me 45mins and sore fingers trying to reseat the gromet correctly.

RIght on great video - so you dont have to run antifreeze into the motor as you do with inboard/outboard motors?

Useless video, doesn't show how to do it.

Stupid question but - does the boat need to be in the water to do this?

Great tip. Took longer to get on the waders than to get the outboard to drop from the stuck raised position. The outboard dropped all the way down, but then the power lift worked to raise it to proper operating levels. Big help!

These boats are shit, Tracker quality...lol

Got a 2022 exact boat. Had it 1 year 2 months. 2 weeks after I bought it wheel berings came out of it. 2 months later ignition switch went bad. Now I'm in the shop again ecu gone out on it. All this in a year and 2 months. I'm selling the peice of shit. And buy a skeeter. The carpet looks like a 6 year old put in in too. It's ridiculous.

I have to say that personally if I need to top off my batteries, I have a 2007 club car precedent that has a 48 volt system, I am using 4 12 Volt Volt deep cycle marine flooded acid batteries and they work awesome pennies on the dollar for Trojan batteries. I Only Use Distilled Water! When you do not use distilled water, anything that is in the potable water you are using will leave containers and deposits on the plates inside of the battery overtime they lose efficiency and do not charge as well until they don't charge at all.

Holy crap this is the first thing that I've ever seen, using 11 mm wrench or socket😂😂😂😂😂

*Promo SM* 😒

Charge before adding water

good video - short and to the point!

Thanks

THANK YOU MAN

This is essential viewing for any owner, our motor became possessed mid plane and the tilt just made its own mind up. Scary situation. Lucky to get it back to the boat ramp.

Seen the stick of 21….now it’s 28 plus. Ugh

Hey, I got a Bass Tracker 175 Tf pro team 2023 and just bought it new. Have had it for a couple months and the front live well stopped working. Not sure what it could be? If you could help me out that would be great! Thanks!

My left ear loved this video

The manual release screw for my mercury 225 is plastic and it cracked when I attempted this. It now leaks from that screw. Looking for instructions on replacing this part. Any advice would be appreciated. Thanks.

Thanks for posting this. It's pretty easy to do. Great concise video!!

Purchased my TXW 175 new from Stokley’s over 5 years ago. Whenever I had questions, maintenance or repairs, they’ve always had answers and friendly and courteous service. Couldn’t ask for more.

Great tutorial Ralph. I am skilled at overloading my live well systems and I appreciate the design and explanation of the tracker system.

Pairing password is 0000

Your awesome bro!!!!!!!!!!

Very helpful, Thanks!

Dude!! This just saved our butts at 11:15 at night THANK YOU for sharing.

Solid gold right here...... Thanks . You need this if your system is low on fluid . You cannot get to the fill plug if the engine wont go up !!!!

Love it.................I NEED one for Chicago, Lake Michigan!

Too bad they arent 10 to 11k anyome. Now theyre selling them for 17 where im at and for 17 i can get a far better boat.

Can this be done on the water??

why doesn't the 18 party barge come with an option for ski tow bar - is it because it can't pull tubes even with the 75?

Garbage ,live well floods your boat in reverse. Put the plug in so you can use this garbage for your beer pop water cooler. That’s all it’s good for.

This worked on my ProGuide V16 when tilt stopped working in up direction with less than 50 hours on the engine. You made it look easy lifting that 60 Merc - but I have a 75 and it takes 2-3 guys to lift that engine. Merc needs better quality control in their Trim System.

Thanks! Just bought a 2012 TXW and this is the best tutorial I have found.

no sound