Seacast set in Styrofoam box
0:15
4 жыл бұрын
Tony Taylor with guest Dani Jaye
3:47
Пікірлер
@diggindiggenit6540
@diggindiggenit6540 7 ай бұрын
Three years later did it hold up good?
@Rick-tb4so
@Rick-tb4so 11 ай бұрын
I would like to see a test between Carbon Bond and Seacast..
@drumrhino
@drumrhino Жыл бұрын
Sorry you didnt get along, i got nothing but support.
@jonolson5397
@jonolson5397 2 жыл бұрын
How’s this boat holding up
@leonharmon1316
@leonharmon1316 2 жыл бұрын
Carbon bond is way better of a product and much easier to use
@jonolson5397
@jonolson5397 2 жыл бұрын
It’s very expensive
@martinmcquaide4807
@martinmcquaide4807 2 жыл бұрын
I think that is the way to do it, inside and outside are F/G, why does the inside have to be plywood? It's just going to rot again sometime. Water will get in do to small cracks in the glass overtime. In cold climates freezing will expand and make voids, which makes room for more water. Technology with this and Coosa board just makes sense. Hulls used to be wood from the beginning of time to the first F/G hull. Why use any wood in boats.
@terrybidez7732
@terrybidez7732 2 жыл бұрын
Monkey mating with a football
@tomlockwood6599
@tomlockwood6599 3 жыл бұрын
Absolutely the most boring video on KZbin. And it ends with them still mixing...
@michielderuyter6011
@michielderuyter6011 3 жыл бұрын
Title must be: mixing seacast 😂
@MihovTV
@MihovTV 2 жыл бұрын
Mixing seacast look at my ass 🤣
@ECOWOLFINC
@ECOWOLFINC 4 жыл бұрын
Great works guys, but...Our updated Manual says you don't need the inside upside fiberglass. Just let cure and then sand and apply (2) Layers Bi-Axle 1708 and polyester resin to seal. Also use a Rubber hammer for better results.