Hey thanks. I have the same year. Side note: after the two screws, switch panel, and tweeter are pulled. All I did was do a slight yank on the door handle and the door panel popped out then like you said run your hands along the bottom to pop the rest out. You have to lift the top part of the panel to detach it completely.

What symptoms did you have prior to this replacement?

I appreciate you making the video. In given socket sizes. The part about loosening the pulley bolt I haven't seen anybody else mentioned and that was my main question. I was afraid if I started adjusting without loosening it it would break but I didn't want to loosen it if I didn't have to.

I just did a enginge swap in my 2007 speed 3 after i blew it up. And after the install everything is good except the temp sensor 😢 i so wish i would have changed the sensor while the engine was out! Thanks for the video!!

Thanks mate 👍🏻

Have that same year and my passenger door won't open from the inside or outside

Thank you so much! I searched for that last bolt for so long. Every other video just skips right over it

Fucking YES! Almost every vid I’ve come across doesn’t even come close to actually showing the bolt locations. Just “remove the easy to see bolts” and boom out goes their manifold. Nothing about the hidden ones except for one that has no sound. Thank you

This was better then most videos thanks👍

Good thing I found this video very helpful 👍

This was very helpful thanks keep at it👍

i need to replace 96 civic ac belt. well i put the belt in but cant find the adjustment bolt to put it on both pullies. belt number is 790