Thank you

Hello. I have just bought this jump starter. Thank you for this video, very well explained with a good presentation. Good to know as well it doesnt work on a fully dead battery. I read on the instruction manual that this model can only be used on a lead battery. This is not indicated on the packaging. Unfortunately I don't have a lead battery. Do you think it will still work? Or is it better to take it back to the store?

Thank you for the great video but may I politely suggest that if you're going to be filming a video for KZbin - blow your nose first if it's runny! That glistening snot sitting at the edge of your nostril was kinda gross, and then you even tried to sniff it up! 🤢🤮🤧

Buy a new battery, a booster isn’t a cure for a garbage battery

My friend let me use theres it worked in seconds my battery was dead !! Not even key worked I definitely recommend

LOOKS GREAT

You showed exactly how it was needed to be shown. Thanks for that. ❤

The kit with the bump stops? Or without. Any rubbing on 35’s while off roading?

MAYBE CLEAN YOUR TERMINALS BATTERY POSTS AND CONNECTIRS.

Pls when u did ur 35’s did you add spacers to all the 4 wheels?

Did you add spacers to the tires bcos i have the same car with 35 but it keeps rubbing

I have the Eliminator 011-1905-5 1500amp version I would recommend it that was the 759amp one in the video

Try that at -30

The blind leading the blind. Take the cellophane off the instruction manuel and read the contents.

This video should be taken down

You need to push the brake pedal down before the car will even start normally. For most of the video where I could see your failed attempts you were not on the brake pedal (4:33m), you need to push the brake pedal down to start all vehicles! Or pushing in the clutch like I must do on my car with a standard transmission. It’s a safety feature!

Read the instructions Bra. A completely dead battery requires pressing and holding the over-ride button.

You’re wrong. It’ll work on a completely dead battery. You need to hold down manual override for 3 seconds. With a battery at 2 volts or less the Eliminator thinks it’s not hooked up to anything. Read your instructions

Alway connect neg last and disconnect neg first

Jajaja....

did you change something else? or only install 35's and after lift kit 1.5?

What is the exact size of the rims?

wheel 17x9 or 8.5, offset is -12 or 0 ?

Loved the idea of spacer for spare… didnt think of something like that..

Is this the 3.6L or 2.0 turbo?

The turd thing 😂

Absolutely awesome video for me.... Thank you for making this video in cold.... Blessings 🕊️

You didn't let the lights that wis flashing, to stop then try and start it, i did and it worked.

Great video, I just want a tool like this for tires only.

I bought a 20000 mah one. Used less than 10 times. It was stored for a month and now it won't charge. Completely dead.

Does it rub ?

The LCD blank out , can do nothing

THANK YOU 🙏

Hi! Firstly, thank you a lot for your video, you did amazing job! Secondly, I want to ask you how or where do you recharge the powerbank? Can you plug it into a normal socket (220V)?

Hi @Tushar, thanks for the nice videos If this tool can help fix the shift points, what else pushed you towards regearing? what other benefits can regearing offer?

My device doesn't charge after one year of no use. Does anybody know what happened?

1st off looks great. Question with the spare tire spacer? Does the tire rattle ? Did you extend the bump stocks off the trunk so the tire is supported? Does the camera cover fit back on with the extender ?

Red light is keep coming on and the device is keep beeping

Hi. Im trying to contact with you. We want u to review some power banks and portable stations and fast charger usb. If you are interested. Please reply me. Thanks

Instead of calling your friend how about you read the manual.

SHUT YOUR DOOR! And let the booster charge the battery a little bit, wait a couple of minutes, then jump start.

I don't like these lithium-ion boosters because they have a fuse in them to prevent over heating, which means if you try to start your car too many times the booster may over heat and even start to smoke, blowing the fuse, which you would have to take the booster apart to replace the fuse, and from what i've seen the fuse is in a terrible place, very hard to replace. Plus you have to look for a new fuse to buy. Many people would just buy a new booster.

You are using a 750 Amp max, that might not be enough juice to jump start a V8.

I recently moved to 35s. But after a lot of trial and error I set the size to 33.25 using the ECRI. That seemed to get my speed to match various speed limit signs and GPS based speedometers. It improved my ride as the shift points corrected. I even more recently re-geared too. Improved my mileage a lot. I lost a lot moving to 35s. But now I am a little better than stock. But the shop set my tires to 34.1, which was again wrong. I moved it back to 33.25 and speeds seemed to correlate with outside sources again. Apparently 35" tires are 33" when on the jeep :) Probably not a surprise as the weight of the jeep likely compresses things a bit. Anyway, the point of all that, was I could never get the ECRI to give me a good tire size. When it was set at 34.1 it recommended 33.9, at 33.9 it recommended 33.3. At 33.25 it recommended 32.75 etc. Even when I initially moved from 33" factory tires to 35" tires it was very random. Interestingly, the 33" tires were set to 31" tires initially. That made me feel better about losing 2" :)

wow💟💟💟💟

What were the shift points doing before the recalibration?

Wrong side tyres in alloy wheels these letters should be outside

How do you feel the suspension 🤔 it is more tiff or sosfter?

How can I change the jump starter it self

Doesn’t work for a totally dead car battery as there is no ‘boost’ function to take its place. It works only when the car battery still have some juice in it. Hopeless item