I wanted to know if the rope goes on the inside or outside

Can riddler handle be reconnected? If so process?

I am considering buying a solis k100, just wondering are they a good stove

Anyone tell me is this a good pellet stove?

There' side metal-rods, between where the side fire blocks would be. These are blocking the sideward movement of the top baffle, blocking it enough to prevent its removal. Instructions suggest to take out these bars (unless the instructions mean some other bars?). In any case the upper baffle will not come out

thks for this totally useless video on stanley cooker and how to use it

Worked perfect for me. Tip for old baffle, just give it a tip of a hammer and it falls appart. I wouldnt agree with taking the top off the stove to change a baffle as others have suggested.

The video isn't real life for sure! I can only say thanks for the video so i found these comments! 🙌🏽😅 What's in the video doesn’t work after the baffle has warped and expanded over time. 1. due to the long tie rods at either side being much too tight to the edges for it to shift left or right to angle it out. 2. Even when i lifted off the top and the long tie bolts werent in the way it was still too tight to take out through the door. I got the baffle out by loosening the two bottom nuts(under the stove), that then let the top and long tie bolts lift clean off. The baffle could be taken out then. As mentioned above, I'm replacing the fire seal again now with a new one. Thanks for the video in order to find this thread, and thanks for all of the comments re hoovering etc. I feel we could start a support group after that experience!!😅

I have gone on to the roof and sweep the flu from there. I shake the baffle plates to release as much soot as i can. Great stove, but a ballox to clean the flu

The 60 cm cookers are made in Turkey, by whom?

He makes it look so simple to remove the baffle. This baffle expands and is next to impossible to get it out or put it back in. It’s also almost impossible to replace the baffle protection plates correctly as they won’t sit in place properly. Avoid at all costs.

Worst stove to clean. Removal of baffle and firebrick an absolute nightmare. Do not buy this stove!

Oh dear, the sound quality is terrible not the Stanley that I was use too as one of your service agents in the north west.

Removed a section in my camper where the entertainment area is and installed. Works great. Instead of propane furnace heat, I can use this kzbin.infoUgkxATHBlMJwipGgVWseuAFKvDQ_5R4_lywo to heat the camper as long as it's hooked up to shore power. Only thing I do not like is there does not seem to be a thermostat. I'm presuming it has a built-in one so it does not overheat. Really like all the other color options it has to offer.

Can the stove/flu cleaning rods be used if the stove has a back 90 elbow that connects to the upright flu

Hello, I would like to know how to reset the hours of service

Olá gostaria de saber como fazer reset das horas de serviço

Very helpful video. Thank you.

not very good instructions for first time user

EXCELLENT!.. Thank you

Is flue really necessary...can one route boiler outlet directly to existing chimney?

I don't have a chimney and would like to have a stove fitted as above, it's says that horizontal pipes are a maximum of six inches, but how long is the 45 degree bend?

Hi,My riddling grate is very hard to move when cold but when hot it doesn't move at all. Would the grate be warped? It's only a year old stove

Fabricated chimney does not need to clear apex.

Hi thanks for video, but I'm just wondering can you tell me what the 4 holes are for on the back of my stove that go straight through the back brick plate aswell, it's a Stanley oisin eco, thanks Liam

I have 6 inch pipe from the wood stove while will go into 3 inch pipe flue to roof . is it possible to use a reducer

The shaft on the primary air control on top of my Stanley Erin stove has disconnected for some reason, any ideas why

They should have made a app for people to make it simpler

On another Irish site says full run to 22 hours and what is cost to run daily pellets and electric

WHERE DO YOU FIND A 45 DEGREE THROUGH THE WALL!?! Everything I have seen has been 90 only! I'd like to go through at 45 for better draft.

Guys I have one of these in the house 10years it came with the house. There is very little heat output from it. Is there an area of the stove that is supposed to throw out heat or is it the radiant heat fro the glass? I know other people who swear by them.

I used this video to replace the bricks but kept the old baffle, easy peasy in the shop with a brand new stove at waist height, not so easy with an old stove. Prepare yourself for tears off despair/joy, broken finger nails, back ache and ensure there are no children around to hear the bad language, well done to the person who accomplished this in 40 minutes, it took me 50 minutes, finally succeeded by putting the baffle protectors in place but leaving the standing up of them until last. Never trust a man with ballpoint pen writing on his hands

What a pisstake using a brand new stove that is not even connected. Wish they showed how to deal with a burnt out baffle plate that has been sitting there for years.

Hi I have a gas fire but I want to get Stanley fire can u come up and check the one that would suit my home

there is some true true but allso some non true true in this video

Could you do the Stanley aoife

Thank you very simple and very useful.

Not that easy as Stanley have removed the rods that hold the top on which are in the way of the baffle

Can you do a video on the aoife stove baffle removal top middle and bottom baffle?

what joke.......cant install a new chiminny or flu unless u buy a new stove.......worthless vid

I bought a new bafele for the oisin Stanley today and it is to small

Are you going to publish the receipts & cooking times?

Fantastic video & range, any chance of getting your recipe & cooking times for the 48 hour lamb & brisket?

How the feck is anyone supposed to remember all this shite?

My Stanley Henley door handle is stuck how do you free it. Do I need to take off the henge, if so how do I do this. Sarah

Made in China?

Made in China??

Great detail lads. Any chance of a video for the non technical domestic customer highlighting basics such as installation costs, compatibility with legacy oil fired systems and what’s involved or required to upgrade older buildings. Basically a suitability guide for dummies like me.

Is there a Stanley fire front boiler stove or small stove like oisin that you can clean chimney flue through the front