Пікірлер
@rayclaudio4141 5 күн бұрын
My bolt that goes to that's steering shaft snapped lol
@scottcazelot4663 Ай бұрын
THANK YOU! Huge help!!!
@stanleykeith7863 3 ай бұрын
You sux
@todrwilliams2871 4 ай бұрын
Get to the work ......
@angelosolano9261 5 ай бұрын
Good video...thanks
@mitchellhines6200 5 ай бұрын
just remembered american nissan might be a little different to australian nissan navara
@mitchellhines6200 5 ай бұрын
I have just done one and found it easier to remove steering rack ends and pull out through bottom of car under engine sump no did not remove front diff either riggle a bit but does come out
@1966roadster 2 ай бұрын
Hey needing to replace my steering rack in my 08 xterra 4x4. You mentioned that you pulled it out the bottom instead of fishing it through the passenger side? Could you please go into some details about it? Thanks
@JimmyBoy87 5 ай бұрын
Did you have to center that rack?
@garrhettmckain3120 5 ай бұрын
Yes I did. Actually I learned the hard way. I centered the rack, but left the steering wheel in the lock position, which Nissan put at 45 degrees off center. Had I more experience, I would have realized before too late. I ended up marking the position with the wheels centered and marking with the steering wheel centered, then disconnecting and reconnecting so that they matched. Back to your question, this rack did not specify so I centered it to make sure, some are centered out of box.
@raysno8367 7 ай бұрын
Do you think it would been easier to drop the diff
@garrhettmckain3120 7 ай бұрын
I haven't dropped the diff before so it's hard to say for sure. It wasn't particularly easy to get the rack out or put in so it very well could have been easier. I also was working with minimal equipment, contributing to my choice not to. In essence: if you're comfortable dropping the diff, probably would have been easier.
@danieltyutyunnik2584 8 ай бұрын
Doing this on 4 by 4 frontier wisn me luck
@garrhettmckain3120 8 ай бұрын
How did it go?