Video moves too fast and not focused on the sensor you are removing m! Hard to follow anything you did! Worst video ever!
@braveniner3720Күн бұрын
DAMN.... How much should i charge for replacing this?
@1Guy1WrenchКүн бұрын
3 😆
@melvinriddick72533 күн бұрын
Good job young man
@ChadLuciano8 күн бұрын
The grinding of the rotor is a result of depleted pads, if one side wore out quickly it could also indicate a seized caliper...also prudent to change pads and rotors per axle to insure even braking, no pulsating pedal, vehicle pulling to one side...rotors also warp with heat and heavy use. Remember to use jack-stands when working from a jack folks.
@Slim14238 күн бұрын
Hi. Do you know the exact location where the MAP sensor is located on the 03 Cadillac CTS ? It is very hard to find.
@BossaNossa19 күн бұрын
Have you done the other side...? Thanks!
@JeriKS36910 күн бұрын
What type of filter is that
@ArtemzBuildz11 күн бұрын
Thanks man
@DylanC82813 күн бұрын
Gd bro giving me a headache
@1Guy1Wrench13 күн бұрын
😆
@RodaRoseRo15 күн бұрын
👍🏻
@MoveMint.est8516 күн бұрын
✨✨✨👌👌👌👌
@trknight196818 күн бұрын
2012 impala is a bit difficult with only 1 motor mount braket & two extra fan bolts on lower part of it on each side is 1 each, my radiator leaked from where upper passenger side fan bolts on. Tried to fix with JB weld & worked for temporary solution but still leaked out small amount each time driven, it ended up cracking even more around that same area I used JB weld. It’s a stupid design & fab vibration constantly caused it to crack around that area fan bolt is held onto by. Bought brand new radiator for 60$ on eBay site & delivered in 2-4 days with warranty! Got an excellent replacement & will attempt to replace tomorrow! I was told removing the drivers headlamp will make access to lower tranny line & hose a bit easier. Did not know had to remove the air cleaner parts. Removing battery helps a bit more as well for easier access to upper hose & fan bolt connection. I almost started to remove the bottom plastic engine cover but glad I did not have to for access to lower part of assembly! Might have to if unable to get to stuff there. Will attempt this tomorrow & record the length of time it takes me. I need to get access to that hose clamp remover thing cuz these clamps are a pain in ass trying to remove with pliers. Easier to just cut damn hose & replace entire both hoses with new type clamps! If cut hoses then only gotta worry about the engine side of hose clamps to deal with & the cost of 2 new hoses with 4 new clamps(the screw driver type)! Saves time trying to remove from radiator in tight spot with pliers can be frustrating & cussing a lot while take break for a minute & keep trying to get that damn clamp off can be a bitch is why I will just cut my hoses. Pull radiator with cut hose & clamp still on cuz radiator is trash anyway!! Just gotta get clamp & hose off engine side after with more room with radiator out of it!! I was also told that if cannot get tranny line clip off then loosen the bolt part of it & it will make easier removal & if radiator is junk it won’t matter. Remove clip after you unscrew it from radiator & radiator removed for better access!! Do not over tighten the fan bolts held on by radiator!! Tighten good but not over tight. Replace both upper & lower hoses to engine prior to reinstall radiator for better access & radiator not in way. Make sure a/c cooler unit is secure to radiator in place, properly snug & do not disconnect a/c lines or anything with that or will need recharge a/c system all over! Cost a shitload if disconnect any part of a/c system!! Will update my progress & any tricks or things to watch out for! As well the true length of time including a break or two with some cussing!!!
@MrRockydee0720 күн бұрын
Thanks, I'm doing this today . How'd you know the sensor was bad ?
@1Guy1Wrench20 күн бұрын
Oil light kept coming on when oil was full
@MrRockydee0720 күн бұрын
@1Guy1Wrench OK thanks, The engine runs fine except for some RPM fluctuations and the light going on and off . Also I think the switch is hooked onto your computer somehow that might be why the RPM is going crazy
@dougrivera198920 күн бұрын
Man, how did y’all get that fuel tank pressure sensor off with such little space? Mine is really stuck on there
@ontheroadproductions395621 күн бұрын
Why there a ford filter on a fucking Malibu tho lmao
@bebo361522 күн бұрын
Thank you!
@misskizzyboyd13424 күн бұрын
what was your car doing as to how you found out it was the throttle body..instead of the gas pedal... i have a 06 3.6L dual gear shifter/auto/manual ... i just replaced my pedal due to not going past 60mph, limp mode, engine light, etc..I DID NOT-- reset/relearn... not many other ways to figure it out besides replace all; throttle body sensor, gas pedal clean throttle body...its moving now since i repl pedal but barely.. What in the #$@ to do next?
@1Guy1Wrench24 күн бұрын
Going Into Limp Mode , This Problem Didn’t Fix The Issue. I’m Sure My Problem Was The Gas Pedal But I Just Ended Up Selling It Because Of It.
@creoleDJ25 күн бұрын
I have a 2004 MC SS, 3.8L V6. Is it the same repair method? Thanks.
@1Guy1Wrench25 күн бұрын
yes
@bluefeatherlopez726 күн бұрын
What are the steps to relearn ?
@1Guy1Wrench26 күн бұрын
Have to take it to the dealer and have them do it
@bluefeatherlopez726 күн бұрын
@@1Guy1Wrench it'll be drivable once I replace this malfunction?
@1Guy1Wrench26 күн бұрын
Yes
@regster216826 күн бұрын
is this what i do when it says service required
@1Guy1Wrench26 күн бұрын
yes
@kristyfrazier872828 күн бұрын
You cracked me up. I love the green Challenger rolling up in the video, I have a white one.
@djhorizion667029 күн бұрын
What filter n oil do I use?
@1Guy1Wrench29 күн бұрын
@@djhorizion6670 top shelf
@williamdrayer3rd412Ай бұрын
Thanks for making the video simple.
@MrSilvernblackbloodАй бұрын
I just got this part at my local pic n pull for less than $10
@1Guy1WrenchАй бұрын
That’s wassup, I don’t like to put used parts on my Lac
@MrSilvernblackbloodАй бұрын
Its a discontinued dealer part, i doubt AutoZone has it still, The one i pulled was in very good condition@@1Guy1Wrench
@JesusRomero-e5f26 күн бұрын
Hey what is this part name ? Nd part number
@1Guy1Wrench26 күн бұрын
Idk the part number but it’s called a “Heater Control Valve”
@MrSilvernblackblood25 күн бұрын
It's a discontinued dealer part and not sure an aftermarket part exist, still searching, I got lucky and found an oem one for someone, if you need one let me know.
@jvst20051Ай бұрын
Bro u should title the video how i removed it cause i didnt see any replacement
@chrisbitoy2686Ай бұрын
Terrible video
@BaronKubeАй бұрын
Thanks for this, I noticed coolant pouring out of my water pump earlier today, this video is preparing me for what I have to go through tomorrow 😂
@noticeelijahАй бұрын
Good morning I sent you a email this morning about my 03 cts was trying to see if you received it or if you have a new email
@jmemixxАй бұрын
Which one is the output and which one is the input
@curtisbarnhart2470Ай бұрын
Were you having poor fuel economy?
@pauldistefano8926Ай бұрын
Great video gets to the point get to the subject matter gets to the plugs and gets a big thank you thank you thank you you made it simple and easy
@user-tn3kx4vc8vАй бұрын
Nice video big man, you flushed the coolant before hand right?
@CHIEFWbrawlАй бұрын
Thanks!
@lovelyamorah5780Ай бұрын
What's the gold cap right there? I need to replace it, but I do not know the name of the part. It's cracked and leaking. It would help tremendously
@luishernandobohorquez1979Ай бұрын
Exelent video thank you
@TexasJester09Ай бұрын
Appreciate it my dude
@-mejor-que-nostradamus-6152Ай бұрын
GM Must Be Sued Because ECM Was Bad Made ECM Gets Corrupt When You Open Door Without Key, When You Change Battery, When Car Stay For A Few Weeks In Your Garage, From Nothing ECM Locked. Amén.
@Todayis2dayАй бұрын
Dope. Thanks. 😂😂😂 Not me the pan
@luisjose5190Ай бұрын
Gracias x el video tanks for de video
@1Guy1WrenchАй бұрын
English?
@oceanavenue1470Ай бұрын
Motor size? Too many dont even post motor size
@1Guy1WrenchАй бұрын
You Can’t Tell From Looking At The Video?
@Evaman1001Ай бұрын
@@1Guy1Wrench funny way to say you can't remember
@dazedu222Ай бұрын
Why did you not show how to get those panels off?
@1Guy1WrenchАй бұрын
Because I only have two hands
@brey932 ай бұрын
Is this clk reliable and easy to work on based on your experience? Thinking of getting a 2001 with only 105k miles
@1Guy1Wrench2 ай бұрын
Not To Bad To Work On Parts Are Expensive Tho
@brey932 ай бұрын
@@1Guy1Wrench thanks for the speedy reply appreciate it. Do you think it’s a good purchase today in 2024 for a daily driver? Are parts hard to come by?
@freedriver31822 ай бұрын
Very helpful. Thanks 👍👍
@Handy4everything2 ай бұрын
Crazy how you shut it off during the most important part
@1Guy1Wrench2 ай бұрын
Which Was?
@annagurule80782 ай бұрын
0:49 Im needing to ask what hose is this in my Chrysler Pacifica 2005 it was spraying out coolant
@rachelmcneal52112 ай бұрын
Could you replace it with rubber hose or does it have to be the exact same thing
@1Guy1Wrench2 ай бұрын
I’d replace it with the exact same thing
@thisguyoverhere47462 ай бұрын
Simple and straight to the point. Respect, my dude!
@andrewgibb97822 ай бұрын
hey what's the threads pitch for that cover on the transmission mines missing