This method is correct. Many PLX owners complain of play and wobble in the tone arm gimble… the fix for this is usually the vertical adjustment screw needs a soft tightening. That will eliminate the annoying problem.. The horizontal screw rarely if ever needs adjustment. Vertical always the issue on the 5 tables I have serviced

What a botch Job. Those pivots and bearings are calibrated in a factory. They use a special tools for the calibration. Don't follow amateurs like this on KZbin.

What about the upper screw?

I just did this on my Reloop 7000 limited edition. Its has been wobbly since day 1. I definitely will never buy reloop again. THanks!

Good video 👏🏽

I bought an old-school used Gemini PDT6000 by a hard-scratching guy. Tone arm seems to be defected, but after this short trick is like a new one!!! THANX!!!

This won’t mess with how it plays?

Thank you sooo much I’m a scratch dj and bought the Stanton atl 1240s after having to part with my technic 1200s 3 years ago. The tone arms were a bit shaky. Not anymore! Thanks again!!!

i have a crosley dj100a everything is set up correctly i even used a leveler no matter what cartridge what needle i use. when i drop the needle the cartridge falls bottoms out to the right it doesnt stay straight.never had this problem with 30 yr turntables.has anybody experience this problem.could it be just a faulty turntable

The locking ring on the opposite side keeps popping out but it doesn’t seem to have a thread like the right side, is the other side usually permanently fixed somehow?

worked a treat on my 1200 MK3's. think the tonearm became loose during shipping. thanks a million

Man, thanks for this. I got my plx1000 perfect after the adjustments. I suggest to wa this video too. kzbin.info/www/bejne/gqKVg55tlM5pnrM That way you can find the right balance. And remember to level correctly the turntable before the anti-skating test.

You’ve got to be gentle, like a watchmaker

Just wanna go on record and say that I just did this to my PLX1000 and it worked perfectly, the top gimbal needed to be tightened, the trick is to do this very carefully. Too tight and it will throw off the anti skate

It doesn't come loose in transit Ir's a shit product made by Hanpin and ALL their tonearms suffer with loose rattly bearings due to the QC being shit. Audio Technica, Onkyo Reloop, Pioneer etc all suffer at the hands of Hanpin!

Thanks mate, helped me a bunch!

In relation to the Pioneer PLX-1000 which some have loose gimbal pivots I found that the adjustment screw was tough to turn due to a thread lock glue having been applied at the factory (shame they didn't set them up correctly before applying loctite!). Once the seal was broken I was able to back off the screw and remove the locking ring. Adjustment is a matter of feeling what is "right" there is only an absolute fraction of a turn between being too loose and too tight. It's vital to "feel" the correct setting. Actually on the PLX-1000 it seems that the top gimbal is almost always the one that needs adjustment to remove excessive play in the tonearm and the very slightest of movement on the screw will fix this. Care must be taken when trying to loosen the screw as not to slip!

This fixed my lose tonearm on a Stanton str8-150. But you have to be careful because if you over tighten by the slightest amount the tonearm will float.

These screws are factory present especially Technics tonearms. You should use special driver to tighten them at specific torque setting. Not sure if I would do this I think it would be better to replace the whole tonearm.

Now I have skipping issues and skating problems ..