Great video, thank you!

Don't know if you are still checking comments but thanks for this really helpful video

Thank you!

backside of butterfly valve still filthy..fyi

Thanks brother. Any benefit to removing the body to clean both sides?

Think you could run the genius 2 off of a portable power station such as an EcoFlow?

Worked perfectly... thanks bud.

Thank you for making a quality video, the information is very clear and useful...,........

Dealer wants $189 to do this service

What does it mean it if never goes past 1 red bar?

❤

Great job, thanks.

So you need to plug it in to an outlet? What if you need to charge ur car battery when it dies on the road?

This was 90% of the info I was looking for. Thanks!

Pass any low flying planes?😂

👍👍👍👍👍

Does the battery have to be hooked up to the car lol?

Thanks for pointing out that when fully charged the green light will remain fully lit. My first time to use my Genius 10 and I have a flashing green light for nearly an hour and was unsure if constant illumination is expected. I’m surprised how difficult it has been to find this confirmation. They should have provided a how to use manual with the charger.

Stop fuse keeps blowing as soon as I push brake pedal, Changed brake switch, same thing. Checked and changed bulbs but still no brake lights and still blowing fuses. Tail lights are fine... not sure what else to do besides the dreaded tracing of wires. I unplugged every connector to try and narrow down short but fuse still blows with everything disconnected. About 40 fuses later and im still puzzled. Any ideas?

I did this. And now the truck wont start

best video I ever saw on you tube, hope you make more videos.

Great video, thank you. Saved me a ton of time fixing my son’s 2009 Colorado!

Takes 5 minutes to just remove and clean it properly

You didn’t have to put a LSD friction modifier?

Is this thing portable or does it need to be plugged into an outlet to use?

can u test it out without water going through first?

Thanks to your video, I was able to locate and replace my brake switch. It started with my third brake light going out (broken bulbs due to weak gasket) and eventually it stopped working even with new bulbs. I even replaced the entire third brake light assembly to no avail. Today all my brake lights were out. I checked my fuses and they were fine. Coincidentally, my cruise no longer engages, so that switch is next on my list. Thank you!

the first time taking off the cover on my 1998 Chevrolet c1500 i replaced the gasket. it leaked a little after. i took it off again, cleaned the surface and now it is ok.. take the time to clean seal before installing new gasket. after taking off once and getting rid of break in magnet metal this is the only option i will use in the future. i see gasket maybe 20 dollars.. risk of the seal leaking.. more time.. this options makes a lot of sense..

And that's how you make a how to video. Great job. It's been 3 years, how is the Lucas gun doing?

I changed the brake light switch and I check all the fuses still no third brake light working

cool!

I'm looking into trying this to keep my chickens out of my flower bed and off my porch.

😊❤🎉

Throttle body nawi kitny ki ati ha

The fuse didn’t blow when the wire melted?

Will it charge two 6 volt batteries

Question: I just bought one and it charge up my battery just fine. NOW ... I want to permanently install it but how do I mount it to the side posts? The clip on ends will likely shake off.

Great video. I also have an 04 Yukon and need to do this. Was the hose that came with the pump flexible enough to get in there? And how far were you able to get the hose in? Thanks!

Thank You

I have changed the fuse and brake light switch and I still don't have breake lights all other lights are working

Me like

You can save yourself a lot of aggravation if you connect to the battery with the ring terminals. The clips are notoriously unreliable, and tend to lose connection after a few weeks.

On some batteries, , desulphater mode startes and on others not.... This charger is very strange. How to start desulphater mode manually?

I'm not even a fan of Chevy, GMC or Ford for that matter but that Eaton G80 locker is one of the best inventions & super badass + hella reliable much props & I like how they put it in their SUVs all different vehicles makes them so much more capable off-road than what they would be without it! Nice because it can be used in 2-wheel drive unlike my '22 dumbass Tacoma that has to be in 4L to work the locker 🔒🤷 figured by now Toyota would have engineered these trucks to work in 2wd or 4H with a locker... Not even on the 4th gen 🤮Tacoma! Whack! Colorado trailboss is the best mid-sized 🛻💨 for the💰... I love old skool Chevy/Ford trucks just not the new OVERPRICED bullshit their (all manufacturers) building. God bless 🙏💯👍👍

very informative video, 1 question, can I use this as my deep cycle 250 ah lithium ion back up inverter charger?, any advice on that, can I just hook it up n leave it ?

I was looking for a basic "How to use" manual and found your video. It's extremely helpful, but you didn't mention how long the battery took to charge. Other than that, fantastic video. Thank you SO much!!!! My dead car (-37C outside) is now charging away. :)

I just boxed mine up to return it, as a lot of people have stated, these things don't work! People you will regret buying this.

Does this charger desulfate a agm?

The hose was extremely hard to remove, had to get 2 people to remove the air filter end off first, pry that off, then pry the other end off the throttle body. This is with the tightening brackets unscrewed and loose.

The cable clips should be facing in the same direction as the light so you can see what your doing on a dark moonless night.