Random question but what’s the lowest PSI it can run?
@AlaaddinSurmen9 күн бұрын
are those for a mtb
@SMGPERFORMANCE1613 күн бұрын
Do you still have this
@keldonator17 күн бұрын
Was that the max6 g2 or the older one?
@braydonisert74017 күн бұрын
I just put them on my XRT
@gabrielruiz519320 күн бұрын
3s?
@niallmackenzie9920 күн бұрын
I prefer my limited with the chrome trim. I don't need a huge grille to tell everyone it's a ford.
@Tavionag20 күн бұрын
Congratulations
@matthall937520 күн бұрын
Did you put a 47 tooth sprocket to make it go even faster?
@sturner15121 күн бұрын
I found with a couple of my builds flex blades in just the rear are great
@matthewedwards664321 күн бұрын
Can we get a more detailed video on all the stuff you have to do for the motor swap
@Tavionag20 күн бұрын
I mean I’m not sure what else there is to show it’s a pretty straightforward swap it basically just bolts in
@matthall937521 күн бұрын
Did you put an upgraded sprocket to make go even faster?
@CyrusToledo-j3m23 күн бұрын
were did you buy that tires broo???
@72mmALKYDRAGGIN23 күн бұрын
Needs ☝️more tooth on the front ⚙️ or -2 teeth on rear. I say do 1 more on the FRONt SPROCKET
@Tavionag23 күн бұрын
Yup already bought all of that
@72mmALKYDRAGGIN23 күн бұрын
@ which one u going to do 1st?? The +1 tooth FRONT?? That what I do to all my QUADS because IT MAKES THEM SO MUCH MORE RIDEABLE!! Banshees, blasters, raptors, ECT!!
@72mmALKYDRAGGIN23 күн бұрын
100ml of oil(pre-mix) and 1gal fuel is PERFECT 37:1 U got a good one and just tip the quad on it’s side w/5gal bucket against the handle bar to remove the clutch cover and do crank seals. Just drain coolant and the oil will stay in engine while u tear it down & replace seal. The only REASON to pull the engine is for TRANS & CRANK REPLACEMENT/FIX. Everything else u can do IN THE CHASSIS
@72mmALKYDRAGGIN23 күн бұрын
47th👍 The BANSHEE CONTENT is what will GET THE 🌍 TO WATCH and U OVER THE TOP!!
@MohammadBashir-w4j23 күн бұрын
When you bought the engine and checked for oil in there it might look like oil on the dip stick but it’s shipping fluid. Make sure you drain that out because it’s NOT OIL. there people who I know made that mistake I did too. I blow my engine wondering why. So buy a quart of oil and put it in. Thanks
@Tavionag23 күн бұрын
Yup I did that lol
@MohammadBashir-w4j23 күн бұрын
Did you check for oil. If you did and the fluid on the dipstick that’s not oil that shipping fluid. So make sure you drain that fluid out put in fresh 10W-40 oil and break it in for 20- 30 hours. Drive it like you stole it. Then change the oil put In 10w40 synthetic and you sure by good 👍🏻