Daily Captures

Пікірлер

@basabra 3 күн бұрын

Does the manual opening by doorkey still work when the car battery dies?

@DADoESofTX 4 күн бұрын

It kept filling after you reassembled the console because you disconnected the pressure tube from the water level switch while the tub was full of water. Water level works via air pressure increasing in the tube in response to the water level rising in the tub, from empty for proper levels.

@jaybx2230 4 күн бұрын

You losen the screws first or just loosen with the gun?

@droopy128 3 күн бұрын

@@jaybx2230 loosen by hand tool first

@jaybx2230 3 күн бұрын

@droopy128 thank you im about to start this job and im scared to break the screws, i have broken a few before so im extra nervous.

@Gabesmusicdiscography 6 күн бұрын

I did what you did and it worked! Thanks for posting this video, you saved me a big headache.

@CesarioAgado-ni4zg Ай бұрын

DOES ANYBODY KNOW WHAT YEAR IS THIS KENMORE WASHER ?

@MatthewJames-st5wv Ай бұрын

1995 model year

@CesarioAgado-ni4zg Ай бұрын

@MatthewJames-st5wv THANK YOU SIR IM FIXING TO PUT ALL THE SEALS NEW I HAVE HAVE THIS EXACT WASHER STILL GOING STRONG 💪.

@jeffscomp 28 күн бұрын

I have the same washer too. It still works also.

@CesarioAgado-ni4zg Ай бұрын

AFTER DONE FILEING. STRAY SOME WD 40 WILL HELP ALOT .

@california_valley 2 ай бұрын

My question is when you disconnect the hoses didn’t drop it some fluids or not couse I m about to do that job soon on my tl 2005.

@droopy128 2 ай бұрын

@@california_valley there is no fluid

@california_valley 2 ай бұрын

@@droopy128 🙏

@b1ugr742 2 ай бұрын

Yoo these are gonna help me restore my EF si thank you! 🙏

@matthewsanchez956 2 ай бұрын

All the single cams need rebuilds by now. You should have did a full rebuild if you went this far

@chineeboy18 2 ай бұрын

Amazing work...!!!

@morlongilbert6513 2 ай бұрын

How do you get the second screw out

@droopy128 2 ай бұрын

@@morlongilbert6513 Don’t remember exactly. I think with just with the screwdriver

@stacywright4977 4 ай бұрын

How did you get the bottom cover off?

@droopy128 4 ай бұрын

@@stacywright4977 it held up by clips. Pull the panel straight toward the seat Like pulling it parallel direction, then release whatever connectors. Dont pull down on the panel..!

@stacywright4977 4 ай бұрын

@droopy128 thank you so much

@frankgt2723 5 ай бұрын

Whats the part number for amazon?

@DJV94022 5 ай бұрын

Nice good work

@jasmineamezcua6245 7 ай бұрын

Did it fix the problem??

@droopy128 7 ай бұрын

Nope. But this did… kzbin.info/www/bejne/aWqZm3-OqduFrNEsi=kNehf3Bead13-Iuu gas indicator is off since this fix. Junk yard item. I think it was $7 at the yard.

@kingstilletto 7 ай бұрын

thats my old girl i miss that car.

@nevonmilton6019 9 ай бұрын

Thanks a lot for this video! Very helpful

@droopy128 11 ай бұрын

Still on the car after all these years. It works..!!

@kevinpatriquin822 11 ай бұрын

Stupid . Justnreplace the starter

@icesalami 11 ай бұрын

how have the held up?

@alexdolan4210 11 ай бұрын

This is what I was looking for thank you man 👍

@bradmaurer5566 Жыл бұрын

Thanks much, I just successfully replaced the switch after months of intermittent non-start and finally getting stranded, with the buzzing noise. Previous owner sold the car at a discount because of this non-start problem after all the usual remedies of new battery, starter, ground cable without working for him. The way to check this is to bypass the ignition switch. Turn the car to the on position . Run a small wire from the + battery terminal and touch it to the starter where the ignition wire connects to the starter (the small connection on the starter; not the big one). Just touch the 12 v wire to this terminal for a few seconds and the car should start up. Or you could jump the big terminal on the starter to the small (ignition terminal) for a few seconds to start it the same way.

@nathanoglesby3879 Жыл бұрын

Can it be cleaned

@droopy128 Жыл бұрын

Don’t know. Didn’t try it

@maxbet3997 Жыл бұрын

Does the transmission have to be in neutral or it doesn’t matter?

@droopy128 Жыл бұрын

To remove the shift fork from the holding rod. You would need to be in neutral setting.

@Crx018 Жыл бұрын

any updates, has the buzzing come back ??

@droopy128 Жыл бұрын

Nope, no noise since. I think the old relay was on it way out

@Crx018 Жыл бұрын

@@droopy128 ok mine does the same noise from the fuse box relay, even when the car is off , it sometimes will buzz and stop and go randomly, car starts no problem, I'm going to order the same part, I hope it will solve this issue

@ivoryusagi Жыл бұрын

Was it successful?

@droopy128 Жыл бұрын

End up adding two more long wood to support the top screen because it got heavy when leaves and fruit grew.

@kelvinmaldonado1626 Жыл бұрын

Work for me thanks

@jesushernandez5532 2 жыл бұрын

@uffdxniel 2 жыл бұрын

Question is tank fuel tank pressure sensor with canister I’m having problem code P0452 So every time I would put gas it would have issue starting up

@zachtaylor2860 Жыл бұрын

Did you ever fix this?

@uffdxniel Жыл бұрын

Nope still haven’t

@andygomez3014 11 ай бұрын

same issue

@jeffkeryk3550 2 жыл бұрын

I replaced the gas cap and all is well on our 2006 TSX with 210K.

@E85_STI Жыл бұрын

What did you notice on your gas cap? Anything wrong with the o ring

@jeffkeryk3550 Жыл бұрын

@@E85_STI Just old. As I recall, the O-Ring was flat.

@snrakmas 2 жыл бұрын

Is it still working?

@droopy128 2 жыл бұрын

Ya. Still working since

@kelvinmaldonado1626 Жыл бұрын

I buy 1 I gonna try it thanks

@crowngyc6046 2 жыл бұрын

I change my battery and starter and igiton switch and relay and all I get is clicking noises and it never starts or turn over ?

@droopy128 2 жыл бұрын

Check yo batt cable pos and neg

@thithuynguyen3991 2 жыл бұрын

Mê quá

@leminhkhoi8222 3 жыл бұрын

Xay ra làm ớt sa tế để tu lạnh ăn từ từ ngon lắm bạn ơi

@Catpanl 3 жыл бұрын

There is a service bulletin for this. Honda says to check the lines for obstructions like insects or rust flakes.

@mikeerali5670 3 жыл бұрын

My sons car won't crank and makes same noise. 12 bucks ebay 54 to 94 dollars advance auto for the relay

@Cruz99juan 3 жыл бұрын

What ecu did you run ?

@fernando2390001 3 жыл бұрын

Did that fix the problem

@mariowilliams9815 3 жыл бұрын

Did you have a blinking key in the dash ?

@chancedennis6979 2 жыл бұрын

Blinking green key is an immobilizer issue, not this.

@anglegrinder4630 3 жыл бұрын

Is that the only indication warning?I have an 06 mdx

@thefreedomguyuk 3 жыл бұрын

I think the allen head had gotten lost....

@BudgetGears 3 жыл бұрын

Nice video! I'll likely be doing the same to my si transmission soon. But I think my diff bearing is gone. Lots of play in my diff and oil keeps leaking out. Good info on your video. I don't see anyone showing a d series cable rebuild. How the transmission holding up after your bearing replacement? I noticed you got a USA Standard kit. I think that's the kit I was looking at. Are they all Japanese bearings?

@droopy128 Жыл бұрын

Oh damn. Didnt realized this msg. Hope u got your rebuild done.. tranny still going strong.!!