Try recalibrating the bed stepper motor.

@@BruhBronxy It took me a minute watching it to figure it out. It was because in the instructions they say to tighten the bed all the way down. This actually lowered the bed lower than it should have to where it was hitting the back stepper motor and not hitting the limit switch back there first. So the grinding was it trying to keep moving but because the bed was too low, it was hitting. I had replaced the springs to stiffer springs, but they were a little shorter, so I believe that's why it was hitting if lowered too low. I may get some spacer blocks or something to put under them to raise the bed up just a little so I can tighten it down all the way. But for now I just have to remember not to tighten it all the way and work my way up from there. Thanks for the suggestion though. I appreciate you trying to help.

Gooood to know! haha

3d print it

Where did you get the STL?

You can do that by using Moonraker plugin from Cura marketplace, either select a check box to print immediately after upload, or take full control of Sonic Pad from a web browser entering its IP address on local network, if you don't want to print right away.

@@Dimsumlezako what I'm trying to find out is once I'm done in Cura, will it export the gcode file to the sonicpad via a usb, thumbdrive, sd card, or wifi? And will the laptop or computer need to stay running during the print or will it be able to be shut down?

You can do that by using Moonraker plugin from Cura marketplace, either select a check box to print immediately after upload, or take full control of Sonic Pad from a web browser entering its IP address on local network, if you don't want to print right away.

Hello! Stl file is inside the flash drive👍

@@chriss1671 ohh do you mean when you create the flash SD card ? If so after setting up the sonic pad I actually deleted and formatted the actual card…

Here you go. I uploaded them to thingiverse www.thingiverse.com/thing:5671208

@@chriss1671 Awesome!! thank you... I'm downloading it now

happy printing!

Youre welcome!!

It must be firmly mounted, it senses vibrations and movement and velcro isn't a solid method of mounting.

Hi! I picked the one that matches my main board. The most certain way to check it, is by opening the bottom cover of your printer and taking a look at the mainboard

Thank you very much!

It should. I think thy have same size👍

Yup, that’s what I have

Yes, it comes with the SP👍

Thanks for your feedback ! Just order mine, but i have a last question 😅 i wanted to known if i have to change my slicer setting (increase print speed, i use Prusa) for print faster, or if the Pad will do it by itself. Thanks ✌️

@@anthonyguenat8174 i would recommend using the profiles made by creality to work with Sonic Pad. You can download them from their website. If you want to continue using prusa, you can just use the creality profiles as a guide to adjust your prusa profiles. So you'll have an idea on how to sey your speed, acce, etc.