Honestly how did you get the center screw out? I'm about to smack somebody

Hey, thank you man, your video helped a lot with my Honda Civic 2006-2011! The 3/8 ratchet was too big, and 1/4 too small, but the PRY BAR DID THE JOB! It was easy on one side, and a bit more difficult on the other caliper, but all in all it saved me $ and time to go to the local stores and look for that specialty tool.

my light bulb broke and theres glass inside so this is no help for me :D

Excellent and informative video, took less than 15 minutes to change ! Thank You

Mine went out, but my check engine light is on cause a catalytic converter they say, but how do I get mine back on?

I recently installed a starter on a 2014 Honda Accord 2.4 L four-cylinder. The car turns on, but it makes a grinding noise. Please comment down below if there’s any solution to this.

which parts did you apply the lithium grease to, it wasnt demonstrated in the video?

My 2016 Honda had 300K, do I need new starter soon?

Can a 168 bulb work for 2013 Honda accord?

Awesome 😎 I was trying to figure out what to do. This was simple and it helped me out. When I bought the car the owner's manual was missing.

Nicely done

Had the same issue the wire was broken in the same location, never would have thought about that area. Thank You for posting the video spliced the wire back together and it’s good to go.

😊

Man, I know this is 8yrs to ago but I wish you could do this for me esp installing the glove box light. I would pay for it of course!

This video totally helped me. Thank you.

Is the bulb 74 for all Honda accord models even sport from 2013-17

How do you do this on a 2016 touring??

Thanks man

Thank you sir. Very good straight to the point video.

thank you bro, I can imagine some people could be driving with this issue for years.

Wherr can I by it

I would consider this more of a diagnosis than repair. Most likely you need a new pigtail.

i would have never guessed, thanks

great video.....would it be same on older 99 hondas...?

Yep, I noticed my 04 has nothing on rear doors , but i bought RGB bulbs, so time to make them work.

Mine just Arrived today!! Gon put em in tomorrow. It's dark outside lol. This video just hyped me Up 😮🎉🎉

Easy tutorial to understanding and straight to the point. After watching this video, I spent less than ten minutes researching and calling around the local,junk yards and was able to locate an armrest lid about 30 minutes away and for $21 including taxes and about a total of 20 minutes of labor invested I replaced my armrest lid and changed the armrest cover right in the junk yard parking lot in a few minutes. Thank you for sharing.

My bolt is just spinning in place , i feel resistance but its not backing out or going in , any advice ?

What sucks is you have to do this every time you start your car

You used a Honda A01 (Filtech) oil filter, those are not common now, hard to find. I recognized the difference in baseplate between it and the very common Fram made A02. Yeah, I wouldn't be very happy finding a screw missing either. Nice job.

I have been using Kirkland synthetic motor oil for over 5y now on all our family cars. So far, so good. I only buy/restock them when they are on sale. As for filter, we use Wix brand from Rockauto.

So on the maintenance minder settings, you can just individually reset each one right? Like for example just resetting "B" only and do the other ones later when you actually perform them.

Kirkland brand oil is from Warren Oil.

Excellent. Used a 6 inch bit extension tool with some 3m double sided tape. Worked like a charm.

Thank you Sir. From Brazil.

It worked on my 2014. Sounded better. Every time I turn the car off it goes back to the original setting. How do I keep this setting?

My armrest broke somehow. Can the armrest be replaced without replacing the whole center console?

Still relevant! 2012 Fit and having the closeups where I could see the direction of the plastic tabs helped. One had fallen off to the ground and it can be a little trick to get it back to where it needs to be. Fortunately, the airflow sensor had enough slack so the filter was accessible. Thanks!

how do you keep it on every time your turn you car

I installed it correctly but my break lights won't work. When I turn my headlights on they work tho

Thanks for the video. Very helpful.

Thank you man!

Someone lmk if they are able to still find this spoiler. Thanks

What the in the what the helllll... Who designed this? Fantastic video thank you very much. I've got three batteries and a hero 3 Plus that were doing nothing and they show voltage they've been sitting on the shelf for a few years. Works great batteries have charge too thank you thank you

What size is the bulb, I want to change mine but I’m having a really hard time taking it out and have the same model ❤

2011 Honda Accord the driver's door light how to fix it need a video

I figured it’d would be this simple haha but I still had to look up a video 💀 was getting kinda worried that the message wasn’t going away after removing the cap and tightening it till the 3 clicks and the cap looked brand new still but I drove about 20 minutes home and turned the car off then back on and the message went away !

THANK YOU!

Your link takes me to ALL of the LED’s on Amazon. Do you have a product number, sku?

without a car lift and a power ratchet, you can forget about DIYing this.