Take off drive shaft. Remove seal. Install seal. Got it.... Terrible video man.
@Jbone182.2 күн бұрын
Did you also have a p0300 code too? Mine just came on today and had both P0339/p0300 I replaced the sensor and reset the codes so far so good
@masonboettcher28004 күн бұрын
Useless
@braxtonjohnston21356 күн бұрын
Is it necessary to fill the speaker box or will it be fine without being filled?
@philippinelife7128 күн бұрын
Torque? Tools used?
@e.gadd.110 күн бұрын
Jeep Liberty 2004 and mine is welded in apparently with rust? Won't come out for anything. The screw unscrews but can do nothing from there :(
@TopNoTchVSOP20 күн бұрын
I know this fix at least two to three years old but is there two of these camshaft sensors on JK/JKU 3.6L ?
@gofasters129 күн бұрын
Great video, Was this on a stock Jeep? I have a 2018 stock Sahara and want to add some quick release sway bar links.
@chrisgamingzone50229 күн бұрын
my 2014 start doing it stalling at 245km when it want thanks for the info time to change it 👍🏻🔥
@lindamcnealy3121Ай бұрын
My 2014 Wrangler JKU Rubicon just threw this code when I started it up last week.... P0335. I only have 58k miles on mine.
@sbond1963Ай бұрын
Wondering if that would be the cause of a P0340 or the p0018 that just happened
@davejones2541Ай бұрын
Will it work with the 5 speed manual transmission?
@thereddragonslair9548Ай бұрын
I got about 169K on my 2013, i’ve never replaced this, but when I’m accelerating, sometimes I feel a little bit of a power drain, but then it kicks back up the further i press the pedal, not all the time though. could this be causing my problem as well?
@jasontaylor9871Ай бұрын
Is this liner a hard plastic or is it rubbery when you touch it?
@JeepLifePodcastАй бұрын
It is a firm rubber material
@jasontaylor9871Ай бұрын
Wonder why they don't offer rear side panels for the LJ Kind of an incomplete package without them?
@JeepLifePodcastАй бұрын
They are currently working on them, Armorlite has been hard at work developing a lot of applications at once. They offer the rear wheel wells for the normal TJ.
@MichaeljanTabadero-rs2hnАй бұрын
not a smart tool
@davidkeeton67162 ай бұрын
So, did you have to lift the lock tab on the connector or squeeze it? This is a great video! Thanks for getting in there with the camera.
@gamersgrubs29522 ай бұрын
There was a KK there last year also. We're going again this year
@israelcontracting40592 ай бұрын
You didn’t show how it came out. This video is useless.
@TheTurnback2 ай бұрын
My 2014 JKU had the idle just drop to zero while driving on the highway. Still had power but nothing even when downshifting (6 speed manual). I was able to just turn it off and back on and had normal idle again. I’ve had CEL on for wheel sensor and crankshaft position (PO018) that comes on randomly. I’ll see how it drives tonight when I get out of work. Hoping the fix suggested in this video might solve it if it happens again.
@jeffreyned2 ай бұрын
Thanks man. This happened to me this morning. Once I had the part I was back on the road in less than 10 minutes.
@JeepLifePodcast2 ай бұрын
Glad it helped
@samueliglesias95302 ай бұрын
You’re using that jeep I see mud
@JeepLifePodcast2 ай бұрын
heck yeah, we always use our Jeeps for what they are meant for!!!!
@DaddyJeepGarage2 ай бұрын
Looks good Billy 🤘
@JeepLifePodcast2 ай бұрын
Thank you, it was a bit of a job.
@coldcaseradiators2 ай бұрын
🥶 Nice Work! 💪💪💪
@JeepLifePodcast2 ай бұрын
Thanks 🔥
@Noscams002 ай бұрын
These things make a huge difference! 👍
@JeepLifePodcast2 ай бұрын
Couldn't agree more
@jeepdoctv2 ай бұрын
Man that’s gotta stop all that feet roasting heat!! Awesome video man!!
@JeepLifePodcast2 ай бұрын
Tell me about it, it really does
@marksween7612 ай бұрын
So, how is it?
@JeepLifePodcast2 ай бұрын
Night and day difference, heat reduction, sound deadening and so easy to clean out!!
@marksween7612 ай бұрын
@@JeepLifePodcast I think I'm going to order the full set. Is that code good for a while?
@JeepLifePodcast2 ай бұрын
@@marksween761 yes, it has been active for the past two years. "jeeplifepodcast10"
@sachmo19183 ай бұрын
Great video. Our 2012 lost power and was throwing up codes like gang signs
@JeepLifePodcast2 ай бұрын
Sorry to hear that, thank you
@sachmo19183 ай бұрын
Great video. Our 2012 lost power and was throwing up codes like gang signs
@JeepLifePodcast2 ай бұрын
Oh no!
@Wandering_Buffalo_Adventures3 ай бұрын
Thanks for this!! My JKU is a 2013 and it just went out at 83k miles. Thanks for the clear and simple video. Happy Trails!!
@JeepLifePodcast2 ай бұрын
Thanks, you too!
@LostThymeOverlandAdventures3 ай бұрын
Should you disconnect the battery first?
@JeepLifePodcast2 ай бұрын
yes, you should, it will give the vehicle a complete reset.
@WilliamGerringer-vc2ld3 ай бұрын
I call mine B.O.B. ( Betty Of Bolts )...Got duck #5 good to report. Looking forward to my N3 suspension upgrade. Safe Travels & Trails.
@WilliamGerringer-vc2ld3 ай бұрын
Say Jeep Life Podcast I enjoy your shows for sure. New to Jeeps. Wanted to share Jeep Wrangler Team wheeling in Japan I think. You may or may not have seen it here on the tube. Just wanted to share seeing other Jeeps in other countries. Safe wheeling.
@WilliamGerringer-vc2ld3 ай бұрын
Any advice for the Deathwobble in my 2012 Jeep Wrangler?? I'm new to Jeeps 3 year owner & only 1 trail. Learning. Thanks.
@WilliamGerringer-vc2ld3 ай бұрын
Listening to The Jeep Life Podcast for the first time. New to Jeeps (Virginia). 🚙. Thanks for sharing your thoughts!!
@SuperDj20003 ай бұрын
I just replace mine today. Thank you very much!
@cdubs99183 ай бұрын
One of the most cursed phrases you'll ever hear while working on your Jeep is..."It or they should come off real easy"! This refers to screws,doors,hinges,soft tops,hard tops,bolts,bushings...etc,etc...!
@Rubicon143 ай бұрын
I just replaced mine with plastic bushings today hopefully this will solve the door seizing bullshit that the wranglers are known for 😡
@timflaherty27314 ай бұрын
What's with the yelling, used-car salesman voice that every youtuber uses?
@BustedBeaters4 ай бұрын
Not too shabby! Putting that new welder to use!
@JeepLifePodcast2 ай бұрын
Thank you
@mateofreyo15534 ай бұрын
Nice! What's our first bending project going to be??
@JeepLifePodcast2 ай бұрын
Going to be working on the Reaper the Buggy over this next off season.
@scottalleman47194 ай бұрын
Nice job!
@JeepLifePodcast2 ай бұрын
Thank you!!!!
@jeffkohler215 ай бұрын
Wish i could get one but they dont ship to Alaska 😢 they look like great machines.
@mateofreyo15535 ай бұрын
…I always eat the silica gel
@BustedBeaters5 ай бұрын
New shop toys are always the best! Can't wait to see what you make with it!
@peterhinton6 ай бұрын
How has it all held up? I was thinking of installing one but worried it'll get fried too easily
@jlautomotive63496 ай бұрын
Love the show and this high clearance exhaust but the sound was a disappointment… maybe it will sound better once it gets some miles on it?? I listen to your show on Apple Podcasts and is my favorite Jeep podcast!! 👍
@JeepLifePodcast5 ай бұрын
So unfortunately, during the process of installing the exhaust we actually discovered a cracked manifold on the driver side that was affecting the sound. Also it is really hard to capture good exhaust sound on crappy iphone mic.
@anaslp5256 ай бұрын
Hi When climbing hills, the RBM level decreases by itself.I'm having a problem with my Jeep Wrangler.
@GooeyFrog7 ай бұрын
What size are the nuts? 18mm?
@esurles17 ай бұрын
Are they supposed to slide out with the door because mine won't stay in the hinges