3 ай бұрын
3 ай бұрын
4 ай бұрын
6 ай бұрын
7 ай бұрын
Жыл бұрын
2 жыл бұрын
2 жыл бұрын
2 жыл бұрын
2 жыл бұрын
2 жыл бұрын
2 жыл бұрын
2 жыл бұрын
Пікірлер
@melostreetvybztv6328 4 сағат бұрын
You’re not tied to the rub rails correctly, you’re going to rip your stake pocket.
@SuperHddeuce 6 күн бұрын
Just picked up a 2000 Blazer 4x4 four button 4x4 switch with Auto and mine doesn't work I see the vacuum line on mine that goes to nowhere and it has a bolt plugged in it. But it don't see anything in the inside of the fender. Nevermind I found the nipple I'm an idiot😅 hand to big to get to it 😂😂 Thanks for the video
@pjheloguy 10 күн бұрын
Agreed! An old, proven design.
@100rubenaragones 13 күн бұрын
Great video helped me a lot.
@k30krazy 12 күн бұрын
Glad to hear it!
@timmackey8133 18 күн бұрын
Brah 1st Thang 2 do is clean Dat motor off, eres dirt n shit all over
@SteveM-q1m 23 күн бұрын
Is 3614 filter causing any issues with the engine
@SteveM-q1m 23 күн бұрын
Have you had any issues with the s3614 oil filter
@k30krazy 23 күн бұрын
Not a single issue. Has been just fine
@RichSchafer-q8b 23 күн бұрын
They will also work on briggs and kawasake too ph3614
@nobiden3134 27 күн бұрын
3:01 thats a 351M. 400 has a 1" X 1/2 X 2" SQUARE BEAM next to the distributor.
@pistolpaulie4871 27 күн бұрын
That does not work!
@k30krazy 26 күн бұрын
Has worked for myself and others many times. Not going to work every time in every situation though I'll give you that.
@ClarenceUlery 29 күн бұрын
verry good job,,,, it is just what i needed to know
@buckwelsh2608 Ай бұрын
What size is the vacuum line
@k30krazy Ай бұрын
I don't remember I'm sorry. That was a few years ago and I don't have it anymore.
@davidhayes5195 Ай бұрын
I use my Klein flush cuts because Milwaukee doesn't make a pair yet.
@k30krazy Ай бұрын
You'd think Milwaukee would have em by now lol
@ZIZZERFLAG Ай бұрын
I use my linesman’s and give it the twist until it breaks off. No sharp edges
@k30krazy Ай бұрын
I'll have to give that a shot
@jamesolsen9599 Ай бұрын
I have a 14,800lb equipment I need to secure 4 corners I was thinking 4 grade 70 3/8 chain will 6600 and 4 ratchet chain binders will 7100lb am I good I'm not holding you to anything just asking
@inyobase127 Ай бұрын
Came in clutch 4 ars later, thank you for uploading this
@k30krazy Ай бұрын
No problem, glad it helped!
@chakrathong2090 Ай бұрын
when you do like that can be vacuum sand on land?
@coinfisher9263 Ай бұрын
Thanks for the vodeo, will gove it a shot on friday.
@tomdavis7112 Ай бұрын
Thanks so much! You’re a great detective.
@AlbertoTorres-k1e Ай бұрын
For wat it s that for l have a s10 2000 an it s ben eating alot of gas you tink they fixmy peoblem it s ben true 5 mecanic s can t fund the problem
@heatherotterstrom2815 Ай бұрын
So now that the mystery hose problem is solved!! Someone tried to solve it yesterday and messed up my car.. if I show you some pictures can you send some advice please??
@heatherotterstrom2815 Ай бұрын
So now that the mystery hose problem is solved!! Someone tried to solve it yesterday and messed up my car.. is there a way to send a picture ? Maybe you could give me your advice 👍
@heatherotterstrom2815 Ай бұрын
I have been wondering about that vacuumed hose for a couple yrs!! Mystery solved thankyou!!!
@ilovemesome_tendies9096 Ай бұрын
I have to get out the exhaust manifold on my lexus rx300. I'm really not looking forward to it...
@David-ii5td Ай бұрын
W😂hat happened to your 😂t😂h😂u😂m😂b
Ай бұрын
Sorry Guys. . . The 351 Modified was built at WEP#2 (Windsor Engine Plant). The 351W at WEP#1. Summer of 1977. When I started working for Ford. Piston & Rod assembly/Piston House in WEP#2. The Windsor Casting Plant (WCP) was next door. The cranks were cast there.
@glennhutson2015 Ай бұрын
Thanks
@NightWolf-vv5me 2 ай бұрын
You didnt show how to put the twist at all. Nobody on YT has. The search continues
@k30krazy 2 ай бұрын
Half flip each side
@welderboy525 2 ай бұрын
Cross your chains so in a failure the trailer tows straight and doesn’t veer into other lanes
@eliamaneyesongsymbaleli1878 2 ай бұрын
Great research dude keep up the good work and yes thats a hidden hard to locate vac hose port COMENT From (Eliama&i Songs on youtube) One Blood One Vine, Love is Much more, Sound of Sadness, Dudo Gulpe ! Share and coment !
@fxnytro141 2 ай бұрын
unlock, hold unluck
@2ndstreetmarvel 2 ай бұрын
I’m trying to find where the hose that Ts off the check valve goes to. I have the one going into the sidewall, just not the one that goes down to I don’t know where. It’s the hose right next to the one that you just hooked up.
@jd_tokesmokekill3887 2 ай бұрын
when i do this it just losens the nut on tensioner. 07 jeep liberty
@Howler1974 3 ай бұрын
Ty sir
@dannymartin5518 3 ай бұрын
Get a bungee cord rope wire or whatever Google AC tubes back take it out and put it in
@Jenkinsfamily0812 3 ай бұрын
What would cause a blazer lose charge ?
@k30krazy 3 ай бұрын
As in battery die?
@adamdouglas8243 3 ай бұрын
Dude you are genius
@centermass4962 4 ай бұрын
Will that make it hard to start sometimes
@k30krazy 3 ай бұрын
Any vacuum leak could at times so yes. I didn't that I remember with that one. I had the main lime that goes to come off the intake and I did yes
@centermass4962 3 ай бұрын
@@k30krazy ok. It's just weird cause mine only does it sometimes. But it's kicking the evap code.
@k30krazy 3 ай бұрын
What's the code?
@centermass4962 3 ай бұрын
@@k30krazy p446 or something like that
@k30krazy 3 ай бұрын
Evap problem sounds like
@brandonbrown2202 4 ай бұрын
I gotta take off the tensioner also but damn you saved me a headache
@k30krazy 4 ай бұрын
Glad it helped!
@paulshamblin6260 4 ай бұрын
Electrical tape is essential for field first aid.
@k30krazy 4 ай бұрын
Facts!!
@ThePatriotPirate 4 ай бұрын
Appreciating the video but since I have to go buy the “clips” I need the technical term for them. Clips doesn’t cut it when you go in asking for them
@k30krazy 4 ай бұрын
Hitch pins, hair pins, hitch clips... they're called a number of things
@coleman6131 4 ай бұрын
34 second intro? Fuck off!
@beasyphone 4 ай бұрын
The 98+ vacuum can in thd fenders ONLY job is to provide backup vacuum under HEAVY ACCELERATION to the HVAC. It literally had ZERO to do with your 4x4. I'm on truck #7 over the past 30+ years and I know them well enough to 100% believe that your 4wd started miraculously working better after randomly jostling the lines around lol. But the facts in this case is you solved a weakened HVAC control actuators mainly blendoor functionality. But with an S-Series?? Tire pressure low and your passenger window gets stuck lol. These are finicky animals for sure! Glad you got your 4x4 going again- that's the only thing that matters. Just don't want some 20 something kid seeing this and believe it's going to solve his shorted out TC motor. It's an hvac line, that's it
@k30krazy 4 ай бұрын
First off if someone is stupid enough to believe fixing a vacuum leak is going to an electrical problem that's not my problem. Second all I said was that the line was disconnected. I had no 4x4 because the axle actuator wasn't getting enough vacuum because of a leak. I plugged the leak and it worked fine. All this video states is I found out about the fender mounted vacuum canister and that's where that short line went. That did intact fix the hvac problems under acceleration like you mentioned. There's more than one issue I talked about here. Never said that the canister fixed the 4x4 problem
@steveelgersma3589 4 ай бұрын
Isn't this a safety cable/Kill cable rather than a throttle cable?
@steveelgersma3589 4 ай бұрын
Good video though. Easy Smeazy.
@k30krazy 4 ай бұрын
Both I guess
@morales1ist 4 ай бұрын
Thanks 🎉
@AROD500500 4 ай бұрын
Hey K30Krazy, Great Video.. I had the same issue and took care of that. I don't know where these lines are hooked up to. I still have the same 3 way plastic tee line that you have with the green marks on it going down the driver's side and the line that disappears towards the engine block. I'm still hearing a hissing sound on the open t line nipple. Thanks if you can help out. I just replaced distributor cap and rotor this morning..! Thanks
@k30krazy 4 ай бұрын
Thanks! So those lines on the other 2 ports go to the hvac and the intake. The one going towards the firewall to a hard line us for hvac. The one going towards the engine goes to the intake for your vacuum source.
@AROD500500 4 ай бұрын
Thanks for the feedback, I'll check it out today.. we have these severe thunderstorm warnings here in Central Florida. I'll let you know on I did. Thanks,
@RJ-ud1pr 4 ай бұрын
Nicely done. Thanks!
@coreythedford5903 4 ай бұрын
What year model was this? I have a 2013 Tahoe with some slop
@k30krazy 4 ай бұрын
2004. I'd check the rest of your steering before jumping to this.
@catman256able 5 ай бұрын
I like the way you said that at least it worked on the other side. 👍🙏✌️🎏🤠
@dinonaccarato2989 5 ай бұрын
Thx for the video , I’m hoping that’s my issue on my 5.7l