Next time don’t record your arm…..

You cut your plastic 😅good video 😂

I don’t know Wich clutch to but because l can’t find the code or name of the clutch can anyone help ? Please 😊

Shoulder screws in your arm cuz that's all that I could see at that moment when you were explaining that we got a good shot of your tattoo

My 90cc fully auto loncin engine won’t release the clutch for the back wheel to spin freely when engine is off but if I start the bike hold brakes (as back wheel wants to spin ) for a minute or so it seems to release the clutch a lot more but not enough to stop the back wheel from tugging the bike forward if that makes sense …? New oil brakes not binding also think it’s clutch?

1:58 what’s that arm called

Wire brush

Too painfull to whatch. Not sure how anyone would not know where clutch is or why it would be near the chain.

Dude, 4 bolts to remove that front rack and you decided to cut through it instead?

Hey man my back tires are locked up because I towed it help me fix it thanks

Great video - Thank You ! Does anyone know how i could attempt to fix/rebuild the clutch (vs replace) ? Also, on my 2nd ATV, what could I do preventative care or maintenance to make it last longer ?

Good video..thanks bro.helped me alot.

I would turn that tie rod castle nut over and run it back on a few turns before hitting the bolt with a hammer. Will save you threads and bending of that bolt, as the lock pin holes weaken it. Or, for like $10 get a tie rod separator.

Hey Jesus. I really appreciate the video. We have purchased the tool that you use in minute 4:18 of the video, but we cannot get the clutch to stop spinning when we attempt to use it. How did you get the clutch to stand still so you could apply the tool?

Thanks helped a lot. This top bolt is a pain. I have the frame like yours and I'm trying to avoid cutting a hole in it, but it's really in there

And what's the name of that tool for $20

Did u prop the ATV up with the oil pan on the bottom to catch the oil right just looking at it.

Thank you Jesus, removing the control arm helped me get this job done.

Thanks a ton for the video. I'm having a similar issue with a new motor due to lack of info in the supplied manual. Turns out you have to use oil designed for a wet clutch. Go figure right? Anyway, I just ordered the tool online www.amazon.com/dp/B00G5OQRXO/ref=cm_sw_em_r_mt_dp_U_ubOSCbH7M25KB When I purchased, it was only $5.99 so I hope this helps.

How do i change the clutch on a 50 cc bmx atv

Thanks for this, I have to do the same thing on a 1992 Trail Boss. It is similar to yours, this video will help!

Would I need a clutch kit for an automatic bike

you need the clutch removal socket. it will pop that nut right out

What's that piece call again I been looking for it

I can't take off that nut That holds the clutch

Hey... Thanks for the video. I'm having the same issue. Runs and revs, but won't move under load. So, did you have to replace the clutch or were you able to just repair it and put it back in?