Yes, of course you can

thank you

Automation studio

It all depends on the job to done, and to understand the way you want your machine to handle it. You can easily change the process and add or remove some features.

Hello! You can find it from torrent sources

You may find different ways of automating your pneumatic metal sheet cutting machine. First of all, you need to Identify number of Cylinders, type of directional Control valves, and the target or sequence to be done to complete one cycle.

Automation studio 5

Thank you Brother

Thank you

Thank you!

Asante sana! then share with your friends

Thanks

Thank you

Go directly to this link, kzbin.info

@@OlivierNkubito , I have seen all . thank you . we need that software for well understanding , Lecturer

@@bwimbamitali2726 We shall handle that

Can you give more details please

The fact that, the relay has more contacts (NO and NC) some of them can be used to hold or to maintain the electrical circuit in Closed status even if the Normal open switch is released. Read more about direct and indirect control system.

I need more information, like sequence

Dou you want your hydraulic cylinder to be fully extended and remains extended for 3 seconds and then retracts itself? If Yes you need a timer.

The details are as follows: When push button 1 is pressed (PB1) and push-button 2 is pressed then Cylinder A will extend. When a limit switch senses that A has fully extended (LS1) then B will extend. When Push Button 3 is pressed (PB3) or Push Button 4 is pressed (PB4) then Cylinder A will retract - this will cause B to automatically retract at the same time. ***Using a flow control to control the speed of the B cylinder extending, it should extend at approximately half the speed that it retracts. • Cylinder A is a single-acting cylinder, controlled by a Double acting pilot control valve. • Cylinder B is a Double-acting cylinder, controlled by a Single-acting pilot control valve. • Using appropriate valves, pushbuttons, limit switches, etc. It would be a great help if you could shed some light on this. :) Thank you

Thanks @Sahib Bhardwaj! I will do it sooner.

Yeah, both counters' values need to be changed, and that's what I did.

@@OlivierNkubito however during simulation should he accumulated value change also? when using Siemens or while using Allen Bradley in Studio 5000 the Up down counter will sync after naming the counters the same. I think it is a glitch with Automation Studio

Thanks! Find me on social media so we can Talk about it!

From there we can talk through email or phone

@@OlivierNkubito thx for u're kindness! Here's my email address: [email protected] Let me know if u get it. Thx