Ай бұрын
4 ай бұрын
5 ай бұрын
5 ай бұрын
6 ай бұрын
6 ай бұрын
Пікірлер
@eloymarquez4783 Ай бұрын
Yesterday I learned about these tools by an application engineer from another brand, I hope to use it soon! Thank you for sharing Sugino. GREAT MUSIC
@tetzelfigueroa8691 Ай бұрын
How to set the turret?
@agg42 Ай бұрын
Music is great. Keep it up Sugino
@ahmeddesoky3599 Ай бұрын
WOW!! I wonder what is the difference between in the dispersion technique between this machine and ultrasonication and magnetic stirring !
@nickylarsen6207 Ай бұрын
great video and tool, but the music is a joke, we're not in 1996 anymore !🤣
@konstantinNeo 6 ай бұрын
For the 1/8 - 1/4 diameter range, what are the tool cost?
@nightster1501 Жыл бұрын
Where would you inquire about this too?
@timskeens6523 2 жыл бұрын
This is an aspect of burnishing that is largely not thought about.
@jaxnaturals 2 жыл бұрын
Did you see any delamination between layers on the carbon fiber from this process? How wAs the cut edge? Were you predrilling the pierce?
@williamhuang5329 2 жыл бұрын
Hanzhen harmonic drive gear , strain wave reducer, robot gear , over 30 years experience
@SenBolemSpeed 2 жыл бұрын
How much does this cost?
@t_c5266 3 жыл бұрын
need a lead in and a lead out already drilled. This is a perfect way to delaminate your carbon fiber
@Dannerrrr 2 жыл бұрын
but apparently it worked?
@t_c5266 2 жыл бұрын
@@Dannerrrr they didnt show enough to determine that. theres probably delam on the underside and its not shown
@Dannerrrr 2 жыл бұрын
@@t_c5266 i've seen cheap sheets delam, and other sheets not. I've seen people add a piece of acrylic to the back of the part so it doesn't blow out too, if they had problems. get enough garnet at the beginning of your pierce through and you'll be fine.
@LapXuanBuivesinhcongnghiep 3 жыл бұрын
Howmany pressure ? Sugino